180-Z2091_Z2093 v1.03 October 17, 2018
S.Z2091 Medium Shroud AF25 29 1/4” or S.Z2093 Large Shroud AF25 32 1/4”
3. Partially thread thirteen
10-24x1/4” machine screws
with washers into the top,
left, and right cast trim
pieces. Leave at least a
1/16” gap between the
washers and the cast face.
(FIG.3) NOTE: Leave one
hole open on either the left
or right side for the bypass
handle hanger bracket.
4. Slide the cast trim pieces
into their respective
positions by aligning
the partially fastened
screws with the u-shaped
cut-outs on the shroud
panels. Completely tighten
machine screws once the
trim is in place.
5. Align the left and right cast
corners into their respective
positions and fasten to the
upper shroud panel using
four 10-24x1/2” machine
screws with washers.
(FIG.4)
6. Attach the bypass handle
hanger to the open hole
left from step 3, use the
remaining 10-24x1/4”
machine screw to fasten in
place. (FIG.4)
FIG.3
FIG.4
OPEN HOLE FOR BYPASS
HANDLE BRACKET
