16 17
TROUBLESHOOTINGSAFETY PRECAUTIONS
• Before operation of the juicer carefully read
this operating manual. It contains important
information on safety methods, operation and
care of the juicer. Keep this operating manual, so
that it can be referred to in the future, and if the
juicer passes to another owner give the manual
together with the appliance.
• The juicer is not meant for operation by
unattended children.
• Keep the juicer’s casing clean. During cleaning
observe the instructions specified in section
“Maintenance and Cleaning”.
• Avoid overhanging of the power cord from the
edge of the table, do not lay it on heated surfaces,
avoid twisting of the cord.
• Put the juicer only on a dry even surface.
• Always unplug the juicer when you leave it
unattended, after usage, as well as before
assembly, dismantling, cleaning and storage.
• Upon detection of any damages immediately
suspend operation of the juicer and bring it to
the nearest service center for testing, repair or
replacement.
• Do not leave the operating juicer unattended.
• Before operation make sure that the juicer is
correctly assembled.
• To load products always use the pusher for
products included in the set.
• Do not touch the sharp blades in the filter base.
Do not touch the sharp blades in the feed chute.
• Before juicing remove kernels from fruit, such as
plums, apricots and peaches.
• Use the juicer to make juices from vegetables,
fruit or berries.
• For safety reasons all operations on repair and
maintenance of the juicer shall be performed
only by authorized representatives of BORK
certified service centers.
Failure Solution
When you switch on the juicer it does
not work.
The juicer is probably assembled incorrectly. The lid block must be fixed in
the vertical position in two grooves on the juicer’s lid.
Small amount of juice. Unplug the juicer. Take off the juicer’s lid and clean the filter with the brush.
Assemble the juicer and continue juicing. Try to load soft and solid products
alternatively. Reduce the speed of product supply.
Pulp contains too much liquid. Unplug the juicer. Take off the juicer’s lid and clean the filter with the brush.
Juice leaks from under the juicer’s lid. Reduce the speed of product supply by the feed chute. Products with a large
content of water must be juiced at low speed.
Upon detection of any damages refer to the
nearest BORK service center.