8
Installation to the power supply
Installation to the power supplyInstallation to the power supply
Installation to the power supply
Consider the instructions that we give you under "Electrical connection".
Adjusting the feet
Adjusting the feetAdjusting the feet
Adjusting the feet
Place the appliance in its proper position and take care that it is leveled solid and horizontal. Check this with a
spirit level.
•You can adjust the back foot by the adjusting screw (a) at the center of the
appliance plinth front with an Allen key.
•Adjust the front feet (b) with a screw-wrench until the dishwasher is leveled.
The maximum adjustment height of the feet is 50 mm.
Fixing the dishwasher
Fixing the dishwasherFixing the dishwasher
Fixing the dishwasher
Fix the appliance by tighten the screws from the appliance inside to the provided holes accordingly.
1
11
1If the worktop made of wood, fasten the appliance to the work top.
2
22
2If the worktop made of marble or granite, fasten the appliance sideways with
the housing unit. Put the screw covers on.
Water connection
Water connectionWater connection
Water connection
CAUTION:
CAUTION:CAUTION:
CAUTION:
•The Installation of the water supply must conform to the local laws and regulations.
•The appliance is not
notnot
not suitable for hot water supply.
•Use the new supplied hose set to connect the appliance to the water supply. Do not reuse old or used
connection sets.
•If the water pipe is new or long time not used, ensure before connecting to the water system, that the water
is clear and free from contamination.
Notes on inlet hose safety system (not included in delivery)
Notes on inlet hose safety system (not included in delivery)Notes on inlet hose safety system (not included in delivery)
Notes on inlet hose safety system (not included in delivery)
The safety system consists of a double-walled inlet hose. This system guarantees to cut off the water supply
when leakage of the inner hose. Switching off the water supply leads over an electronic contact.
If necessary, you can order an inlet hose safety system from your dealer or in our online accessories shop,
www.bomann.de
www.bomann.dewww.bomann.de
www.bomann.de. To order, use the reference number found under “Technical Data”.
Connect the water
Connect the water Connect the water
Connect the water inlet
inletinlet
inlet
hose (cold water connection)
hose (cold water connection)hose (cold water connection)
hose (cold water connection)
NOTE
NOTENOTE
NOTE:
::
:
The water pressure must be between 0.04 and 1 MPa. With higher pressure: use a pressure regulator.
•Connect the water inlet hose to a water thread with ¾“. Screw the hose firmly in the direction
of the screw thread; pay attention for a tight fit.
•Connect the other end of the inlet hose to the inlet valve on the appliance back; pay attention
for a tight fit too.
