CanadianSolar HiKu7 Bedienungsanleitung

LEADING THE NEW ERA OF

600W+ MODULES

CANADIAN SOLAR

HiKu7 & BiHiKu7

UNPACKING INSTRUCTIONS

HiKu7 & BiHiKu7 –UP TO 670 W

Canadian Solar Inc.

Special instructions before unpacking

Step

CS7N & CS7L modules are packed vertically using an innovative packaging

system. Please pay special attention：

1) For the roof projects: it is not allowed to carry the whole original

package onto the roof. Please unpack the pallet, pick the module out

one by one and then can carry them to the roof horizontally by the

plans A or B shown as below, or other plans which ensure modules

safe .

×√ √

Plan A Plan B

2) For all kinds of projects: it is recommended to strictly abide the unpacking

steps as follows.

Place pallets on flat ground

Step

CS7N & CS7L modules are packed vertically using an innovative packaging system.

Please place pallets on flat ground. The inclination of the ground should not exceed 4°.

Unpack with anti-tipping bracket when the inclination is 0°＜Angle ≤ 4 °

Flat ground Inclination＞4°

√×

Support with wooden

bracket

＋

Place the pallet in right direction

（the lower wooden fence

leaning downwards）

×√

＝

Anti-tipping group

onsite picture

Please place the pallets in the right direction (shown as below) and use an anti-tipping system to

ensure the safety of the modules. Please check the details in appendix 01.

Anti-tipping

system

Appendix

Step

Two wooden beams are needed to assemble the overturning protection. After carefully unpacking the first

two pallets on a flat ground, two wooden brackets/beams will remain.

2 pallets of modules 2 wooden beams

Assembly process:

Insert bracket 1 into bracket 2. The anti-tipping bracket

is ready

Simple anti-tipping beams making process

121

One of the leftover wooden

brackets remains in the original

direction while the other needs to

be turned 90°.

2 wooden beams

1) 2)

Tear off the box shrink-wrap film

Step

Remove outer packaging straps

Step

Tear off all the shrink-wrap film covering the box

Attention：

•Please wear gloves to prevent injuries.

•Please remove the shrink-wrap film with care

and avoid pulling with excessive force.

•Unpacking operation shall not be carried out

over wind force 6 (Strong Breeze, 10.8-13.8

m/s).

Cut off the packing straps on the outside of the packing box, except the last 2 on the bottom.

Attention：

•Please wear gloves to prevent injuries.

•Please make sure the bottom two straps

remain uncut.

•Please pay attention when cutting off the

straps to avoid it from springing back to

avoid personal injury.

Do not remove!

Remove the upper wooden beams and box top

cover

Step

The wooden edge protection is divided into two parts: upper and lower. Please remove the upper

wood edge protection, keep the lower wood edge protection, and then remove the top cardboard

box cover.

Attention：

•Please wear gloves to prevent injuries.

•Please note the wood edge protection is

heavy. Refrain from letting it fall to the

ground directly to avoid personal injury.

•It is recommended to remove the top

cover with the help of one of the

wooden brackets.

Remove the upper carton

Step

CS7N & CS7L products packaging uses a one-piece enclosure with a pre-cut line design. Please tear

off the box along the pre-cut line and take off the upper part of the carton.

Appearance after removing

the upper carton

Tear the package

along the pre-cut line

The starting point

Pre-cut line on package

front view side view

Top

Bottom

Remove the inner packing straps

Step

Cut off all straps inside the package, including the bottom belt hidden by the box. Do NOT remove

the 2 straps on the outside of the packaging.

Attention：

•Please wear gloves to prevent injuries.

•The lower cardboard can be removed. Behind

it packing straps appear at the bottom. “

Do not remove!

Step

07 Tear off the anti-tipping tape: one by one

CS7N & CS7L module packaging comes along with an ultra-high viscosity tape on both sides to

prevent the modules from falling while being unpacked.

Please remove the adhesive tape one by one so that only one module can be removed at a time

before removing the tape from the next module.

Attention：

•Please wear gloves to prevent injuries.

•Please tear the tape to take only one module

out at a time. Do not tear the tape on the

next piece of module

Take out the modules: one by one

Step

Two workers are required to take modules out of the box. When handling modules always use

both hands.

Attention:

•Please wear gloves to prevent injuries.

•It is recommended that two workers take out the modules from both sides of the

packaging at the same time.

•The module packaging is tight. Please move the first module from left and right parallel

to the short side of the module, pulling up while you move, carefully take out the first

module.

•Need people to support the unpacking modules during the whole process.

•Before taking out the last module, please cut off the two anti-tipping nylon tie between

the installation hole and wooden beams.

•Please install the modules right after unpacking. and install the modules in one time

once opening the package. Do not leave a few pieces in the packing box for a long time.

•Sort out the empty packaging, separating the different materials for proper recycling.

Take out the modules: one by one

Step

Pallet

If the whole package cannot be completed installation till end of

the day, the remaining modules can be temporarily placed in the

following ways:

Bottom module placed

on the pallets

Jointed by two pallets

Two wooden pallets can be jointed as below, and carton can be padded above. Place the modules

horizontally on the pallets. Please make sure the bottom module’s front side is looking upwards, and the

rest of the modules’ back side downward. The number of stacked modules should be less than 12.

You can also order special pallet for 210 products for better transportation experience.

For rooftop projects, if you need pallet to transport the modules to the roof, you need order special

pallet for 210 products .

Scan to see how HiKu7 and BiHiKu7 modules

are made and tested on YouTube

Facebook Instagram LinkedIn Twitter

LEARN MORE

CSI Solar Co., Ltd.

www.csisolar.com [email protected]

Leading The New Era of 600W+ Modules

Canadian Solar HiKu7 & BiHiKu7 Unpacking Instruction

•Please take photos and contact the local sales/customer service staff at first time if you

encounter with damaged package or modules, and feedback to the service mailbox,

[email protected] , thanks!

•If the customer does not unpack the module according to the steps specified in this manual, we

shall not assume any responsibility for the personal and property damage.

Damaged package Damaged module

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere CanadianSolar Solarpanel Handbücher

CanadianSolar

CanadianSolar CS Series Bedienungsanleitung

CanadianSolar

CanadianSolar CS3U-MS-FG Bedienungsanleitung

CanadianSolar

CanadianSolar CS3U-MB-FG Bedienungsanleitung

CanadianSolar

CanadianSolar CS5AH Bedienungsanleitung

CanadianSolar

CanadianSolar CS6L-MS Bedienungsanleitung

CanadianSolar

CanadianSolar CS Series Bedienungsanleitung

CanadianSolar

CanadianSolar BiHiKu6 Mono CS6Y-550MB-AG Bedienungsanleitung

CanadianSolar

CanadianSolar CS3U-MB-FG Bedienungsanleitung

CanadianSolar

CanadianSolar CS3U-P Bedienungsanleitung

CanadianSolar

CanadianSolar CS6K-245P-AG Bedienungsanleitung

CanadianSolar

CanadianSolar CS6R-MS Series Bedienungsanleitung

CanadianSolar

CanadianSolar CS Series Bedienungsanleitung

CanadianSolar

CanadianSolar CS3W-PB-AG Series Bedienungsanleitung

CanadianSolar

CanadianSolar CS5AH-180M Bedienungsanleitung

CanadianSolar

CanadianSolar CS6P-PE Bedienungsanleitung

CanadianSolar

CanadianSolar CSFDC-20-1218A1 Bedienungsanleitung

CanadianSolar

CanadianSolar CS6A-P Bedienungsanleitung

CanadianSolar

CanadianSolar CS6P-245M Bedienungsanleitung

CanadianSolar

CanadianSolar CS Series Bedienungsanleitung

CanadianSolar

CanadianSolar Dymond CS6K-245P-FG Bedienungsanleitung

CanadianSolar

CanadianSolar CS1V-MS Bedienungsanleitung

CanadianSolar

CanadianSolar CS6R-MB-AG Bedienungsanleitung

CanadianSolar

CanadianSolar CS3U-350MB-AG Bedienungsanleitung

CanadianSolar

CanadianSolar CS6K-275P Bedienungsanleitung

Beliebte Solarpanel Handbücher anderer Marken

Navitron

Navitron HFC-2 Bedienungsanleitung

AXITEC

AXITEC 60-CELL Bedienungsanleitung

thermital

thermital TSOL 20 N BLU Bedienungsanleitung

AZO Digital

AZO Digital MPPT-3000 Bedienungsanleitung

Clenergy

Clenergy PV-ezRack SolarTripod Bedienungsanleitung

Beretta

Beretta SCF-20N Bedienungsanleitung

moovo

moovo KSM001 Produkthandbuch

solarwatt

solarwatt EasyIn 60M Series Bedienungsanleitung

Solarland

Solarland Portable Series Handbuch

Ubiquiti

Ubiquiti sunMAX Bedienungsanleitung

Lippert

Lippert Furrion FSFP37MW-BL Bedienungsanleitung

Sonnenkraft

Sonnenkraft GK5-HP Bedienungsanleitung

REC

REC TwinPeak 2S Mono 72 Series Bedienungsanleitung

Sunforce

Sunforce 50039 Bedienungsanleitung

Flexsolar

Flexsolar C100 Leitfaden

Süd Solar

Süd Solar 03005 Bedienungsanleitung

Kodak

Kodak SP21 Bedienungsanleitung

Carmanah

Carmanah Go Power! Solar Flex GP-FLEX-30 Bedienungsanleitung