TROUBLE SHOOTING GUIDE CAMOS DW703W
Monitor does not turn on.
Power cord not
connected properly.
Confirm power cord in plugged into
monitor.
Confirm automotive power plug is
inserted into the vehicles +12volt socket
properly.
Confirm vehicle is supplying power to
+12V outlet where monitor is plugged in.
Inspect 2 amp fuse inside automotive
power plug. (Unscrew tip) Replace fuse
with 2 amp fuse if blown.
Monitor turns on but does
not display wireless
camera image.
Monitor may be set on
wrong video input.
Monitor has 3 video inputs. DVWS –
CAM1 –Cam2. Monitor must be set on
DVWS input. Press MODE button until
monitor displays DVWS on screen.
Monitor displays
“CHECK TX POWER”
Monitor can’t establish
Wi-Fi connection with
transmitter.
Confirm the monitor and transmitter
have matching Wi-Fi serial numbers.
They are sold together as a unique pair.
The monitor has a [Rx] sticker. The
transmitter has a [Tx] sticker.
Transmitter not
powered properly.
Red wire = +12V power
Black wire = Ground
Green wire = No used, no connection.
If transmitter has power and feels warm.
Re-boot the transmitter. Turn off
transmitter power for 10 seconds.
Antennas not
connected properly.
Check Transmitter antenna connection.
Antenna must point straight up.
Check Monitor antenna connection.
Antenna must point straight up.
Weak or No Wi-Fi
signal strength.
Monitor and transmitter are placed too
far apart and are out of Wi-Fi signal
range. Reposition transmitter closer to
monitor.
