BV BV-BF-01 Leitfaden

bathroom VENTILAtion fan

INSTALLatiON MANUAL and USER GUIDE

90 CFM: BV-BF-01

110 CFM: BV-BF-02

CONTENTS

General Safety Information and Warnings .............................................................................

Included Parts ....................................................................................................................................

Dimensions ..........................................................................................................................................

Specications .....................................................................................................................................

Sizes........................................................................................................................................................

Wiring Diagram .................................................................................................................................

Installation I (Joist Mounting) ......................................................................................................

Installation II (In Existing Ceiling) ...............................................................................................

Maintenance ......................................................................................................................................

General safety information and warning

WARNING

Electrical service supply must be 120V 60Hz.

Follow all local safety and electrical codes as well as Canadian Electrical Code and CSST.

Always disconnect the power supply prior to servicing the fan, motor or junction box.

This unit must be properly grounded.

Do not bend or kink the power wires.

Do not install where the room air temperature will exceed 104ºF (40ºC).

This ventilation fan is approved for use in a ceiling over a bathtub or shower when installed on a ground-fault

circuit interrupter (GFCI) protected circuit. Do not use fan over a bathtub or shower that is not approved for that

application and marked accordinglyThis ventilating fan is approved for use over a bathtub or shower when

installed in a GFCI-protected circuit.

Do not use to exhaust hazardous or explosive vapors.

Do not install in a cooking area.

Use this unit in the manner intended by the manufacturer. If you have any questions, please contact BV store.

Fans should always be vented to the exterior and in complian ce with local codes. Do not vent exhaust air in

spaces within walls, ceiling, attic, crawl space or garage.

Do not use this fan with any solid state control device.

Prior to service or cleaning this unit, shut off power supply at the pa nel and lock to prevent the power from

being turned on. If the panel cannot be locked, clea rly mark the panel with a warning tag to prevent the power

from being turned on.

Duct work should be installed in a straight line with minimal bends.

Duct work size must be a minimum of the discharge and sho uld not be reduced. Reducing the duct size can

increase fan noise.

The switch should not be accessible from inside of bathtub or shower.

The fan is to be mounted at least 7 feet (2.1 m) above the oor.

INCLUDED PARTS

READ and SAVE THESE INSTRUCTIONS

Please read these instructions carefully before installing, operating or servicing the fan. Failure to comply with the

instructions contained herein could result in personal injury or property damage. We recommend that you keep this

guide for future reference.

CEILING

OPENING L

9.4”

(24 cm)

CEILING

OPENING W

9.4 ”

(24 cm)

CEILING

OPENING D

8.23 ”

(20.9 cm)

HOUSING

DIMENSION L

9 ”

(23 cm)

HOUSING

DIMENSION W

9 ”

(23 cm)

DIMENSIONS

Note: Be careful to cut the hope exactly because if it is too big, the grille will not hide it.

HOUSING

DIMENSION D

7.6 ”

(19.3 cm)

PART NAME APPERANCE QUANTITY

Grille

Long wood screws

Short screws

Suspension brackets I

Suspension brackets II

specifications

WIring diagram

AIR

DIRECTION

90 CFM

110 CFM

HZ DUCT

DIAMETER POWER SPEED

(RPM)

AIR DELIVER

AT 0.1” WG WEIGHT

120

0.8

1.2

4”

(10.16 cm)

4”

(10.16 cm)

24 W

30 W

1000

1160

90 CFM

110 CFM

9.2 lb

(4.18 kg)

9.2 lb

(4.18 kg)

NOISE

(SONE)

SIZES

FAN HOUSING

Capacitor for long

life of motor

Moíor

Black wire

120 V AC 60 Hz

to switch

to neutral

to ground

White wire

Green wire

Junction box

Automatic terminal switch

12 5/8” (32.07 cm)

9 ” (23 cm)

/16” (31 cm)

9” (23 cm)

12 5/8” (32.07 cm)

” (19.43 cm)

( 9.53 cm)

3/4” (1.9 cm)

15 1/8” (38.48 cm)

7 5/8

3/4”

INSTALLation I (joist mounting)

1. For ideal ventilation use, hold the body of the fan with

the exhaust side facing the desired duct direction.

2. Place the body of the fan in between joists in

designated area.

3. If convenient to secure unit to the joist (otherwise go

to step 4), place the unit against joist and push the fan

to the proper depth and use long screws (Fig. C).

4. Add the provided brackets (Fig. D) to the sides that are

not connected to the joists.

5. If the brackets are too short to reach

the joist, use the extensions provided (Fig. E).

6. Attach the duct to the exhaust outlet of the fan.

Secure with duct tape (Fig. F) and make sure there is

no air leak. Make sure there are no sharp bends in

the duct line (Fig. G). For 90 degrees angles,

use smooth curves or break into two smaller angles

or curves (Fig. H).

FIG. A

FIG. B

FIG. C

FIG. D

FIG. H

FIG. G

FIG. F

FIG. E

SECURE WITH DUCT TAPE

WRONG SUPPORT

RIGHT SUPPORT AND ANGLE

7. Electrical installation:

Wires from the power supply to the unit should

not be smaller than size 14 AWG. The ground wire

must be connected to the green wire in junction

box, the neutral wire to the white wire and the hot

wire to the black wire.

installation II (IN EXISTING CEILING)

1. In case there is a ventilation unit with the same dimensions in the ceiling,

proceed as follows:

• Remove the old unit;

• Check the existing duc t work and electrical wiring;

• Install the unit as des cribed in Installation I.

2. In case you want to mak e a new opening in existing ceiling:

• Find the best location for the ventilation purpose;

• Make sure that :

− the chosen place has easy access to exterior air outlet (wall cap or roof jack)

and there will not be a need for sharp angles or very lo ng duct;

− the chosen place for the duct work will not interfere with any other existing

duct work in the building;

− there is no electrical w iring or any pipes behind the chosen place;

• Open the optimal place. Be careful to cut the hole exactly. If the hole is too big,

the fan grille will not hide it;

• Make the strong support b eams for the unit (make sure it is strong enough

for the weight of the unit);

• Provide the duct syste m and electrical wiring;

• Follow the instructions on Installation I.

Ceiling

Grille

Mounting

spring

4 long screws

I-joist

maintenance

CLEANING THE FAN

Routine maintenance should be done at least once a year and should be as follows:

1. Remove cover grille;

2. Wash with lukewarm water and a mild detergent and clean the grille in a sink and dry with a cloth;

3. Remove dust and dirt from the fan housing with a vacuum cleaner;

4. Dry the body with a cloth or paper towel;

5. Replace the grille.

CAUTION

Never use solvents, thinner or harsh chemical

for cleaning the fan. Do not allow water to enter

the motor. Do not immerse resin parts in water

over 140ºF (60ºC).

LIMITED WARRANTY

This is a quality product. It was made and selected with care and BV offers a limited

one-year warranty agai nst any manufacturing defects as long as it is used according to

its intended use. BV will exchan ge any product that would show any such manufacturing

defects. However, this warranty does not include labor costs to install or remove the fan.

Vacuum

Ventilateur de salle de bains

INSTALLatiON MANUAL and USER GUIDE

90 PCM: BV-BF-01

110 PCM: BV-BF-02

Table des matières

Consignes de Sécurité et Mises en Garde ..............................................................................

Pièces Fournies ..................................................................................................................................

Dimensions ..........................................................................................................................................

Caractéristiques .................................................................................................................................

Formats .................................................................................................................................................

Schéma de Câblage..........................................................................................................................

Installation I (Sur Solive) ................................................................................................................

Installation II (Construction Existante) ......................................................................................

Entretien ...............................................................................................................................................