9
Vehicle star t i n g and Running
If there is a problem with the engine,press engine OFF
After running you must check the car and perform routine
Make sure linkage setup is correct before running.
Turn on transmitter first then the receiver.If you turn on
Make sure you understand all engine instructions before
attempting to start the engine. Failure to follow all
instructions can lead to damage to your vehicle, property
damage and bodily injury.
receiver first,it can cau se you to los e control the car.
maintenance.
switch to shut down the engine.
Caution
the engine.
If there is a problem with the engine,
pres s en gine off swit ch to shut down
Preparatio n f o r E ngine Start
keep the wheels off the ground
Fill Fuel Tank
Clean the dirt from ga s cap before removing .Dirt and debris
sho uld nev er get into the fue l tank. Fill the tank with fuel.
Make sur e th e ga s ca p is scr ewed on tightly b ef ore start in g
the engine.
You must use mixture of gasoline and two stroke oil as fuel
for this engine,Never use glow fuels intended for R/C cars.
C a u t i o n
Be careful not to tilt the car,gasoline may
leak from the vent hole.
Turn on the transmitter first,then turn on the receiver.
Ch e ck the thr o ttle a n d s t eeri n g f unct i on and che c k t he
rad io rang e before sta rting the engi ne,Make sure no one
is using the same frequency.
I f y o u s w i t c h o n t h e r e c e i v e r
you may lose control of the R/C
swit ch befo re the tran smitt er,
car.
Check Max.Range
push
Priming Engi n e
for the first time,if fuel appears in the yellow
To prime the engine,fill th e tank with fuel and
push t h e pr i m e r bu l b u n til f u e l a ppears i n t he
r e t u r n t u b e ( Y e l l o w ) . A f t e r t h e en g i n e r u n n i n g
return tube,you do not need to prime the engine.
Pri mer B ulb
PUSH Ret urn p ipe Out
In
Into the tubing
Turn on remote c o n t rol power
Eng ine O FF
Swi tch
PUSH
TH.TRIM
ST.TRIM
EXIT
ENT
+
-
ST.D/R
POWER
Multi Function
O N
All manuals and user guides at all-guides.com
