- 2 -
INSTALLATION OF THE APPLIANCE
Installation should always be carried out by a qualified electrician or a competent person in accordance with the
current I.E.E regulations, or the appropriate standards of your country. The supply must be done through a properly
earthed socket. The appliance must be connected to the power supply by a H05RN-F cable, correctly sized for the
unit (see the Table 1 below)
Model 447602 447603 447604
Power supply 220-240V~50/60Hz 220-240V~50/60Hz 380-415V~50/60Hz
Total power 1 x 2000W 2 x 2000W 3 x 2000W
Current 9A 18A 3 x 9A
Cable H05RN-F
(min.section) 3 x 1.5mm² 3 x 2.5mm² 5 x 1.5mm²
Table 1 (Cable minimum section – per 5 m length.)
A circuit breaker with contact separation distance of at least 3 mm must be fitted upstream from the
supply.
Be careful to connect the heater to a supply line protected by 16 A fuses (not quick-acting type).
Wall mounting using the bracket (provided)
• Make sure that the wall where you plan to mount the appliance is solid, and free of electrical cables or water pipes
inside.
• Fasten the bracket to the wall with suitable wall plugs and screws by passing through the Aholes (fig. 1).
• Use the Bholes just as reference (fig. 1).
• This heater is intended for permanent installation.
• The heater can be angled on its bracket by adjusting the C screws, each module can also be adjusted by the D
screws (fig. 2). When the adjustment has been made, tighten all the screws.
• Be sure that the heater is not facing the ceiling or inflammable substances.
Ceiling mounting with chains (not provided)
• Fasten the chains (having an appropriate length) to the ceiling, and hook them to the heater by using all the four E
holes and the “S” shaped rings enclosed inside the packaging (fig. 3 ).
• Keep the indicated distances between the heater and the wall/ceiling (fig. 1-2-3).
• Install the heater in such a way that the lamps stay horizontal.
• A safety distance of not less than 1 m should always be left in front of the heater.
• The appliance must not be located directly below, nor in front of a socket-outlet.
• Do not use the heater directly near a bathtub, a shower, or a swimming pool.
• Ensure that the power cable cannot come into contact with the reflector of the appliance and does not intrude into
the area of light flux.
The appliance is intended for indoor use only.
Keep the appliance dry and protected from dust
Ensure that there is no possibility of inflammable material, combustible
material or curtains coming into contact with the Heater, or lie near the heater.
