1
.
The transmitter sends a signal.
2
.
Repeaters receive the signal and re-broadcast it, allowing the user
to extend the range of the RF system to cover large areas such as
installations in campuses, sites with detached buildings, or
multiple story complexes.
3
.
The receiver hears the signal from the repeaters and processes
accordingly.
Functions
Installation
The installation is as easy as mounting the repeater
and plugging it in. No wires or programming are
required, although registration is recommended for a
fully supervised system.
Supervision and Expansion
The repeater supervises for low battery, loss of line
power, case tamper, and jam detection. An on-board
lithium-ion battery:
• Provides backup without additional expense
• Offers up to 24 hours of continuous operation when
line power is unavailable
• Reports power loss when programmed or supervised
to a slave receiver
Installers can employ multiple repeaters in a micro-
cellular network, providing coverage for applications
including large campuses with multiple-story buildings.
Signal Management
The repeater incorporates sophisticated signal
management, preventing ping-pong messages and
maximizing reliability.
Certifications and approvals
Inovonics Wireless Corporation also holds the following approvals:
FCC Conforms to FCC Part 15 regulations
Installation/configuration notes
Compatibility Information
The EN5040‑T High‑power Repeater is compatible with
the following products:
Receivers
EN4200 Serial Receiver
EN4204R LED Receiver
Transmitters
EN1210 Universal Transmitter (Single‑input)
EN1210EOL Universal Transmitter with EOL Resistor
EN1210SK Survey Transmitter
EN1210W Door-Window Transmitter with Reed Switch
EN1215EOL Universal Transmitter with Wall Tamper and EOL
Resistor
EN1215WEOL Door‑Window Transmitter with Wall Tamper,
Reed Switch, and EOL Resistor
EN1223D Water-resistant Pendant Transmitter
(Double‑button)
EN1223S Water-resistant Pendant Transmitter
(Single‑button)
EN1223SK Survey Pendant Transmitter
EN1233D Necklace Pendant Transmitter (Double‑button)
EN1233S Necklace Pendant Transmitter (Single‑button)
EN1235D Beltclip Pendant Transmitter (Double‑button)
EN1235S Beltclip Pendant Transmitter (Single‑button)
EN1235DF Fixed-location Transmitter (Double‑button)
EN1235SF Fixed-location Transmitter (Double‑button)
EN1242 Smoke Detector-Transmitter
EN1247 Glass-break Sensor Transmitter
EN1249 Billtrap Transmitter
EN1260 PIR Motion Sensor‑Transmitter (Commercial
and High‑end Domestic Applications)
EN1261HT PIR Motion Sensor‑Transmitter (High‑traffic
Areas)
EN1262 PIR Motion Sensor‑Transmitter (Residential and
Low‑traffic Commercial Applications)
EN1265 PIR Motion Sensor‑Transmitter (Ceiling‑mount
Applications)
Parts included
Quant. Component
1EN5040‑T Repeater
1 Transformer
1 Backup battery assembly (BAT850)
1 Hardware pack
1 Literature – Installation and Operation Manual
Technical specifications
Electrical
Power Requirements: 14 VAC, 250 mA
Backup Battery
• Capacity: 3.7 VDC nominal, 2.45 Ah
• Life: 24 hours typical
• Type: Rechargeable lithium-ion battery
2 | EN5040-T High-power Repeater
