Caple C711G Bedienungsanleitung
2
Installation Requirements................ ........................................................................3
Installation ...............................................................................................................4
How To Use Your Gas Hob ............................ ......................................................6
Your Guarantee ..................... .................................................................................8
Thank you for buying your new CAPLE Gas Hob. To ensure that you get the best
results from your new CAPLE Gas Hob, we strongly suggest that you read this
instruction manual thoroughly before use. This manual contains installation advice,
usage instructions and a cleaning guide, as well as other important facts about your
CAPLE Gas Hob. If treated with care, your CAPLE Gas Hob should give you years
of trouble-free cooking.
For Spare Parts, Technical Advice
or Product Service call the
CAPLE HELPLINE on 0870 241 1142
(Answerphone outside office hours)
Contents
Technical Information
Total absorbed power 8.05 kW
Rapid burner (1 ) 3.05 kW
Rapid burner (2) 2.40 kW
Semi rapid burner 1.60 kW
Auxiliary burner 1.00 kW
Voltage 230 V Single phase
Cat. I2H - Class 3
The CE marking confirms that the appliance conforms to the following EU directives:
- safety requirements of the “Gas” Directive 90/396/EEC;
- safety requirements of EEC Directive “Low voltage” 73/23;
- protection requirements of EEC Directive “EMC” 89/336;
- requirements of EEC Directive 93/68.
3
Electrical Installation
This appliance must be connected by a
qualified electrician using fixed wiring via
a double pole isolating switch (fig. 1).
As the colours of the wires in the mains
lead for the appliance, may not corre-
spond with the coloured markings iden-
tifying the terminals in your spur box,
proceed as follows:
1) The wire which is coloured green
and yellow must be connected to
the terminal marked E(Earth)
or coloured Green.
FUSE
DOUBLE POLE SWITCHED
FUSED SPUR OUTLET
USE A 3 AMP FUSE
ON
Fig. 1
2) The wire which is coloured blue must
be connected to the terminal marked
N(Neutral), or coloured Black.
3) The wire which is coloured brown
must be connected to the terminal
marked L(Live), or coloured Red.
WARNING!
ELECTRICITY CAN BE
EXTREMELY DANGEROUS.
THIS APPLIANCE MUST BE
EARTHED.
Gas installation
This appliance should be fitted by a
C.O.R.G.I. registered fitter.
The installation must comply with Gas
Safety (installation and use) Regulations
1994.
It is illegal to provide any assistance in
the installation of gas appliance except
to C.O.R.G.I registered installers.
Any C.O.R.G.I registered fitter requiring
help must provide name, address and
registration number. Information supplied
will be validated before help is provided.
This appliance is predisposed and
adjusted to operate with Natural Gas at
20 mbar.
BURNERS
Auxiliary (A) 1,00 0,32 40 65*
Semi-rapid (SR) 1,60 0,39 43 85*
Rapid (R2) 2,40 0,58 55 110*
Rapid (R1) 3,05 0,67 60 115 (.15*)
Nominal
input [kW] Reduced
input [kW] By-pass
[1/100 mm] Ø injector
[1/100 mm]
Natural Gas - 20 mbar
*= Injector brand
INJECTORS TABLE
GB
Cat: I2H
Installation Requirements
4
Take care not to lose or
mishandle any parts when
unpacking the appliance.
Positioning the appliance
The hob must be installed a
minimum of 50 mm from the
back wall and 150 mm from any
vertical surface either side of the
hob.
Adjacent units must be a
minimum of 366 mm above
the worksurface.
If you are installing a cooker
hood above the hob there
must be a minimum height of
750 mm between the
appliance.
If a cooker hood is not installed,
there must be a minimum
height of 900 mm between
cabinets above the hob.
This hob must not be installed
above refrigeration products.
750 mm
Cooker hood
Cabinet only
(without
cooker hood)
900 mm
366 mm
Fig. 2
Ventilation
All rooms require a window which can be opened or equivalent, while some rooms requi-
re a permanent vent in addition to a window.
This unit must not be used in a room with less than 5 m3.
Room Volume Air vent necessary (effective area)
5 m3100 cm2
5 m3to 10 m350 cm2
Greater than 11 m3No air vent necessary
A room 5 m3to 10 m3with a door No permanent air vent necessary
opening to the outside
The above requirements allow use of a gas oven and grill but if there are other fuel
burning appliances in the same room BS5440 part 2: 1989 (ventilation) should be
consulted to determine the necessary air venting requirements.
Installation
5
1. The hob requires a space in the kitchen work surface as shown in fig 3.
2. Apply the adhesive seal around the edge of the hob, making sure that the ends do
not overlap or leave a space (fig. 4).
3. Attach the hob to the worktop using the brackets supplied as indicated in figure 5.
4. Tighten carefully.
NOTE: A partition between the base of the hob and the cupboard below should be
fitted 100 mm below the worktop if the cupboard is to be used for storage.
Never place perishable foods in the cupboard below the hob.
560
580
500
480
50
;;;
;;;;;;;;;
;;;;;;;;;
20 mm min.
40 mm max.
Fig. 5
Fig. 3
Fig. 4
C
B
A
Adhesive
side
Installation
6
3 4
21
8
7
6
5
9
Fig. 6
BURNERS
1. Auxiliary burner
2. Rapid burner (R1)
3. Semi-rapid burner (SR)
3. Rapid burner (R2)
CONTROL PANEL
5. Burner 1 (A) control knob
6. Burner 2 (R1) control knob
7. Burner 3 (SR) control knob
8. Burner 4 (R2) control knob
9. Electrical ignition push button
How to use your gas hob
– Check that the electricity is switched on to allow spark ignition.
– Make sure that all controls are turned to zero.
– The gas flow to the burner is controlled by a knob operating on a safety tap. You
control the flow by turning the knob indicator to line up with the following symbols:
symbol ●: Off
symbol : Maximum
symbol : Minimum
– To ignite, simply push the required knob down and turn it to maximum, then press
ignition continuously until the burner lights.
When the flame is lit, you can control the temperature with the control knob.
– To switch off, turn the knob clockwise until you hear the safety click.
– Please note that, if you are using a burner at the minimum setting, you turn the knob
clockwise past the maximum setting before reaching the off position.
7
Cooking hints
The burners are different sizes, and can
be used in different ways; the largest for
boiling, to seal meat or foods that are
cooked quickly and the smallest for
stews and sauces.
Always ensure that you use the correct
size of saucepan.
For fast boiling, make sure that the
flame just reaches the edge of the pan.
Flames going up the side of the pan
means wasted heat and the contents
of the pan will take longer to boil.
Cleaning your hob
Your gas hob has an enamelled finish, so you should use a non-abrasive cleaner.
An abrasive cleaner will scratch the surface and could erase the control markings.
Cream cleaners may clog the holes in the burners. When cleaning, ensure that these
holes are kept clean and free from debris. Failure to do so will result in poor flame
pattem and possible scorching of cooking utensils.
Remember to let the hob cool down before you clean it.
Troubleshooting
If you acquire a problem with your hob, check the following points before calling an
engineer.
1. The power is switched on.
2. The controls are switched on.
3. Both the fuse and the mains fuse are intact.
4. The gas supply is connected to the appliance.
Should you still require an engineer then call the CAPLE Helpline on 0870 241 1142.
Fig. 7
How to use your gas hob
Cod. 1101800
CAPLE “Built-in” Service
Should you require service at any time,
please contact the Caple Helpline on
0870 241 1142.
Caple have a nationwide service
network of engineers who will respond
quickly to your call.
YOUR GUARANTEE
CAPLE guarantees all parts of this product for one year from the date of pur-
chase. During that time, should it become necessary CAPLE engineers will
replace or repair all defective parts free of charge, except for parts subject to
fair wear and tear, such as lightbulbs.
Parts and the engineers labour costs are chargeable after the first 12 months.
To qualify for benefits under the guarantee, you must be able to provide proof
of date of purchase and the appliance must have been supplied, installed and
used for domestic purposes only in accordance with CAPLE instructions.
Consequential losses and accidental damage to the product are not covered
by the guarantee.
This guarantee does not affect your statutory or common law rights.
CAPLE cannot be responsible for the results of using this appliance for any
other purposes other than those described in these instructions.
Always replace spare parts with gen-
uine Caple spares. These are available
from authorised Caple Service
Centres or by mail order from our
National Service Stores, simply tele-
phone 0870 241 1142.
When ordering parts always quote the
model number and serial number of
your appliance.
ß2
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Andere Caple Kochfeld Handbücher
Caple
Caple C762GSS Bedienungsanleitung
Caple
Caple C891C Bedienungsanleitung
Caple
Caple C840i Bedienungsanleitung
Caple
Caple C775G Bedienungsanleitung
Caple
Caple C 611 E/GRN Bedienungsanleitung
Caple
Caple C864I Bedienungsanleitung
Caple
Caple C8301C Bedienungsanleitung
Caple
Caple C876I Bedienungsanleitung
Caple
Caple C896IBK Handbuch
Caple
Caple C602E Bedienungsanleitung
Caple
Caple C743G Bedienungsanleitung
Caple
Caple C761G Bedienungsanleitung
Caple
Caple C7591G Bedienungsanleitung
Caple
Caple C8241C Bedienungsanleitung
Caple
Caple C748G Bedienungsanleitung
Caple
Caple C851i Bedienungsanleitung
Caple
Caple C702G Bedienungs- und Sicherheitshinweise
Caple
Caple C806C Handbuch
Caple
Caple C808C Bedienungsanleitung
Caple
Caple C742G Bedienungsanleitung
