Boss Audio Systems CHAOS CH3000D Bedienungsanleitung

MODEL: CH3000D

SPECIFICATIONS

Maximum power output (2 Ohms): 2200W x 1ch

RMS power Output: 1200W x 1ch

Bridged Power Output: 3000W x 1ch

Frequency response: 20 - 300Hz

S/N Ratio: 103dB

Low Pass Crossover (Variable) 20Hz-250Hz

Power Source Voltage: 14.4V

Ground: Negative

Power consumption: 25A(with 125Wx2 rated output)

External dimensions: 300(W)x65(H)x406(D)mm

- 1 -

2. Place the parts and wiring back in their original positions after replacement or

re-wiring. For proper circuit construction, use of insulation tubes, bonding, gaps to

PCB, etc, is involved. The wiring connection and routing to the PWB are specially

planned using clamps to keep away from heated and high voltage parts. Ensure that

they are placed back in their original positions after repair or inspection. If extended

damage is caused due to negligence during repair, the legal responsibility shall be

with the repairing company.

3. Check for safety after repair. Check that the screws, parts and wires are put back

securely in their original position after repair. Ensure for safety reasons there is no

possibility of secondary ploblems around the repaired spots. If extended damage is

caused due to negligence of repair, the legal responsibility shall be with the repairing

company.

4. Caution in removal and making wiring connection to the parts for the automobile.

Disconnect the battery terminal after turning the ignition key off. If wrong wiring

connections are made with the battery connected, a short circuit and/or fire may occur.

If extensive damage is caused due to negligence of repair, the legal responsibility

shall be with the repairing company.

5. Cautions regarding chips.

Do not reuse removed chips even when no abnormality is observed in their

appearance. Always replace them with new ones. (The chip parts include resistors,

capacitors, diodes, transistors, etc). The negative pole of tantalum capacitors is

highly susceptible to heat, so use special care when replacing them and check the

operation afterwards.

6. Cautions in handling flexible PCB

Before working with a soldering iron, make sure that the iron tip temperature is

around 270... Take care not to apply the iron tip repeatedly(more than three times)

to the same patterns. Also take care not to apply the tip with force.

7. Turn the unit OFF during disassembly and parts replacement. Recheck all work

before you apply power to the unit.

To engineers in charge of repair or inspection of

our products.

Before repair or inspection, make sure to follow the instructions so that customers

and Engineers in charge of repair or inspection can avoid suffering any risk or injury.

1. Use specified parts.

The system uses parts with special safety features against fire and voltage. Use only

parts with equivalent characteristics when replacing them. The use of unspecified

parts shall be regarded as remodeling for which we shall not be liable. The onus of

product liability (PL) shall not be our responsibility in cases where an accident or

failure is as a result of unspecified parts being used.

- 2 -

- 3 -

EXPLODED VEIW

- 4 -

PRINTED CIRCUIT BOARD - 1

- 5 -

CIRCUIT DIAGRAM 1

- 6 -

CIRCUIT DIAGRAM 2

- 7 -

PARTS LIST - 1

PARTS LIST - 2

- 8 -

PARTS LIST - 3

- 9 -

PARTS LIST - 4

- 10 -

Inhaltsverzeichnis

Andere Boss Audio Systems Auto-Verstärker Handbücher

Boss Audio Systems

Boss Audio Systems Diablo D1000.2 Bedienungsanleitung

Boss Audio Systems

Boss Audio Systems Havoc REV-265 Bedienungsanleitung

Boss Audio Systems

Boss Audio Systems CX150 Bedienungsanleitung

Boss Audio Systems

Boss Audio Systems CER1200M Bedienungsanleitung

Boss Audio Systems

Boss Audio Systems Blade BL3KD Bedienungsanleitung

Boss Audio Systems

Boss Audio Systems CHAOS CH1200M Bedienungsanleitung

Boss Audio Systems

Boss Audio Systems PH1500M Bedienungsanleitung

Boss Audio Systems

Boss Audio Systems Blade Extreme BLX3500M Bedienungsanleitung

Boss Audio Systems

Boss Audio Systems R2002 Bedienungsanleitung

Boss Audio Systems

Boss Audio Systems Ripper RIP D3 Bedienungsanleitung

Boss Audio Systems

Boss Audio Systems CHAOS EXXTREME CX250 Bedienungsanleitung

Boss Audio Systems

Boss Audio Systems GT1500D Bedienungsanleitung

Boss Audio Systems

Boss Audio Systems Chaos ExxtremeII CXX354M Bedienungsanleitung

Boss Audio Systems

Boss Audio Systems CLR-40 Bedienungsanleitung

Boss Audio Systems

Boss Audio Systems Riot GT1280 Bedienungsanleitung

Boss Audio Systems

Boss Audio Systems Riot GT780 Bedienungsanleitung

Boss Audio Systems

Boss Audio Systems Chaos Epic CE202 Bedienungsanleitung

Boss Audio Systems

Boss Audio Systems AR1200.2 Bedienungsanleitung

Boss Audio Systems

Boss Audio Systems Riot GT680 Bedienungsanleitung

Boss Audio Systems

Boss Audio Systems R1100M Bedienungsanleitung

Boss Audio Systems

Boss Audio Systems Blade BL1400 Bedienungsanleitung

Boss Audio Systems

Boss Audio Systems CHAOS CH1000 Bedienungsanleitung

Boss Audio Systems

Boss Audio Systems Riot GT480 Bedienungsanleitung

Boss Audio Systems

Boss Audio Systems GT1180 Bedienungsanleitung

Beliebte Auto-Verstärker Handbücher anderer Marken

Cyfre

Cyfre CHACDMA-819 Bedienungsanleitung

MTX

MTX Thunder Marine TM904 Bedienungsanleitung

MTX

MTX Thunder TA Super TA92001 Bedienungsanleitung

Lanier

Lanier 480-0239 Bedienungs- und Wartungsanleitung

Kenwood

Kenwood KAC-642 Bedienungsanleitung

Pioneer

Pioneer GM-D8500M Bedienungsanleitung

Jensen

Jensen XA4150 Bedienungsanleitung

Sony

Sony XM-405EQX Marketing Specifications Bedienungsanleitung

Audiopipe

Audiopipe AQX-660.2 Bedienungsanleitung

Clarion

Clarion APA2001 APA2001 APA2001 Kurzanleitung

Sony

Sony XM-7547 Bedienungsanleitung

Alpine

Alpine PDX11000 - Amplifier Bedienungsanleitung

Steg

Steg Qx Mos 105.4x Bedienungsanleitung

JL Audio

JL Audio HD900/5 Bedienungsanleitung

Memphis

Memphis 16-MC5.700 Bedienungsanleitung

Audiopipe

Audiopipe APSM-1150 Bedienungsanleitung

Kenwood

Kenwood KAC-PS811D Bedienungsanleitung

Fusion

Fusion CA-DA41400 Bedienungsanleitung