Bosch PCH615FAU Bedienungsanleitung

Carl-Wery-Straße 34

81739 München

Robert Bosch Hausgeräte GmbH

www.bosch-home.com

This cooktop is for use with Natural Gas and Universal LPG

PCH615FAU

PCH615DAU

PCH615CAU

PCD615CAU

Cod. 9000298602 D

CONTENT

4Safety considerations

For your safety

Warnings

Installation

Preparing to install

Clearances

Installation of cooktop into Kitchen bench

Connection

Electrical connection

Gas connection

To change injectors

Minimum flame adjustment

Injector size chart

Operating instructions

User instructions

Warnings concerning cooking

Cleaning and maintenance

Service

Trouble shooting

Wiring diagram

Installation procedure

Conversion front Nat. Gas to Universal LPG

4Contents

What to do if you smell gas

Burner ignition & control

Burner location

7

Safety considerations

•  If the information in this manual is not followed exactly, a

fire or explosion may result causing property damage, personal

injury or death.

• Do not store articles on or against this appliance.

• Do not store flammable material near this appliance.

• Do not spray aerosols in the vicinity of this appliance while

it is in operation.

• Do not try to light the appliance.

• Do not touch any electrical switch; do not use any phone

in your building.

• Inmediately call your gas supplier from a neighbour’s phone.

Follow the gas supplier’s instructions.

• If you cannot reach your gas supplier, call the fire department.

• Installation and service must be performed by an authorised

person.

1. Do not allow the flame to extend beyond the edge of  the

cooking utensil. This instruction is based on safety considera-

tions.

2. Do not forget that the unit becomes hot when in use. 

Common sense is important. Just because the flame is out,

does not mean parts cannot still be hot.

3. This appliance shall not be used for space heating. 

This instruction is based on safety considerations.

4. Be sure to disconnect the electrical supply before disass-

embly of the appliance.

5. Keep the appliance area clear and free from  combustible

materials, gasoline and other flammable vapours and liquids.

6. This appliance must be installed in a position with the proper

level of ventilation. Do not obstruct the flow of combustion and

ventilation air.

7. Cabinets installed above the gas cooktop must have a

minimum clearance of 650 mm (24”).

8. The gas pressure regulator supplied with the appliance 

must be installed in line with the gas pipe. (N.G. only)

9. For pressure testing in excess of 3.5 kPa (1/2 psig) the

appliance and its individual shutoff valve must be disconnected

from the gas suply piping system.

For your safety

What to do if you

smell gas

Warnings

10. Important. When using a very large pot, leave a gap of at

least 50 mm (2”) to avoid damaging any parts in bench top

wood, plastic or other non-heat resistant materials. Never leave

oil or hot fat unattended.

11.The surfaces on heating and cooking appliances get hot

when in use. Be careful. Keep children away from the



12.Only use your appliance for the preparation of food and

 for room-heating purposes.

13.This appliance leaves the factory set for the gas supply

14. Do not tamper inside the appliance. If necessary, call your

local Service Centre.

15. Overheated fat or oil can easily catch fire. Never leave the



 Cover the receptacle to smother the flames and turn

the hob off.

17. In the event of a fault, cut the gas and electricity supplies

to the appliance. Call our Service Centre to repair the fault.

18. Do not use unstable or uneven-based receptacles on

cooking plates or burners. They may accidentally tip over.

19. If a gas supply knob/valve jams, do not force it. Call your

official Service Centre immediately for them to repair or replace

it.

20. The illustrations used in this booklet are only intended as

a guide.

Note: To avoid jeopardising the electrical safety of the appliance,

it is forbidden to use high-pressure or steam jet cleaning



SHOULD THE RELEVANT CONDITIONS NOT BE

PROPERLY SATISFIED, THE INSTALLER, AND NOT

THE MANUFACTURER, SHALL HELD LIABLE.

if it needs to be altered.

appliance.

never

BURNS!

devices.

16. Never pour water on burning fat or oil. DANGER OF

appliance unattended when cooking food with fat or oil, e.g.

chips.

with the grids.

22. Do not use this appliance neither in marine craft nor in

indicated on the data label. Call the Service Centre

21. Grids become very hot during use. When operating the



appliance control knobs, take care not to make contact



Make sure you keep these instructions for use and assembly in

caravans.

a safe place, so that you can hand them on with the

appliance if it ever changes owner.

This appliance is not intented for use by persons (including chil-

dren) with reduced physical, sensory or mental capabili-

ties, or lack of experience and knowledge, unless they have

been given supervision or instruction concerning use of the

appliance by a person responsible for their safety.

This installation must conform with the following:

• Manufacturer’s Installation instructions

• Local Gas Fitting Regulations

• Municipal Building Codes,

• AGAInstallation Code for Gas Burning Appliances. 

• S.A.A. Wiring Code

• Local Electrical Regulations

• Any other statutory regulations

These built-in hobs are intended to be inserted in a

benchtop cutout.

Only an officially authorised technician should connect

the appliance.

Before connecting the unit, check whether the local

connection conditions (type of gas) are compatible with

the unit’s setting. Observe any special conditions imposed

by local suppliers (utilities). The specifications of this

cooktop are stated on the data label located on the

bottom of the cooktop base.

Preparing to

install

an accessible location near the hotplate if the data

A duplicate data label is supplied for adhesion to

accessed when the hotplate is installed.

label on the base of the hotplate cannot be

Installation dimensions are shown in Fig.1.

(AS 5601 - 2004 - Gas Installations).

Installation

Statutory

requirements

Refer to the AGA Installation Code for piping size details.

Before you begin, turn off the gas and electricity supply.

/ max 60

A range hood fitted above the top must be installed

according to the installation instructions for the range

hood. A minimum distance of 650 mm is required for a

range hood and 750 mm for an exhaust fan.

Minimum thickness of benchtop is 30 mm. See Fig. 2.

Clearances

Installation of

cooktop into the

kitchen bench

minimum

1. For cutout dimensions and clearances refer

Any adjoining wall surface situated within 200mm from the

edge of any hob burner must be a suitable non-com-

If the base of the hotplate can be touched, a protecting

shield must be fitted. This shield must be at least

10mm from the lowest part of the hotplate and must

be capable of withstanding the appliance temperatures.

bustible material for a height of 150mm for the entire

length of the hob. Any combustible construction above

the hotplate must be at least 650mm above the top of

the burner and no cons

above the top of the truction shall be within 450mm

burner

A minimum depth of 50mm from the top of the worktop

surface must be provided for the appliance.

2. a) If the clamps and the selfadhesive seal (lower edge

of the hob) are already fitted (depending on the model),

keeps the entire work surface watertight and prevents

spilage from leaking into cupboards underneath. Slightly

do not under any circumstance remove them. The seal

losen the retaining screws of the clamps positioned at

the bottom of the cooktop.

30 mm

Installation procedure:

b) If the clamps and the selfadhesive seal have not

the gas burner covers from your cooking hob and turn it

upside down. Now fit the selfadhesive seal supplied

with the appliance onto the lower edge of the hob. Take

the clamps and screw them into the lower point designed

been fitted in the factory, remove the pan support and

for this purpose. See Fig. 3.

Side clearances: If the distance measured from the

periphery of the

nearest burner to any vertical surface

is less than 200 mm, the surface shall be protected in

accordance with clauses 5.12.1.1 & 5.12.1.2 of AS 5601.

Fig.1.

4.Once the hob is fitted you should turn the clips and

tighten the screw as shown in Fig. 4.

that the hob is resting on its entire perimeter.

3. Place the hotplate on top of the bench cut-out and

press down firmly on all edges at the same time to ensure

Connection

Installation continued

Electrical:

An electrical 10 amp socket needs to be within 1 m of the

accessible after installation of the appliance.

Important note:

This appliance is connected to the mains (240 VAC) by means

of the connecting lead which must be fixed to the kitchen unit

to prevent it from coming into contact with hot parts of the hob

Gas:

During the planning stage, consider the position of supply

The hob must be connected to the gas supply with upstream

connection of an isolation valve in accordance with the respec-

tively valid regulations. We recommend that the isolation valve

be fitted prior to the cooktop to enable isolation of cooktop

from gas supply. The valve must be easily accessible at all

times.

To find out the factory set gas type, see bottom of cooktop next

to gas connection.

Remove plastic cap from gas supply line prior to installation.

Direction of gas flow is indicated on the rear of the regulator.

Use pipe compound or thread sealant, properly theaded pipes

and careful assembly procedure so that there is no cross

threading, etc., which might cause damage or leakage.

Make sure that all connections peformed are free of leakage.

In either of the cases, do not move or twist the L-tube from its

factory-set position.

If for some reason, the L-tube should be twisted, it is necessary

to make sure that this area is properly sealed. Make sure that

all connections performed are free of leakage.

The manufacture does not accept any liability for leakage on

Natural gas connection

Pressure

test point R 1/2”Pressure

test point.

R 1/2”

or twisted.

connections.

Fit regulator (N.G.) or a test point (Universal LPG) directly to

R1/2" connection as per Fig. 5. and Fig. 6.

the

connections performed by the installer or if the L-tube is moved

Universal LPG connection

(or an oven installed underneath) and remain accessible after

installation of the cooktop.

When making this connection make

sure that the lead cannot come into contact with hot parts

hotplate to allow electrical connection. The socket must remain

of the hob.

Important: This appliance must be earthed. When connecting

the cooktop ensure that the earth wire is connected first and

that all wires are connected to the correct terminals.

For position of the inlet connection refer Fig.1.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Bosch Kochfeld Handbücher

Bosch

Bosch NKN645B17 Bedienungsanleitung

Bosch

Bosch NIT8065UC - Strips 800 30" Induction Cooktop Bedienungsanleitung

Bosch

Bosch AutoChef NETP666SUC Bedienungsanleitung

Bosch

Bosch HIIP055U Bedienungsanleitung

Bosch

Bosch NGM Series Bedienungsanleitung

Bosch

Bosch NES 730 UC Bedienungsanleitung

Bosch

Bosch PKF652BB1E Bedienungsanleitung

Bosch

Bosch NEM73 Bedienungsanleitung

Bosch

Bosch Benchmark Series NETP066SUC Bedienungsanleitung

Bosch

Bosch PCL985FAU Bedienungsanleitung

Bosch

Bosch NIT5665UC - Strips 500 36" Induction Cooktop Bedienungsanleitung

Bosch

Bosch NGMP655UC Bedienungsanleitung

Bosch

Bosch AutoChef NET 8654 UC Bedienungsanleitung

Bosch

Bosch Integra HDI7282U Bedienungsanleitung

Bosch

Bosch NEM 75 Series Bedienungsanleitung

Bosch

Bosch NIT8053UC - 30in 4 Burner Induction Cooktop Bedienungsanleitung

Bosch

Bosch NIT8653UC - 36in 5 Burner Induction Cooktop Bedienungsanleitung

Bosch

Bosch NET8066UC Bedienungsanleitung

Bosch

Bosch NET8066UC Bedienungsanleitung

Bosch

Bosch NIT8065UC - Strips 800 30" Induction Cooktop Bedienungsanleitung

Bosch

Bosch PRP 6A6 D70R Bedienungsanleitung

Bosch

Bosch NEM5066UC Bedienungsanleitung

Bosch

Bosch NITP660SUC Bedienungsanleitung

Bosch

Bosch NIT8053UC - 30in 4 Burner Induction Cooktop Bedienungsanleitung

Beliebte Kochfeld Handbücher anderer Marken

Bonnet

Bonnet OPTIMUM 700 Betriebsanleitung

Jenn-Air

Jenn-Air JGCP430 Bedienungsanleitung

Frigidaire

Frigidaire FES367FCC Kurzanleitung

Ztove

Ztove EZ2 DUO Bedienungsanleitung

Kleenmaid

Kleenmaid cooking GCTK9011 Installationsanleitung

Casselin

Casselin CSASRE24 Bedienungsanleitung

Jenn-Air

Jenn-Air JGC2536EB00 Bedienungsanleitung

Waldorf

Waldorf RN8603E-B Bedienungsanleitung

Whirlpool

Whirlpool SMP658CNEIXL Bedienungsanleitung

Wolf

Wolf CI243C/B Bedienungsanleitung

Fulgor Milano

Fulgor Milano F5PGK305S1 Bedienungsanleitung

GE JP389 Bedienungsanleitung

Wells

Wells WV-2HFG Bedienungsanleitung

IKEA

IKEA Lagan HGA4K Bedienungsanleitung

Samsung

Samsung NA36N9755 Bedienungsanleitung

Miele

Miele KM 404 Bedienungsanleitung

Lacor

Lacor 69562 Technisches Datenblatt

Keating Of Chicago

Keating Of Chicago MG-2 Bedienungsanleitung