Britton 2Way Bedienungsanleitung
EN
ET
LT
PL
SV
DE
FI
LV
RU
Turvatool Britton 2Way kasutusjuhend
Britton 2Way Gebrauchsanleitung
Car seat Britton 2Way instructions manual
Britton 2Way käyttöohjeet
Britton 2Way
®
®
®
®
®
®
„Britton 2Way“ naudojimo instrukcija
®
®
Britton 2Way bruksanvisning
®
1
5
7
4
23
68
L
N
O
M
P
Q
A
B
C
D
E
F
H
IJ
K
G
E
O
E
O
910
11 12 13
14 15 16
17 18 19
M
I
L
click！
Q
F
20 21 22
27 28 29
23 24
26
25
I
I
E
H
33 34 35
30 31 32
36 37 38
39 40
C
J
45 46 47
41 42
43 44
belt guide
IMPORTANT: READ THESE INSTRUCTIONS CAREFULLY BEFORE USE AND KEEP THEM
FOR FUTURE REFERENCE. YOUR CHILD'S SAFETY MAY BE AFFECTED IF YOU DO NOT
FOLLOW THESE INSTRUCTIONS.
Thank you for choosing a Britton® product. Please take a little time to read the important safety
notes detailed below. This will ensure many years of happy, safe use.
This child car seat is suitable for children from birth to 25kg:
Group 0: birth to 10kg (10 months)
Group 1: 9kg (9 months) to 18kg (4 years)
Group 2: 15kg (3 years) to 25kg (7 years)
This product can only be used in vehicle that is tted with 3 point safety belt approved to ECE-
16 or the equivalent standard. Never use a 2 point safety belt.
Safety notes:
•WARNING: A CHILDS SAFETY IS YOUR RESPONSIBILITY.
•WARNING: After an accident the child car seat should be replaced.
•WARNING: NEVER use this child car seat on side facing vehicle seat.
•WARNING: NEVER use this child car seat on passenger seat fitted with active airbag.
•WARNING: NEVER leave your child unattended, even for the shortest time.
•WARNING: ALWAYS secure your child with the safety harness when using this child car seat.
•WARNING: DO NOT attempt to dismantle, modify or add to any part of the child car seat or
change the way your vehicle seat belts are made or used.
•WARNING: Any rigid items and plastic parts of the child car seat must be so located and
installed that they are not liable, during everyday use of the vehicle, to become trapped by a
movable seat or in a door of vehicle.
•WARNING: If any load bearing points other than those described in the instructions are used,
this can significantly reduce the protection factor of the child car seat.
•WARNING: DO NOT use the child car seat in the home. It has not been designed for home
use and should only be used in your car.
•This child car seat can be installed rear facing for group 0+ and forward facing for group 1+2
using a three-point lap and diagonal seat belt.
• Always make sure that the child car seat harness and vehicle belt are correctly tensioned to
ensure maximum protection for your child.
•The buckle has been designed to be released quickly in an emergency. IT IS NOT CHILD
PROOF. More inquisitive children might learn to undo the buckle. Children should be told never
to play with it or any other part of the child car seat.
• Never use any replacement parts other than those that are approved by Britton.
• The lap belt must be used well down in such a way as to properly secure the pelvis of the
child.
• Never use the child car seat without its fabric cover because the seat cover constitutes as an
integral part of the child car seat performance. The seat cover should not be replaced with any
other than the ones recommended by Britton.
• Safely secure any luggage and other objects that might cause injury to the occupant of the
child car seat in the event of a crash.
• After an accident, replace your child car seat and the vehicle seat belts. Although they may
look undamaged, they may not protect your child as well as they should.
•Britton advise that child car seats should not be brought or sold second-hand. Many seats
sold through local advertising and car-boot sales have been found to be dangerous.
• Prevent harness/vehicle belt from getting trapped between car doors or rubbing against sharp
parts of the seat or body.
• If the harness/vehicle belts becomes cut or frayed, replace it before travelling.
EN
EN
• Periodically inspect the harness of wear, paying particular attention to attachment points,
stitching and adjusting devices.
• If the vehicle has been left in the sun for a long time, check the seat cover and make sure it is
not too hot before placing the child in the child car seat.
• Security is only guaranteed if the child car seat is tted in accordance with these instructions.
• Failure to comply with the above instructions will automatically void the warranty and exempt
Britton from any liability.
• Store this car seat in a safe place when it is not being in used. Avoid placing heavy objects on
top of it. Do not allow your child car seat to contact with corrosive substances e.g. battery acid.
NOTICE:
1. This is a “Universal” child restraint .It is approved to ECE Regulation No.44.04 series of
amendments, for general use in vehicles and it will t most, but not all, car seats.
2. A correct t is likely if the vehicle manufacturer has declared in the vehicle handbook that the
vehicle is capable of accepting a “Universal” child restraint for this age group.
3. This child restraint has been classied as “Universal” under more stringent conditions as
those which applied to earlier designs which do not carry this notice.
4. lf in doubt, consult either the child restraint manufacturer or retailer.
This child restraint is only suitable if the vehicle is tted with a type approved 3 point with re-
tractor safety belt, in compliance with standard UN / ECE Regulation No.16 or other equivalent
standards.
1. LIST OF PARTS (Fig. 1)
A - Headrest
B - Backrest
C - Shoulder pads
D - Extra cushion
E - Shoulder straps
F - Harness buckle
G - Crotch pad
H - Harness adjust button
I - Recline handle
J - Adjustment strap
K - Seat base
L - Diagonal belt routing slot for Group 0
M - Reclining board
N - Shoulder strap slots
O - Metal anchor
P - Headrest adjusting button
Q - Belt clip
2. HARNESS ADJUSTMENT
Make sure that the harness is on the same height as your child’s shoulders. If in any doubt
always use the slot above the shoulder rather than below it.
However, once you reach the top slots your child may continue to use the child car seat until
their eye line is above the top of the seat shell or their weight exceeds 18Kg.
Move the shoulder strap up or down to the correct slot (Fig. 2).
Undo the shoulder straps (E) out from metal anchor (O) (Fig. 3).
Pull both shoulder pads and shoulder straps out from the slot and re-insert them into the slot
that corresponds to the height of your child shoulders. Ensure the straps are not twisted (Fig.
4).
Put shoulder straps back into the metal anchor (O) (Fig. 5).
3. ADJUSTING HEADREST
Loosen the red button on back of the headrest in counter-clockwise direction (Fig. 6).
Adjust the headrest height according to the height of your child (Fig. 7).
Tighten the headrest by turning the red button in clockwise direction (Fig. 8).
WARNING! Red button could only be placed on the rectangular groove at the top and bottom of
the headrest (Fig. 9).
4. INSTALLING THE CHILD CAR SEAT FOR GROUP 0 (from birth to 10kg)
Turn the reclining board (M) from back to front (Fig. 10).
Grip recline handle (I) at the front of the child car seat and pull the seat into its fully reclined
position. The seat must be fully reclined when facing rearwards (Fig. 11).
Place the child car seat on a passenger seat facing rearward (Fig. 12).
Put the lap belt under the extra cushion (Fig. 13).
Same time bring the diagonal belt through the belt guide (L) round the back of the seat (Fig.
14).
Check and make sure there is no twist of the belt. Insert the metal tongue of the car belt into
the car seat buckle until you hear a clear ‘click’ (Fig. 15).
Tighten the seat belt by pulling in the direction of the seat belt reel (Fig. 16).
Pull the lap and diagonal belt tightly and attach the belt clip (Q) to the diagonal section of seat
belt. Ensure it’s attached as close as possible to the seat belt buckle without touching it (Fig.
17).
WARNING: Each time you adjust the child car seat, check that it is still secure, the backrest of
the child car seat rests on the vehicles seat and that the seat belt is tight. If there is any slack in
the vehicle seat belt then retighten it before starting your journey.
5. SEATING YOUR CHILD INTO CAR SEAT FOR GROUP 0 (from birth to 10kg)
Loosen the harness by pushing the adjuster button (H) in as you pull the shoulder straps (E)
forward as much as possible (Fig. 18).
NOTE: Pull the harness UNDER the chest pads. DO NOT pull on the chest pads.
Unfasten the harness buckle by pressing the red button and releasing the shoulder straps (E)
(Fig. 19).
Place your child in the child car seat (Fig. 20).
Fit the harness around your child and fasten the harness buckle by joining the shoulder straps
(E) and pushing them both into the buckle (F) (Fig. 21).
Check that the harness is not twisted and pull the harness up to tighten the lap sections which
is designed to t low down on your child’s body.
Pull the adjuster strap (J) forward making sure the harness is a comfortable but FIRM t around
your child (Fig. 22).
Finally, pull both shoulder pads down (C) from your child’s shoulders onto their chest.
NOTE: The shoulder pads are an important safety feature. Never use the car seat without them
6. INSTALLING THE CHILD CAR SEAT FOR GROUP 1 (from 9kg to 18kg)
Grip the recline handle (I) at the front of the child car seat and push the seat into its upright
position (Fig. 23).
Turn the reclining board (M) from front to back (Fig. 24).
Place the child car seat in the forward facing position on the car seat (Pic. 25).
Insert the seat belt tongue into the slot on backrest and pass it through the back of the seat
(Fig. 26).
Check and make sure there is no twists of the belt. Plug the car seat belt tongue securely into
the carseat buckle until you hear a clear ’click’ (Fig. 15).
Tighten the seat belt by pulling in the direction of seat belt reel (Fig. 27).
Andere Handbücher für 2Way
1
Inhaltsverzeichnis
Sprachen:
Andere Britton Autositz Handbücher
