Black Box LB9017A-R2 Bedienungsanleitung

Installation

InstallationInstallation

Installation

This installation guide gives step-by-step instructions about how to install the Express Plus Ethernet Switches:

LB9017A-R2

Selecting a Site for the Express Plus Ethernet Switch: LB9017A-R2

As with any electric device, you should place the switch where it will not be subjected to extreme temperatures, humidity,

or electromagnetic interference. Specifically, the site you select should meet the following requirements:

- The ambient temperature should be between 32 and 104 degrees Fahrenheit (0 to 40 degrees Celsius).

- The relative humidity should be less than 90 percent, non-condensing.

- Surrounding electrical devices should not exceed the electromagnetic field (RFC) standards for IEC

801-3, Level 2 (3V/M) field strength.

- Make sure that the switch receives adequate ventilation. Do not block the ventilation holes on each side of

the switch or the fan exhaust port on the rear of the switch.

- The power outlet should be within 1.8 meters of the switch.

Connecting to Power

Internal power:

Step 1: Connect the supplied AC power cord to the receptacle on the back of the switch, and then plug it into a standard AC outlet with a

voltage range from 100 to 260 Vac.

Step 2: Turn on the switch by flipping the ON/OFF switch on the rear of the unit to I (ON) position.

Step 3: The Oposition is OFF.

Figure 1: Rear view

CUSTOMER

SUPPORT

INFORMATION

Order toll-free in the U.S. 24 hours, 7 A.M. Monday to midnight Friday: 877-877-BBOX

FREE technical support, 24 hours a day, 7 days a week: Call 724-746-5500 or fax 724-

746-0746

Mail order: Black Box Corporation, 1000 Park Drive, Lawrence, PA 15055-1018

Web site: www.blackbox.com • E-mail: [email protected]

Connecting to Your Network

Cable Type & Length

It is necessary to follow the cable specifications below when connecting the switch to your network. Use

appropriate cables that meet your speed and cabling requirements.

Table 3: Cable Specifications

Speed Connector

Port

Speed

Half/Full

Duplex

Cable Max.

Distance

10BASE-T RJ-45 10/20

Mbps 2-pair UTP/STP

Cat. 3, 4, 5 100 m

100BASE-TX RJ-45 100/200

Mbps 2-pair UTP/STP

Cat. 5 100 m

100BASE-FX ST, SC, MT-RJ,

VF-45 100/200

Mbps MMF (50 or

62.5µm) 2 km

100BASE-FX SC 100/200

Mbps SMF (9 or

10µm) 15, 40, or

75 km

Cabling

Step 1: First, ensure the power of the switch and end devices is turned off.

<Note> Always ensure that the power is off before any installation.

Step 2: Prepare cable with corresponding connectors for each type of port in use.

<Note> To connect two regular RJ-45 ports between switches or hubs, you need a cross-over cable.

Step 3: Consult Cable Specifications Table on previous page for cabling requirements based on connectors and speed.

Step 4: Connect one end of the cable to the switch and the other end to a desired device.

Step 5: Once the connections between two end devices are made successfully, turn on the power and the switch is operational.

CUSTOMER

SUPPORT

INFORMATION

Order toll-free in the U.S. 24 hours, 7 A.M. Monday to midnight Friday: 877-877-BBOX

FREE technical support, 24 hours a day, 7 days a week: Call 724-746-5500 or fax 724-

746-0746

Mail order: Black Box Corporation, 1000 Park Drive, Lawrence, PA 15055-1018

Web site: www.blackbox.com • E-mail: [email protected]

Andere Handbücher für LB9017A-R2

Inhaltsverzeichnis

Andere Black Box Schalten Handbücher

Black Box

Black Box SS8P-SH-DVI-U Bedienungsanleitung

Black Box

Black Box Wizard IP Plus ServSwitchTM Bedienungsanleitung

Black Box

Black Box SW1007A Bedienungsanleitung

Black Box

Black Box MT760A-232/232 Bedienungsanleitung

Black Box

Black Box LGB2118A Bedienungsanleitung

Black Box

Black Box AVSW-HDMI2X1A Bedienungsanleitung

Black Box

Black Box KVMC4K-2P Bedienungsanleitung

Black Box

Black Box 12 VDC load Bedienungsanleitung

Black Box

Black Box LBH2001A-H Bedienungsanleitung

Black Box

Black Box LBH100A-PD-ST-24 Bedienungsanleitung

Black Box

Black Box ServSwitch KV0004A Bedienungsanleitung

Black Box

Black Box AC815A Bedienungsanleitung

Black Box

Black Box KV9104A Bedienungsanleitung

Black Box

Black Box EMS10G-28 Handbuch

Black Box

Black Box SWI069A Bedienungsanleitung

Black Box

Black Box LPD100A Bedienungsanleitung

Black Box

Black Box AVSW-VGA4X1A Bedienungsanleitung

Black Box

Black Box KV7004A Bedienungsanleitung

Black Box

Black Box PI9120A Bedienungsanleitung

Black Box

Black Box SS1P-SH-DVI-UCAC Bedienungsanleitung

Black Box

Black Box LGB5028A-R2 Bedienungsanleitung

Black Box

Black Box KVS4-1002D Bedienungsanleitung

Black Box

Black Box ServSwitch SW627A-R2 Bedienungsanleitung

Black Box

Black Box ACL0802A Bedienungsanleitung

Beliebte Schalten Handbücher anderer Marken

URC

URC Total Control MFS-8 Bedienungsanleitung

Azbil

Azbil HPQ-D11 Bedienungsanleitung

Sony

Sony DFS-900M Bedienungsanleitung

SICK

SICK i17S Bedienungsanleitung

F&F

F&F SZR-277 Bedienungsanleitung

Shure

Shure UAMS/BK Bedienungsanleitung

Dräger

Dräger X-zone Switch Off Bedienungsanleitung

Asco

Asco Joucomatic 349 Series Bedienungsanleitung

BT Mini Hub Bedienungsanleitung

D-Link

D-Link DES-1226G Bedienungsanleitung

Johnson Controls

Johnson Controls FS80-C Bedienungsanleitung

MicroNet

MicroNet SP1200A Bedienungsanleitung

Ruijie

Ruijie RG-PF2920 Series Installations- und Betriebsanleitung

Altinex

Altinex DA1914SX Bedienungsanleitung

RJM

RJM MASTERMIND PBC/6X Bedienungsanleitung

Atlas

Atlas MMK-KVM8 Bedienungsanleitung

Cabletron Systems

Cabletron Systems GIGAswitch GSR-16 Bedienungsanleitung

Cisco

Cisco Catalyst X4448 Handbuch