B+B SmartWorx EIS2-EXTEND-A Bedienungsanleitung
1-888-948-2248 | Europe: +353 91 792444
advantech-bb.com
707 Dayton Road | PO Box 1040 | Ottawa, IL 61350
Phone: 815-433-5100 | Fax: 815-433-5109
www.advantech-bb.com | E-mail: support@advantech-bb.com
Fast and easy on the web:
www.advantech-bb.com
QUICK START
GUIDE
Document Number: EIS2-EXTEND-A_QSG_1417
CAT 3 phone wire-grade cabling
CAT 5 or higher Ethernet cabling
Recommended Equipment
Troubleshooting
Included Accessories
DIN rail mount
Panel Mount
RJ-45 to RJ-11 cable
Removable Terminal Block
External AC to DC Adapter
EIS2-EXTEND-A
RJ-45 to RJ-11 cables
Removable Terminal Block
External Power Supply AC to DC
EIS2-EXTEND-A
Compact VDSL2 EXTENDERS
Before you begin--
be sure you have the following:
If there is a condition where data is not
passing the first step is to check the link
LEDs.
Next, make sure that one device is
set to Master and the other to
Remote.
Make sure the setting for duplex is the
same on both the Master and Remote.
Since line noise may be contributing data
transmission interference, check on what
VDSL2 Profile is being used, as you may
have to test the devices under
Symmetrical data rates before returning
to Asymmetrical data rates.
The cable connecting the devices may
be degraded; perform tests with new
cables in a bench test environment.
Product Overview
Set the DIP Switches
Connect the EXTENDERS
LEDS for LAN Port
LEDS for VDSL2 Port
1
2 5
3
Select the DIP Swtich settings based on the VDSL2
Profile for the Master and Remote EIS2-EXTEND-A
devices.
Ethernet Port (RJ-45): Use a straight through or
cross-over cable. CAT 5 or higher
VDSL2 Port (RJ-11): Use a CAT 3 cable
4
STEP 1：
Set the EIS2-EXTEND-A to CO
mode or CPE mode from the DIP
switch at the front panel. For Point to
Point applications, one unit must be
Master (CO mode) and the other one
is Slave (CPE mode).
STEP 2：
Connect the EIS2-EXTEND-A (CPE)
with a regular Cat. 5 cable to the
LAN port from a PC or another
device on LAN.
STEP 3：
Power on EIS2-EXTEND-A (CPE) by
connecting the power adapter.
STEP 4：
Connect the CPE and CO via a
regular Cat. 5 cable or a
telephone wire from each VDSL2
port.
STEP 5：
Connect the EIS2-EXTEND-A (CO)
with a regular Cat. 5 cable to the
LAN port and then connect the other
end of the RJ45 cable to the service
equipment.
STEP 6：
Power on EIS2-EXTEND-A (CO) by
connecting the power adapter and
then observe the status of VDSL2
link LED.
Installation Steps
Inhaltsverzeichnis
Andere B+B SmartWorx Extender Handbücher
