BODEGA JC-85A Bedienungsanleitung

INSTRUCTION MANUAL

CIGAR CABINET

MODEL: JC-85A

115V 60Hz 75W

Thi

s manual

contains important information including safety and installation instructions

of the

appli

ances. Please read it carefully before use and follow all safety information

instructions. It

recommended to keep this manual for easy reference so that you can

be familiar with

the

operation of the

appliance.

CONTENTS

SECURITY CONSIDERATIONS --------------------------------------------------------------- 3

COMPONENTS ------------------------------------------------------------------------------------- 4

STORAGE -------------------------------------------------------------------------------------------- 5

INSTALLATION AND BEFORE USE ---------------------------------------------------------- 5

SET-UP AND USE OF CIGAR CABINET ---------------------------------------------------- 7

TECHNICAL DATA -------------------------------------------------------------------------------- 10

TROUBLESHOOTING ---------------------------------------------------------------------------- 11

WARRANTY ----------------------------------------------------------------------------------------- 12

Security considerations

Please read the following before using the cigar cabinet

Please read the instructions carefully and operate carefully.

There is a potential danger in any electrical operation. For the sake of safety, please

read the instructions carefully and operate carefully when operating this product.

Do not use power sources other than 115V or access multiple appliances on the

same wiring board.

The cigar cabinet shall use a separate power outlet and the voltage shall match

the nameplate.

Ensure separate and effective grounding of the cigar cabinet.

-This will ensure the best performance and prevent indoor circuit overload,

which may cause the wire overheating and cause fire.

Do not unplug by pulling the power cord. Please hold the plug tightly and unplug it

directly from the power plug.

-Power cord damage may cause short circuit, fire or electric shock.

Make sure the power cord plug is not squeezed or damaged by the back of the

cigar cabinet.

Do not fold the power cord in half or place heavy objects on the power cord.

-There is a fire hazard.

Do not use loose sockets or power cord with cracks or surface wear.

If the power cord is damaged, please contact the manufacturer or other agent

immediately for repair or replacement.

Please be careful not to crush or damage the power cord when moving the cigar

cabinet. Do not touch the power plug with wet hands.

Remove foreign matter and dust from power plug.

-Otherwise there is a fire hazard.

After the cigar cabinet is out of power, wait at least ten minutes before

reconnecting.

If the wall socket is loose, please do not plug into the power plug.

-Otherwise there will be fire or electric shock risk.

This machine must be placed in a suitable place so that it is easy to connect or

unplug the power plug after installation.

Be sure to use a separate, reliable grounding power supply, do not share sockets

with other electrical appliances, to ensure safe use, sockets and their connecting

wires must be able to withstand more than 10A of current.

The cigar cabinet must be grounded.

-To prevent leakage of electricity or electricity from the cigar cabinet.

Never use gas pipes, telephone lines or other hidden lightning rods for grounding.

-Improper grounding may lead to electric shock.

Do not disassemble or repair the cigar cabinet by yourself.

-This can lead to fire, machine failure or personal injury.

-If the cigar cabinet can not be used normally due to self-disassembly, cigar

cabinet will no longer bear the warranty policy and other losses caused by the

inability of the cigar cabinet to work.

The product passes through the back plate for heat dissipation, in order to achieve

the necessary heat dissipation effect please provide the necessary ventilation

conditions.

-Do not cover the product back with cloth or other material.

-Do not put this machine on the bedside to avoid the sleep effect caused by the

sound of the machine running.

-Do not place this machine in restricted spaces such as: bookcases or

embedded cabinets unless properly ventilated. Or contact the merchant to

consult the solution before purchase.

-Be careful to keep the distance between the back and the wall more than 5CM

when placing the product.

Do not place this machine near an electric heater or radiator, or in direct sunlight.

Do not place any heat-producing items such as candles, ashtrays, aromatherapy,

combustible gas or explosive materials near the product.

Do not place containers containing water on this machine, as this may lead to the

risk of fire or electric shock.

Do not expose this machine to rain or near water (e.g. near bathtub, sink, kitchen

sink, or laundry pool, wet basement, or near swimming pool and balcony). If this

machine is accidentally wet, unplug the power immediately and dry with a dry rag.

When cleaning, please use more than 75% medical alcohol to wipe, do not use

water-containing rag to wipe, so as not to cause wood structure mildew and

bacteria breeding.

All parts of this machine are not running with battery.

Do not allow children to climb this product.

The front of the machine is a whole tempered glass, do not use sharp products

bump, so as not to cause glass door breakage.

Do not place this product in unstable positions such as rocking shelves, tilted

ground or positions affected by external vibrations.

Do not cause the product to fall or be impacted. If the product is damaged, please

disconnect the power supply and contact the service center.

Unplug the power cord from the power outlet and wipe it with a soft dry cloth. Do

not use any chemicals such as wax, benzene, alcohol, diluent, insecticide, air

cleaner, lubricant or cleaner to wipe the power after cleaning. This may cause

short circuit of power contact and fire.

COMPONENTS

STORAGE

Installation and Before Use

UNPACKING AND INSTALL THE DOOR HANDLE

Remove the exterior and interior packing materials.

Install the door handle provided with the appliance b

following these steps:

Step 1 －Remove the gasket at the inner side of th

door

to expose the two screw holes.

Step 2 －Install the handle tightly with the screws

and washers provided.

Step 3 －Tidy and restore the gasket.

INSTALLATION INSTRUCTIONS

Before Using Your Cigar Cabinet

Remove the exterior and interior packing.

Before connecting the Cigar cabinet to the power source, let it stand upright for

approximately 24 hours. This will reduce the possibility of a malfunction in the cooling

system from handling during transportation.

Use a soft cloth to clean the interior surface with lukewarm water.

This appliance is intended to be used in household and similar applications such as

– staff kitchen areas in shops, offices and other working environments;

– farm houses and by clients in hotels, motels and other residential type environments;

– bed and breakfast type environments;

– catering and similar non-retail applications.

When disposing your appliance, please choose an authorized disposal site.

Installation of Your Cigar Cabinet

This appliance is designed to be for free standing installation or built-in (fully recessed)

(Refer to sticker location the back of this appliance).

This appliance is intended to be used exclusively for the storage of cigar.

Place your Cigar cabinet on a flat floor that is strong enough to support it when it is fully

loaded. To level your Cigar cabinet, adjust the front leveling leg at the bottom of the

appliance.

This appliance is using flammability refrigerant. So never damage the cooling pipework

during the transportation. Locate the Cigar cabinet away from direct sunlight and sources

of heat (stove, heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat

sources may increase electrical consumption. Extreme cold ambient temperatures may

also cause the unit not to perform properly.

Avoid locating the unit in moist areas.

Plug the Cigar cabinet into an exclusive, properly installed-grounded wall outlet. Do not cut

or remove the third (ground) prong from the power cord under any circumstances. Any

questions concerning power and/or grounding should be directed toward a certified

electrician or an authorized Products service center.

Attention

Store Cigar in sealed boxes;

Do not overload the cabinet;

Do not open the door unless necessary;

Do not cover shelves with aluminum foil or any other shelf material which may prevent air

circulation;

Should the Cigar cabinet be stored without use for long periods, it is suggested to leave the

door ajar to allow air to circulate inside the cabinet after a careful cleaning,avoiding

possible formations of condensation, mold or odors.

The product needs to run 24 hours after the power operation before putting into the cigar.

Cedar wood shelf in cigar cabinet needs to absorb enough moisture and the inner duct

board needs to be wet enough to achieve the desired operating effect.

Set-up and Use of Cigar Cabinet

CONTROL PANEL

Lock key Press the button for 3 seconds to

open/close the lock function.

Temp. Up button Press to add temperature when setting.

Temp. Down button Press to reduce temperature when

setting.

Humidity Up button Press to add humidity when setting.

Humidity Down button Press to reduce humidity when setting.

Combination key Press the combination key at the same

time for 3 seconds, you can interchange

the Fahrenheit (ºF) and Celsius (ºC).

Lamp/switch power key Press to turn on/off the light; long press

for 3 seconds to turn on/off the power

After the temperature or humidity of the cigar cabinet is set up, the system flashes for

5 seconds and automatically confirms, without the need of keystroke confirmation.

Cigar cabinet cigar maintenance temperature and humidity setting.

-Recommended temperature setting range :16-22℃(62-72℉).

-Recommended humidity setting range: 50-80%.

Set temperature and humidity.

-Long press the to turn on the unit. Then begin to set the temperature by

pressing or to add or reduce the temperature; press the or to

add or reduce humidity.

Temperature and humidity display calibration function.

-When the temperature and humidity display of the cigar cabinet comes with a

deviation from your temperature and humidity meter display, the following

operation can be carried out to calibrate the temperature and humidity display.

-It is recommended that the cigar cabinet runs at least 3 days before calibration.

Cigar cabinet calibration operation:

-Press the up and down button at the same time, after 5 seconds the

temperature displays a number "0", you can start the temperature calibration.

Press the up and down button key again for the humidity calibration while the

humidity displays “0”.

-If the temperature/humidity of the unit is ＜the value of temperature and

humidity meter, press temp./ humidity Up button to increase the value.

-Conversely, if the temperature/humidity of the unit is ＞the value of

temperature and humidity meter, press temp./ humidity Down button to reduce

the value.

Water tank.

-Note: please add water into water tank before use. Water shortage may cause

the humidity can not reach the set value.

-It is suggested to add purified or distilled water only with 1/2 of the water tank

capacity. Do not use directly the tap water to avoid impurities.

-Please keep the white mesh inside the water tank when adding water. If the

white mesh become yellow or black due the impurities, take it out and use

white vinegar, baking soda and water to soak it together.

-It is recommended to clean the water tank every month and replace the water

in the water tank.

Interior lighting

-Press the lamp key to turn on (or turn off) the interior cool LED lighting.

Lock

- Press the button for 3 seconds to lock. When the control panel is locked, other

key icons are not available except the light icon.Press the button for 3 seconds

to unlock.

LCD PANEL

Symbol Description

The light is on

Cooling/dehumidified

Fan is on

Heating for temperature and

humidification compensation

Defrosting

Alarm notification

Lock/unlock

Current Temperature

Current Humidity

If the unit displays other icons. Do not self-install to avoid personal injury.

The temperature and humidity are interrelated, it is normal that the cooling and

heating icons will light on at the same time when the cigar cabinet is working.

Refrigeration.

-While the cabinet works, the is lit.

-The cigar cabinet is designed for use with R600a as the designated ,no need to

add freon during use.

-Therewillbenofrosting onthe back at the air cooling mode.

Heating

-The cigar cabinet has heating compensation function, and the maximum

temperature compensation is 10-15 degrees. If the ambient temperature is too

low, the cigar cabinet can not reach the set temperature, please move the

product to a higher temperature environment for use.

-The cigar cabinet use PTC heater for heating, through the entire rear duct plate

for hot air heating. So there will be no damage to the cigar.

-While the cabinet begins to heat, the is lit.

Humidification

-The cigar cabinet converts the water in the bottom water tank into humidity by

humidifying fan for the inner cabinet. Therefore, it is recommended to use pure

water or distilled water to avoid impurities contaminating cigars.

-While the cabinet Humidifies, the is lit.

Dehumidification .

-The humidity will be converts to condensing water during refrigeration and flow

into the water tank.

-While the cabinet dehumidifies, the is lit.

Defrosting

-the cabinet has the auto defrosting function. While it defrost, the will be on.

Alarm notification

-If there is any failure on the appliance, the will be lit to remind you.

TECHNICAL DATA

Model JC-85A

Total Volum 2.88Cu.Ft.

Power 115V~60Hz

Amps 1.0A

Start-up Amps 10A

Power Input 75W

Pressure High Side 105PSL

Pressure Low Side 55PSL

Refrigerant R600a

Amount 0.78 oz.

Net Weight 70.9

Inhaltsverzeichnis

Andere BODEGA Küchengerät Handbücher

BODEGA

BODEGA YC-408A Bedienungsanleitung

Beliebte Küchengerät Handbücher anderer Marken

Tayama

Tayama TYG-35AF Bedienungsanleitung

AEG

AEG 43172V-MN Bedienungsanleitung

REBER

REBER Professional 40 Benutzerhandbuch

North American

North American BB12482G / TR-F-04-B-NCT-1 Bedienungsanleitung

Presto

Presto fountain popper Bedienungsanleitung

Westmark

Westmark 1035 2260 Bedienungsanleitung

Zanussi

Zanussi ZCG64396XA Bedienungsanleitung

HOFFEN

HOFFEN SM-9302M Bedienungsanleitung

Philips

Philips HD3133 Bedienungsanleitung

Ronco

Ronco Beef Jerky Bedienungsanleitung

Hendi

Hendi 470411 Bedienungsanleitung

Livoo

Livoo MEN386 Bedienungsanleitung

Vogue

Vogue D446 Bedienungsanleitung

croydon

croydon WR-10313-700 Bedienungsanleitung

ADE

ADE AUTOMATIC-L Bedienungsanleitung

Chefman

Chefman RJ43-SQ Series Bedienungsanleitung

Vacmaster

Vacmaster VP680 Bedienungsanleitung

Jetmaster

Jetmaster 900HG Bedienungsanleitung