04
The work light comes complete with a charging base, charging wire, and plug as well as a travel adapter.
Ensure the work light is fully charged before initial use.
Operation
1. Connect the charging lead to the charging base.
2. Fit the work light securely into the charging base.
3. Plug into the power supply and turn on. A red light will appear on the back of the work light to show
it is charging.
4. When the work light is fully charged the indicator light will turn green.
5. Turn off the power supply and remove the work light from the charging base.
Charging the work light with the charging base
1. Connect the charging lead to the travel adapter.
2. Plug the charging lead into the back of the work light.
3. Plug the travel adaptor into the power supply and turn on. A red light will appear on the back of
the work light to show it is charging.
4. When the work light is fully charged the indicator light will turn green.
5. Turn off the power supply and remove the charging lead from the back of the work light.
Charging the work light with the travel adapter
When the work light has been charged using either method above, please follow the steps below for
operating the work light.
1. Switch the light on using the power button on the front of the light.
2. For hands free use the light may be suspended by the hanging hook or attached to a magnetic
surface by the magnet on the bottom or back of the work light.
NEVER point the light in yours or somebody else’s eyes as this could cause damage to the eyes.
Operating the work light
ALWAYS ensure the work light is turned off and is not connected to the power supply when you are
cleaning or performing maintenance.
Clean the torch by wiping with a damp cloth.
NEVER use solvents or abrasives to clean the work light.
Cleaning & Maintenance
