Bosch HWD27 Bedienungsanleitung

Warming Drawer

Modc_s:

HWD27_ HWD30

Table of Contents

Safety ...................................... 1

ImportantSafety Instructions ....................................... 1

Installation .................................. 3

Before you Begin ................................................. 3

Tools and Parts Needed ...................................................... 3

Parts Included .............................................................. 3

General Information .......................................................... 3

Installation Procedure ........................................................ 5

Service ..................................... 7

Data Plate ................................................................. 7

This Bosch Appliance is made by

BSH Home Appliances Corporation

1901 Main Street, Suite 600

Irvine, CA 92614

Questions?

1-800-944-2904

www.boschappliances.com

We look forward to hearing from you!

Safety

Important Safety Instructions

READ AND SAVE THESE INSTRUCTIONS

Appliance Handling Safety

Safety Codes and Standards

Electric Safety

WARNING:

If the information in this manual is not followed exactly, fire or shock may result

causing property damage or personal injury.

WARNING:

Do not repair or replace any part of the appliance unless specifically recommended

in the manuals. Improper installation, service or maintenance can cause injury or

property damage. Refer to this manual for guidance. All other servicing should be

done by a qualified technician.

Hidden surfaces may have sharp edges. Use caution when reaching behind or

under appliance.

This appliance complies with one or more of the following Standards:

• UL 1026 - Electric Household Cooking and Food Serving Appliances

• CSA-C22.2 No. 64-10 - Household cooking and liquid-heating appliances

• UL 858, The Standard for the Safety of Household Electric Ranges

• UL 923, The Standard for the Safety of Microwave Cooking Appliances

• UL 507, The Standard for the Safety of Electric Fans

• ANSI Z21.1, The American National Standard for Household Cooking Gas

Appliances

• CAN/CSA-C22.2 No. 113-M1984 Fans and Ventilators

• CAN/CSA-C22.2 No. 61-M89 Household Cooking Ranges

It is the responsibility of the owner and the installer to determine if additional

requirements and/or standards apply to specific installations.

Before you plug in the electrical cord, be sure all controls are in the OFF position.

For appliances equipped with a cord and plug, do not cut or remove the ground

prong. It must be plugged into a matching grounding type receptacle to avoid

electrical shock. If there is any doubt as to whether the wall receptacle is properly

grounded, the customer should have it checked by a qualified electrician.

If required by the National Electrical Code (or Canadian Electrical Code), this

appliance must be installed on a separate branch circuit.

Installer - show the owner the location of the circuit breaker or fuse. Mark it for easy

reference.

Important - Save these instructions for the local electrical inspector's use.

Before installing, turn power OFF at the service panel. Lock service panel to prevent

power from being turned ON accidentally.

English 1

Refertodataplateformoreinformation.See"DataPlate"under"Service"fordata

platelocation.

Important Safety Instructions

READ AND SAVE THESE INSTRUCTIONS

Related Equipment Safety

Be sure your appliance is properly installed and grounded by a qualified technician.

Installation, electrical connections and grounding must comply with all applicable

codes.

Remove all tape and packaging before using the appliance. Destroy the packaging

after unpacking the appliance. Never allow children to play with packaging material.

Never modify or alter the construction of the appliance. For example, do not remove

leveling legs, panels, wire covers or anti-tip brackets/screws.

CAUTION:

For units with glass panels, use care when handling glass to avoid breaking. Broken

glass could cause injury.

English 2

Installation

Before you Begin

Tools and Parts Needed

Parts Included

• T-20 6-lobe screwdriver

• Measuring tape

• Drill with bit (1/8")

T-20 6-lobe screws, #8xl/2" (8)

General Information

Power Requirements and

Grounding

Overall Dimensions

Circuit Specifications: 120V, 15A, 60Hz

The outlet must be properly grounded in accordance with all applicable codes.

@BOSCH 0

)

Dimension Model

27" (685 ram) 30" (762 ram)

A 25" (634 mm) 28" (710 mm)

B 10 3/4" (274 mm) 10 3/4" (274 mm)

C 22 1/4" (565 mm) 22 1/4" (565 mm)

D 11 7/16" (289 mm) 11 7/16" (289 mm)

E 26 5/8" (676 mm) 29 5/8" (752 mm)

English 3

Cabinet Cutout Dimensions Instructions are based on standard American cabinets 36" (914 mm) high and 24"

(609 mm) deep with a 25" (635 mm) countertop. If using non-standard cabinets,

alter dimensions accordingly.

Cabinet opening bottom must be able to support 110 pounds (50 kg).

1/2"--3----

(12.7mm)

Allow 3-1/2" (88.9mm) in front

1-1/2" (38,1mm) min. to

1/2" (12.7mm) r = opening above __1 f°r drawer handle clearance

[-- Frame Overlaps

-L-ca_%....... _ -U' _-- c

..... t- , 1;

B I

Frame

_ A

*- D _ Overlaps

Cabinet

X_Wall

Receptacle

Dimension Model

27" (685 ram) 30" (762 ram)

A 25 3/8" (645 mm) 28 3/8" (721 mm)

B 10 7/8" (276 mm) 10 7/8" (276 mm)

C 24" (610 mm) 24" (610 mm)

D 5/8" (16 mm) 5/8" (16 mm)

Custom Drawer Front Dimensions Build custom drawer front to the dimensions specified in the following table. All four

(Optional} edges must be finished. If using wood, the back must be sealed to prevent moisture

damage.

| E

Pilot Holes _ B

lg_"_:t2e7:oTJ J-

'IDIZ

English 4

Dimension Model

27" (685 mm) 30" (762 mm)

A 26 3/4" (679 mm) 29 3/4" (755 mm)

B 11 1/4" (286 ram) 11 1/4" (286 ram)

C 3 5/8" (93 ram) 3 5/8" (93 ram)

D 2 3/16" (55 ram) 2 3/16" (55 ram)

E 2 5/8" (66 ram) 2 3/4" (69 ram)

F 1 5/8" (40 ram) 1 5/8" (40 ram)

G 21 1/2" (547 ram) 24 3/8" (618 ram)

Installation Procedure

CAUTION:

Before installing, turn power OFF at the service panel. Lock service panel

to prevent power from being turned ON accidentally.

Prepare cabinet cutout.

Prepare cabinet cutout and install electrical connection according to the

dimensions in "General Information".

Remove drawer.

Pull drawer to fully open position.

Press down right drawer clip.

Lift up left drawer clip.

Firmly pull the drawer straight out. Retract cabinet rails while drawer is

removed.

Connect power cord.

Insert plug into three-prong, grounded outlet. See "Power Requirements and

Grounding" above for electrical specifications.

English 5

4. Installwarmingdrawer.

_ AUTION:

It is recommended to have 2 installers to install warming drawer. Failure

to do so may result in property damage or personal injury.

Slide warming drawer assembly into cutout until it is flush with cabinet. Secure

through four screw holes in front frame (drill pilot holes in cabinet first if

necessary).

5. Attach custom drawer front (optional).

CAUTION:

Use care when handling glass panel to avoid breaking. Broken glass

-- could cause injury.

1) Prepare custom drawer front as explained above.

2) Remove drawer from warming drawer frame (See Use and Care Manual for

instructions).

3) Remove six screws from backside of drawer front. Set handle and screws

aside.

4) Remove signal light lens from glass panel and set aside. Discard glass

panel (Note: stainless steel models do not have a glass panel).

5) Install the signal light lens in the custom drawer front.

6) Attach drawer front with six screws. Attach handle as well if desired.

6. Replace drawer.

1) Be sure cabinet rails are pushed inside cabinet.

2) Align the drawer rails with the cabinet rails.

3) Firmly push the drawer straight into the cabinet until drawer clicks into

place.

4) Open and close drawer to test operation. Note: if the drawer will not close,

verify that the rail clips are properly positioned.

7. Turn power on at the service panel.

8. Test the installation.

Turn the warming drawer on. Signal light and timer should turn on immediately.

Check for warmth.

English 6

Service

Data Plate

If the warming drawer elements or signal light do not turn on, check the power

source to see if the circuit breaker is tripped.

See Use and Care Manual for troubleshooting information. Refer to the Warranty in

the Use and Care Manual.

To reach a service representative, see the contact information at the front of the

manual. Please be prepared with the information printed on your product data plate

when calling.

The data plate shows the model and serial number. Refer to the data plate on the

appliance when requesting service. The data plate is visible on the left side of the

drawer casing. It may be necessary to remove the drawer to view it.

Data Plate

@BOSCH ©

English 7

English8

Andere Handbücher für HWD27

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Sprachen:

Andere Bosch Wärmeschublade Handbücher

Bosch

Bosch HWD27 Bedienungsanleitung

Bosch

Bosch BIC510NS0 Bedienungsanleitung

Bosch

Bosch HSC140652B Bedienungsanleitung

Bosch

Bosch HWC800500 - 30 in Built Bedienungsanleitung

Bosch

Bosch BI.7101 Series Bedienungsanleitung

Bosch

Bosch HWD5051UC Bedienungsanleitung

Bosch

Bosch HWD272UC Bedienungsanleitung

Bosch

Bosch BIC510N 0 Series Bedienungsanleitung

Bosch

Bosch HSC 140 Series Bedienungsanleitung

Bosch

Bosch HWD57 Bedienungsanleitung

Bosch

Bosch HWD57 Bedienungsanleitung

Bosch

Bosch HWD Series Bedienungsanleitung

Bosch

Bosch HSC290652B Bedienungsanleitung

Bosch

Bosch BID630N 1 Series Bedienungsanleitung

Bosch

Bosch FAP-OC 500Series Bedienungsanleitung

Bosch

Bosch HWD Series Bedienungsanleitung

Bosch

Bosch BIC630N 1 Series Bedienungsanleitung

Bosch

Bosch HSC140A51 Handbuch

Bosch

Bosch BIC510N 0W Series Bedienungsanleitung

Bosch

Bosch BI.9101 Series Bedienungsanleitung

Bosch

Bosch BIC510N.0 Bedienungsanleitung

Bosch

Bosch BIC510N.0B Bedienungsanleitung

Bosch

Bosch HWD57 Bedienungsanleitung

Bosch

Bosch BIC630N 1A Series Bedienungsanleitung

Beliebte Wärmeschublade Handbücher anderer Marken

Siemens

Siemens HW 290 Series Bedienungsanleitung

Hatco

Hatco HDW-1 Montageanleitung

APW Wyott

APW Wyott WD-2CMF Bedienungsanleitung

Viking

Viking DEWD102SS Bedienungsanleitung

Miele

Miele ESW 6229 Bedienungsanleitung

Brandt

Brandt WD1014X Bedienungsanleitung

KitchenAid

KitchenAid KOWT107ESS Bedienungsanleitung

Gaggenau

Gaggenau WSP 222 Bedienungsanleitung

DCS

DCS WDI Bedienungsanleitung

Fisher & Paykel

Fisher & Paykel OR90SCG6R1 Bedienungsanleitung

Electrolux

Electrolux EED21600X Bedienungsanleitung

Fisher

Fisher PROFESSIONAL WB76SPEX1 Bedienungsanleitung

Electrolux

Electrolux EW30WD55GS Bedienungsanleitung

Hanseatic

Hanseatic TCN14J6D-S Bedienungsanleitung

Jenn-Air

Jenn-Air JWD6030CDX Bedienungsanleitung

Gaggenau

Gaggenau WS482710 Bedienungsanleitung

NEFF

NEFF N29HA11Y2 Bedienungs- und Wartungsanleitung

Fisher & Paykel

Fisher & Paykel WB60SMTB1-SET Bedienungsanleitung