7
THD20.. 06/2012
en
To install a new lter cartridge, proceed as
follows:
Preparing and installing the BRITA
MAXTRA lter cartridge
►Remove the lter cartridge’s protective
packaging.
►Immerse the lter cartridge in cold tap
water and shake it lightly (for about ve
seconds) to remove any air bubbles.
►Take the lter holder out of the water tank
and rmly insert the cartridge into the
holder until you hear a click.
►Hold the lter holder under the water tap
and ll it with fresh, cold water; let the
water run through the BRITA MAXTRA
lter cartridge.
►Repeat this procedure two or three times.
►Place the lter holder with the lter
cartridge back into its position in the
empty water tank and ll the tank with
cold tap water.
►Hold down start/stop button for at least
2 seconds to delete M.
Note: To replace the cartridge, simply
pull on the strap attached to the top of the
cartridge. When installing a new cartridge,
follow the above steps for preparing and
inserting a cartridge.
Used BRITA MAXTRA water lter
cartridges can be disposed of with
the regular household garbage. If you
have more questions, contact BRITA
Consumer Service at 0844 742 4800
(toll-free).
Important information
– Always store spare lter cartridges
sealed in the original packaging in a cool
and dry place.
– BRITA water lters are designed for use
only with municipally treated tap water
(note: this water is constantly control-
led and according to legal regulations
safe to drink) or with water from private
supplies which has been tested as safe
to drink. If an instruction is received from
the authorities that mains water must be
boiled, the BRITA ltered water must also
be boiled. When the instruction to boil
water is no longer in force, the appliance
and lter funnel must be cleaned and
a new cartridge inserted to ensure any
residual contaminants are removed.
– Please lter cold tap water only.
– Clean the appliance and lter funnel
regularly.
– For certain groups of people (e.g. those
with impaired immunity and for babies), it
is generally recommended that tap water
should be boiled; this also applies to
BRITA ltered water.
– For hygiene reasons, the MAXTRA
cartridge contents are subject to special
treatment with silver. A very small
amount of silver may be transferred to
the water. This transference would be
within the World Health Organisation
(WHO) guidelines.
– During the ltering process, there may be
a slight increase in potassium content.
However, one litre of BRITA ltered water
contains less potassium than e.g. an
apple. If you have kidney disease and/
or follow a potassium restricted diet, we
recommend that you consult your doctor
before using a BRITA water lter.
– Should your BRITA appliance not be in
use for a prolonged period (e.g. holiday),
BRITA recommends that you take out the
cartridge, discard any water left inside
the BRITA water lter and loosely insert
the MAXTRA cartridge again. Before us-
ing the BRITA water lter again take out
the cartridge, clean the appliance and
funnel thoroughly and repeat the steps
of the instructions for use in chapter:
“Preparing and installing the BRITA
MAXTRA lter cartridge”.
– BRITA ltered water is dedicated for
human consumption. It is a perishable
food and as such please consume within
1 to 2 days.
