CONNECTION
The power supply connection of the ignition transformer
occurs by means of Stelvio 3-way connectors; the high
voltage part is connected by means of 2,8X0,5 fast-on
connectors.The following figures showthe connectors and
the wiring diagram.
TERMINALS
STOCKO: RFB7851
STELVIO: CT84
Fig. 2
Fig. 3
Some control boxes, like forexample types MT…, are
prearranged to work with one electrode only for both
ignition and flame detection.In such cases, the wiring
diagram changes as follows:
Connection diagrams
to the flame
detection input
Fig. 4
INSTALLATION
− Connect and disconnect the ignition transformer only
after switching offpower supply.
− Respect the applicable national and European
standards (e.g. EN 60355-1 /EN 50165 /EN 61558-1-
2-3) regarding electrical safety.
− Make sure the earthof the transformer and the earth of
the electrical system are well connected The device can
be mounted in any position.
− Avoid placing high voltage cables close to other cables.
− Make sure the protection degree is suitable tothe
system.
− Reduce the ignition cable length toaminimum (this
reduces stray capacitance and the possibility that the
ignition cable acts like an antenna transferring
interference to the nearby cables).
− Make ignition cables followaseparate path close to
ground planes (this reduces the influence of
interference on the remaining electrical wires).
− Arrange asingle earth centre, thus preventing earth
conductors from creating ring paths.
Connection diagrams
to the flame
detection input
Fig. 5
Via delPontiere, 31/32
37045 Legnago (VR) - ITALY
Tel. +390442 635211 - Fax+39 0442 25683 06/01/26 Subject to amendments without notice
http://www.brahma.it - E-mail: brahma@brahma.it
2/2 4485_r02
