P/N 033000=13891 9 Rev.15-05-06
[17] REW (rewind)
In VCR, DVD or CD mode: This button works the same way
as in your original remote.
IN TV mode: Coloured key (Red), control of videotext or
special equipment functions.
[18] FF (fast forward)
In VCR, DVD or CD mode: This button works the same way
as in your original remote.
IN TV mode: Coloured key (Blue), control of fasttext or
special equipment functions.
[19] PLAY
In VCR, DVD or CD mode: This button works the same way
as in your original remote.
IN TV mode: Coloured key (Yellow), control of fasttext or
special equipment functions.
[20] STOP
In VCR, DVD or CD mode: This button works the same way
as in your original remote.
IN TV mode: Coloured key (Green), control of fasttext or
special equipment functions.
[21] REC (record)
This key works the same way as the one on your original
remote for your VCR. In order to avoid a mistake you have
to press this key twice to activate this feature.
[22] PAUSE
In VCR, DVD or CD mode: This button works the same way
as in your original remote.
IN TV mode: Coloured key (Magenta), control of fasttext or
special equipment functions.
[23] SHOWVIEW
You can use the ShowView or VideoPlus function of your
video recorder with this button (if your video recorder
supports this function). If your video does not support this
function, the button can give access to the timer function or
the menu of your video recorder. When the ShowView/V+
button is used in other modes than the VCR mode (TV, CBL,
SAT, AUDIO), this button is often used for the Scan function.
For example, in TV mode you can change channels or when
listening to a CD you can only listen to the intros. After 3
seconds, the button selects the following channel or song.
Press any button to stop the Scan function. The Scan
function will automatically stop after 2 minutes.
[24] LEARN
Programming button for learning the functions of your
original remote control. See chapter 4.5, Learning codes, for
information about programming these codes.
[25] MACRO, M1, M2, M3
Macro buttons. With these buttons you can execute a series
of pre-programmed commands with one press of a button.
First press the MACRO button. Then press the M1, M2 or
M3 button to activate the relevant macro. See chapter 4.7 for
more information.
[26] L1, L2, L3, L4
Extra buttons for learning the functions of your original
remote control.
4. Programming
To make your remote suitable for your own equipment, you
have to program it once. You can do this by entering a code,
