Campbell C311 Bedienungsanleitung

Redwing105

AirLink CDMA Modem C3111

Revision: 7/06

Campbell Scientific, Inc.

Warranty and Assistance

The REDWING105 AIRLINK CDMA MODEM C3111 is warranted by

CAMPBELL SCIENTIFIC, INC. to be free from defects in materials and

workmanship under normal use and service for twelve (12) months from date

of shipment unless specified otherwise. Batteries have no warranty.

CAMPBELL SCIENTIFIC, INC.'s obligation under this warranty is limited to

repairing or replacing (at CAMPBELL SCIENTIFIC, INC.'s option) defective

products. The customer shall assume all costs of removing, reinstalling, and

shipping defective products to CAMPBELL SCIENTIFIC, INC. CAMPBELL

SCIENTIFIC, INC. will return such products by surface carrier prepaid. This

warranty shall not apply to any CAMPBELL SCIENTIFIC, INC. products

which have been subjected to modification, misuse, neglect, accidents of

nature, or shipping damage. This warranty is in lieu of all other warranties,

expressed or implied, including warranties of merchantability or fitness for a

particular purpose. CAMPBELL SCIENTIFIC, INC. is not liable for special,

indirect, incidental, or consequential damages.

Products may not be returned without prior authorization. The following

contact information is for US and International customers residing in countries

served by Campbell Scientific, Inc. directly. Affiliate companies handle

repairs for customers within their territories. Please visit

www.campbellsci.com to determine which Campbell Scientific company

serves your country. To obtain a Returned Materials Authorization (RMA),

contact CAMPBELL SCIENTIFIC, INC., phone (435) 753-2342. After an

applications engineer determines the nature of the problem, an RMA number

will be issued. Please write this number clearly on the outside of the shipping

container. CAMPBELL SCIENTIFIC's shipping address is:

CAMPBELL SCIENTIFIC, INC.

RMA#_____

815 West 1800 North

Logan, Utah 84321-1784

CAMPBELL SCIENTIFIC, INC. does not accept collect calls.

Redwing105 CDMA Table of Contents

PDF viewers note: These page numbers refer to the printed version of this document. Use

the Adobe Acrobat® bookmarks tab for links to specific sections.

1. Introduction..................................................................1

2. Specifications ..............................................................1

2.1 Base Station Requirements .......................................................................1

2.2 Datalogger Site Equipment.......................................................................1

2.3 Power Considerations ...............................................................................2

3. Configuration ...............................................................2

3.1 Establish Cellular Service.........................................................................2

3.2 Program the Modem .................................................................................2

3.3 Setup LoggerNet.......................................................................................3

Appendix

A. Configuring Modem with a Terminal Emulator..... A-1

A.1 HyperTerminal Setup.......................................................................... A-1

A.2 Programming the Redwing’s Phone Number ..................................... A-2

A.3 Programming the Redwing for Use with a Datalogger....................... A-3

This is a blank page.

Redwing105 AirLink CDMA Modem

1. Introduction

Redwing modems are full-duplex, digital cellular modems that communicate

with a base station PC via Code Division Multiple Access (CDMA) network

and Public Switched Telephone Network (PSTN). Redwing105 modems are

for use on the Alltel network only.

2. Specifications

2.1 Base Station Requirements

•PC with Hayes-compatible modem, running Campbell Scientific’s

LoggerNet or PC400 software.

•Subscription to the Alltel CDMA network with coverage at the datalogger

site.

2.2 Datalogger Site Equipment

•Redwing modem—includes power cable; the modem is configured using

CellWizard.exe

•Datalogger—CR510, CR10(X), CR23X, CR7, CR5000, or CR2XX

•SC105 or SC932A Interface—connects the modem to the CR510,

CR10(X), or CR7 dataloggers’ CS I/O port

•14392 Null Modem Cable—connects the modem to the CR23X, CR2XX,

CR1000, or CR5000 RS-232 port

•14394 Redwing Mounting Kit—includes mounting hardware for securing

the modem to below referenced environmental enclosure and a 9-pin male

to 9-pin female cable.

•Antenna—the following antennas are available from Campbell Scientific;

sites near the edge of the CDMA coverage may require the Yagi antenna.

Contact a CSI applications engineer for help in determining the best

antenna for your application.

o14453 0 dBd ½ Wave Dipole Whip Cellular Antenna

o18285 1 dBd Omnidirectional Antenna with 10' Cable

o14454 9 dBd Yagi Cellular Antenna with 10' Cable

•Power Supply (see power considerations)

•Environmental Enclosure— ENC 10/12, ENC 12/14, or ENC 16/18

Redwing105 AirLink CDMA Modem

2.3 Power Considerations

•A power cable included with the modem connects to the datalogger's 12 V

or switched 12 V terminal. Connection to the switched 12 V terminal

allows the datalogger to switch power to the modem during scheduled

transmission intervals if desired.

•When using the switched 12 V terminal, the modem can be powered with

a BP12 battery, CH100 charger/regulator, and MSX10 solar panel.

3. Configuration

3.1 Establish Cellular Service

Prior to contacting Alltel, have the following information on hand:

1. Electronic Serial Number (ESN). The ESN is found on the unit label.

2. Desired area code and local prefix. Normally, choose the same area code

and prefix as the calling PC. These will ensure that calls are billed at local

rates, even if the phone is used outside the local calling area.

Contact the provider, tell the account representative that you would like to

open an account for a new voice phone. Request a voice plan and ask that

voice mail NOT be activated. The Redwing may show up on Alltel’s network

as a MultiTech device; this is okay.

The provider will provide you with the following:

1. MDN (Mobile Directory Number). This is the number you dial.

2. MIN (Mobile Identification Number). This number identifies the Redwing

on the cellular network. This may be the same number as the MDN.

3.2 Program the Modem

Program the modem with CellWizard.exe, available from Campbell Scientific,

Inc. The appendix describes how to program the modem via a terminal

emulator; however, programming via a terminal emulator is NOT the preferred

method.

1. Connect the phone to your computer COM port.

2. Apply 12 volts to the phone. Red lead to +, black lead to -.

3. Start CellWizard.exe and select the COM port you will be using to

program the Redwing.

4. Select desired datalogger baud rate. For the CR1000 or CR5000

dataloggers, set the baud rate to 115200. For the CR10(X), CR510, CR7,

21X, or CR200 dataloggers, set the baud rate to 9600. For the CR23X

datalogger, set the baud rate to 38400.

Redwing105 AirLink CDMA Modem

5. Enter the MDN.

6. Enter the MIN.

7. Press the “Start” button to program the phone.

3.3 Setup LoggerNet

1. Select Add Root | TapiPort.

2. Add a TapiRemote to the TapiPort.

3. Add a datalogger to the TapiRemote.

4. On the TapiPort page, select your installed modem on the Tapi Line.

5. On the TapiRemote un-check “Use Tapi Dialing Properties.“

6. Enter the phone number of the CDMA phone.

7. Apply the changes and test.

If you have a black SC12 cable, that is not Rev 1 or newer, it is a

CS I/O cable only and will not work for RS-232. Connect the

black SC12 cable between the datalogger and the SC932A. Use

a 9-pin serial cable or a blue ribbon cable between the phone and

the SC932A.

NOTE

Redwing105 AirLink CDMA Modem

This is a blank page.

A-1

Appendix A. Configuring Modem with a

Terminal Emulator

Programming the modem with a terminal emulator is not

recommended. Please first attempt programming with the

CellWizard.exe program available from Campbell Scientific, Inc.

Items needed:

•Computer with a COM port.

•9-pin cable to connect between the computer and the Redwing.

•A terminal program on the computer “HyperTerminal”.

•12 volt DC applied to the Redwing.

•Antenna on the Redwing (for over-the-air updates).

•CDMA account.

A.1 HyperTerminal Setup

Under “Connect using”, select the COM port you will be using.

Set COM Properties to:

Bits per second (baud) = 115200

Data bits = 8

Parity = None

Stop bits = 1

Flow control = None

NOTE

Appendix A. Configuring Modem with a Terminal Emulator

A-2

Apply power to the modem and connect it to the computer via the 9-pin serial

cable.

A.2 Programming the Redwing’s Phone Number

Your provider should give you two numbers to program into the Redwing, the

MDN (Mobile Directory Number) and MIN (Mobile Identification Number).

Perform the following steps substituting the MDN and MIN with yours.

AT Commands to be typed are in bold. Follow each AT command string by

pressing the Enter key and verify the response.

Step AT Commands Response Description

1 AT+WSPC=1,000000 OK Unlocks the module for service

provisioning AT commands.

AT+WMDN=[MDN]

Example:

AT+WMDN=4352551212

Enter the MDN here. The MDN is

the number used to dial this device.

AT+WIMI=31000[MIN]

Example:

AT+WIMI=310004352551234

Enter the MIN here. The 31000

must precede the MIN. The MIN

is the number used to identify this

device on the cellular provider’s

network. This number may be the

same as the MDN.

OK Commits the changes done during

the service programming session.

4 AT+WCMT=1

+WIND:8

Commission of these changes will

force a software reset of the

module.

5 AT+CDV*22890

+WORG:*22890

+WCNT:3

+WOT1:”Programming in progress”

+WOTS:”SPL unlocked”

+WOTP:”PRL Download OK”

+WOTM:”MDM Download OK”

+WOTC:”Commit Successful”

+WOT2:”Programming Successful!”

Initiates over-the-air update. You

must have cellular coverage with

good signal strength for this to be

successful.

There are no O’s in the above strings, they are Zero’s.

NOTE

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Campbell Modem Handbücher

Campbell

Campbell COM300 Bedienungsanleitung

Campbell

Campbell COM220 Bedienungsanleitung

Campbell

Campbell 4GMini Bedienungsanleitung

Campbell

Campbell DC112 Bedienungsanleitung

Campbell

Campbell CS-GSM/GPRS Bedienungsanleitung

Campbell

Campbell RavenXTG GPRS/EDGE Bedienungsanleitung

Campbell

Campbell DCP-Intelimax Bedienungsanleitung

Campbell

Campbell Sierra Wireless AirLink RV50 Bedienungsanleitung

Campbell

Campbell 9522B Bedienungsanleitung

Campbell

Campbell Airlink Raven Bedienungsanleitung

Campbell

Campbell Raven110 Bedienungsanleitung

Campbell

Campbell LS300G-EU Bedienungsanleitung

Campbell

Campbell COM9602 Bedienungsanleitung

Campbell

Campbell DCSCOM Bedienungsanleitung

Campbell

Campbell COM110 Betriebsanleitung

Campbell

Campbell RF401 Bedienungsanleitung

Campbell

Campbell 9522B Bedienungsanleitung

Campbell

Campbell LS300G Bedienungsanleitung

Campbell

Campbell Raven XT-Telus Bedienungsanleitung

Campbell

Campbell Raven100 Bedienungsanleitung

Campbell

Campbell Sierra Wireless AirLink RV50 Bedienungsanleitung

Campbell

Campbell Sierra Wireless RavenXTV Bedienungsanleitung

Campbell

Campbell COM320 Bedienungsanleitung

Campbell

Campbell R410 Bedienungsanleitung

Beliebte Modem Handbücher anderer Marken

Davicom

Davicom DM562AP Bedienungsanleitung

EpiValley

EpiValley TATA indicom SXC-1080 Bedienungsanleitung

Zte

Zte WiMAX Bedienungsanleitung

Intelimax

Intelimax MA-2060 Bedienungsanleitung

SMC Networks

SMC Networks D3CM1604V Gebrauchs- und Pflegehandbuch

Telstra

Telstra Wi-Fi 4G Advanced Pro X Bedienungsanleitung

Thrane&Thrane

Thrane&Thrane imarsat EXPLORER 300 Bedienungsanleitung

Samsung

Samsung AceLink SAM-335A Bedienungsanleitung

Enfora

Enfora Enabler-G Kurzanleitung zur Einrichtung

iRZ

iRZ ATM2-232 Bedienungsanleitung

Zhone

Zhone 6310 Bedienungsanleitung

Paradyne

Paradyne Hotwire 7976 Bedienungsanleitung

US Robotics

US Robotics 3453C Bedienungsanleitung

MaxTech

MaxTech Plug & Play Internal Voice/FAX/Data/SVD... Bedienungsanleitung

Zte

Zte MF823 Bedienungsanleitung

Four-Faith

Four-Faith F1403 Bedienungsanleitung

Sierra Wireless

Sierra Wireless AIRLINK MP595W Bedienungsanleitung

Gemtek

Gemtek WiMAX WIXFBR-103 Bedienungsanleitung