Black Box LB9019A-R3 Bedienungsanleitung

Installation

This installation guide gives step-by-step instructions about how to install the Express Ethernet Switches:

LB9019A-R3

Selecting a Site for the Express Ethernet Switch: LB9019A-R3

As with any electric device, you should place the switch where it will not be subjected to extreme temperatures,

humidity, or electromagnetic interference. Specifically, the site you select should meet the following requirements:

- The ambient temperature should be between 32 and 104 degrees Fahrenheit (0 to 40 degrees Celsius).

- The relative humidity should be less than 90 percent, non-condensing.

- Surrounding electrical devices should not exceed the electromagnetic field (RFC) standards for IEC 801-3,

Level 2 (3V/M) field strength.

- Make sure that the switch receives adequate ventilation. Do not block the ventilation holes on each side of the

switch or the fan exhaust port on the rear of the switch.

- The power outlet should be within 1.8 meters of the switch.

Connecting to Power

yConnect the supplied AC power cord to the receptacle on the back of the switch, and then plug it into

a standard AC outlet with a voltage range from 100 to 240 Vac.

Figure: Rear view of the switch

Connecting to Your Network

Cabling

yFirst, ensure the power of the switch and end devices are turned off.

<NOTE> Always ensure that the power is off before any installation.

yPrepare cable with corresponding connectors for each type of port in use.

yConsult Table 2 below for cabling requirements based on connectors and speed.

yConnect one end of the cable to the switch and the other end to a desired PC or workstation.

yOnce the connections between two end devices are made successfully, turn on the power and the

switch is operational.

Rece

tacle

Cable Length

The maximum distance of a node to a directly connected switch on a 100BASE-TX network is 100 meters with

Category 5 shielded twisted-pair (STP) cable or unshielded twisted-pair (UTP) cable. For a 10BASE-T network, it

may range up to 100 meters with Category 3, 4, or 5 STP/UTP cable.

The maximum segment distance between a node and a directly connected switch port on a 100BASE-FX network is

75 km using 10/125(or 9/125)µm single-mode fiber optic cable. It is capable of spanning at most 2 kilometers when

use of 62.5/125(or 50/125)µm multi-mode fiber-optic cable.

Table: Cable Specifications

Ethernet

Standards

Connector Port

Speed

Half/Full

Duplex

Cable Max.

Distance

10BASE-T RJ-45 10/20

Mbps

Cat. 3, 4 or 5

UTP/STP

100 m

100BASE-TX RJ-45 100/200

Mbps

Cat. 5

UTP/STP

100 m

CUSTOMER Order toll-free in the U.S. 24 hours, 7 A.M. Monday to midnight Friday: 877-877-BBOX

SUPPORT FREE technical support, 24 hours a day, 7 days a week: Call 724-746-5500 or fax 724-746-0746

INFORMATION Mail order: Black Box Corporation, 1000 Park Drive, Lawrence, PA 15055-1018

Web Site: www.blackbox.com yE-mail: [email protected]

Andere Handbücher für LB9019A-R3

Inhaltsverzeichnis

Andere Black Box Schalten Handbücher

Black Box

Black Box ServSwitch 17S Bedienungsanleitung

Black Box

Black Box SW595A Bedienungsanleitung

Black Box

Black Box VGA to Video Portable Plus Stücklistenhandbuch

Black Box

Black Box KV5300 Series Bedienungsanleitung

Black Box

Black Box LPBG716A Bedienungsanleitung

Black Box

Black Box KVS4-4004DHVX Bedienungsanleitung

Black Box

Black Box DCX3000 Bedienungsanleitung

Black Box

Black Box SW925A Bedienungsanleitung

Black Box

Black Box PSE544 Bedienungsanleitung

Black Box

Black Box ServSwitch 4site II Bedienungsanleitung

Black Box

Black Box AC1032A-2 Bedienungsanleitung

Black Box

Black Box VSW-DVI3X1 Bedienungsanleitung

Black Box

Black Box SERVSWITCH Series Montage- und Wartungsanleitung

Black Box

Black Box ServSwitch Bedienungsanleitung

Black Box

Black Box ServSelect KV124A-PS2 Bedienungsanleitung

Black Box

Black Box MT760A-232/232 Bedienungsanleitung

Black Box

Black Box SS2P-SH-HDMI-U Bedienungsanleitung

Black Box

Black Box LGB408A Gebrauchsanweisung

Black Box

Black Box ServSwitch Jr. SW621A-R2 Bedienungsanleitung

Black Box

Black Box LinkUp 5294 Bedienungsanleitung

Black Box

Black Box KV6222A-R2 Bedienungsanleitung

Black Box

Black Box LPB5028A Bedienungsanleitung

Black Box

Black Box DISPLAYPORT KV4402A Bedienungsanleitung

Black Box

Black Box SS1P-SH-DVI-UCAC Bedienungsanleitung

Beliebte Schalten Handbücher anderer Marken

URC

URC Total Control MFS-8 Bedienungsanleitung

Azbil

Azbil HPQ-D11 Bedienungsanleitung

Sony

Sony DFS-900M Bedienungsanleitung

SICK

SICK i17S Bedienungsanleitung

F&F

F&F SZR-277 Bedienungsanleitung

Shure

Shure UAMS/BK Bedienungsanleitung

Dräger

Dräger X-zone Switch Off Bedienungsanleitung

Asco

Asco Joucomatic 349 Series Bedienungsanleitung

BT Mini Hub Bedienungsanleitung

D-Link

D-Link DES-1226G Bedienungsanleitung

Johnson Controls

Johnson Controls FS80-C Bedienungsanleitung

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Bedienungsanleitung

MicroNet

MicroNet SP1200A Bedienungsanleitung

Ruijie

Ruijie RG-PF2920 Series Installations- und Betriebsanleitung

Altinex

Altinex DA1914SX Bedienungsanleitung

MiLAN

MiLAN MIL-SM2401M Bedienungsanleitung

RJM

RJM MASTERMIND PBC/6X Bedienungsanleitung

Atlas

Atlas MMK-KVM8 Bedienungsanleitung