Step 1. Connect the deector
Insert the bottom end of the segment into the groove on
the body of the vacuum pool cleaner Insert the top end
of the segment into the detaining clip adjusted to the
nosepiece. See picture 3.
Step 2. Connect the immersion controller
Fix the immersion controller into the bottom adjusting
sleeve of the U shape. Make sure that the protective
detaining latch on both sides of the immersion controller
are in the position „locking”. See picture 4.
Step 3. Fastem the weights on the hose and
t it together.
The hose of the vacuum pool cleaner is delivered in
components that must be assembled. You will need
as many components to reach the furthest part of
the pool from the point of the connection of the vacuum
pool cleaner, plus one additional piece. You will also
have to add the weights into the hose for the reason
that the hose is not oating on the water level.
The maximum weights required is assigned according
to the maximum depth of the pool. The deeper the pool
is, the more weights you will need. The number of weights
suitable for your pool is explained in the Table.
TABLE
Depth of the pool Setting of the weights
120 cm or less 1 weight: 10 to 30 cm
from the nosepiece
More than 120 cm 2 weights: the rst one 10 to 30 cm
but less than 210 cm and the second one 182 cm from
the nosepiece
more than 210 cm, 3 weights: the rst one 10 to 30 cm,
but less than 365 cm and the second one 182 cm
and the third one 305 cm from
the nosepiece
More than 365 cm 4 weights: the rst 10 to 30 cm,
the second 182 cm, the third 305 cm
and the fourth 365 cm from
the nosepiece
Detent
Terminal
latch
Folded padding
in the groove
Flat latch
Flat
latch
Picture 3
Picture 4
EN
