WARNING:TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO
PERSONS, OBSERVE THE FOLLOWING:
A. Use this unit only in the manner intended by the manufacturer. If you have questions,
contact the manufacturer at 866-402-4600.
B. Before servicing or cleaning the unit, switch power off at service panel and lock the
service disconnecting means to prevent power from being switched on accidentally.
When the service disconnecting means cannot be locked, securely fasten a prominent
warning device, such as a tag, to the service panel.
C. Installation work and Electrical Wiring must be done by qualified person(s) in accordance
with all applicable codes and standards, including fire rated construction.
D. Sufficient air is needed for proper combustion and exhausting of gases through the flue
(chimney) of fuel burning equipment to prevent back drafting. Follow the heating
equipment manufacturer’s guideline and safety standards such as those published by the
National Fire Protection Association (NFPA), and the American Society for Heating,
Refrigeration and Air Conditioning Engineers (ASHRAE), and the local code authorities.
E. When cutting or drilling into wall or ceiling, do not damage electrical wiring and other
hidden utilities.
F. Ducted fans must always be vented to the outdoors.
CAUTION: Reduce the risk of fire and to properly exhaust air, be sure to duct air to
outside. Do not vent exhaust air into spaces within walls or ceiling, nor into attics, crawl
spaces, or garages.
Note: Unit must be vented to the outside of the building.
WARNING!: To reduce the risk of electrical shock or injury to persons, all Vent Hoods
must be installed with ventilators that have been approved for use with the hood.
WARNING! – If the information in this manual is not followed exactly, a fire or
explosion may result causing property damage, personal injury or death. Do not
store or use gasoline or other flammable vapors or liquids in the vicinity of this or
any other appliance.
SAFETY WARNING! – Turn off power circuit at service panel and lock out panel,
before wiring this appliance. Requirement: 120V AC, 60 HZ. 15 A Branch Circuit
FOR YOUR SAFETY!
If You Smell Gas:
•Do not try to light any appliance.
•Do not touch any electrical switch; do not use any phone in your
building.
•Immediately call your gas supplier from a neighbor’s phone. Follow
the gas supplier’s instructions.
•If you cannot reach your gas supplier, call the fire department.
•Installation and service must be performed by a qualified installer,
service agency or the gas supplier.
4
