Caple WC6216 Handbuch

WC6216

Caple 60cm in-column wine cabinet

Technical information

Item Part Code Description Qty

1DG2-14 Power cord 1

2DG22-476 support bar of tank water 2

3DG13-447 water box 1

DG1-77 Compressor 1

B40-120/B 1

QP2-12/B 1

5DG3-206 PCB board 1

6DG6-7 Transformer 1

7DG11-41 Condenser 1

8DG26-137 Cabinet 1

9DG13-268 Decorative nail 3

10 DG13-473 limiting bar(B) 1

11 DG13-472 limiting bar(A) 1

12 DG14-206 Top hinge module 1

13 DG121AEvaporator 1

14 DG12-6.1 Air-circulating pipe 1

15 DG13-7 Shelf support 1

DG20-1 Wire clamp 1

DG8-8 senser 1

17 DG7-3.1-BH Evaporator fan 1

18 DG22-498 Air duct board 1

19 DG22-499 Upper panel for air-leaded board 1

20 DG22-3000 middle airway-board 1

21 DG18-98 Foam 1

22 DG13-469 Display support 1

23 DG20-261 Display panel 1

DG15-205-1 Wooden shelves 1

DG15-205 Wooden shelves 4

25 DG13-1.2 Humid box 1

26 DG23-210 doo

27 M147-005 gasket 1

28 DG22-3027 handle 1

29 DG13-3005 magnet 2

30 DG15-206 Wooden shelves 1

31 DG13-198 senser cover 2

32 DG8-8 senser 1

33 DG22-500 lower panel for air-leaded board 1

34 DG8-8 sense

WC6216 - Caple 60cm in-column wine cabinet

Item Part Code Description Qty

WC6216 - Caple 60cm in-column wine cabinet

35 DG7-33-BH fan 1

36 DG7-41-BH PTC heater fan 1

37 DG14-207 Lower hinge module 1

38 DG13-475 Reed switch 1

39 DG22-3014 Lid of reed switch 1

40 DG13-474 support bar 2

41 DG22-3005 Electrical box cove 1

42 DG22-473 strengthening board 1

43 DG3-13-W LED light 1

44 DG13-129 LED light cover 1

45 DG11-18 PTC heater 1

46 DG3-18-W LED Light 1

47 DG11-4 Drie

DG13-3031 Hinge pin clip/cover

DG22-475 Hinge pin

Computer Controlled Wine Cellar

WC6215 WC6216

Service Manual

Here below we listed various faults while using the wine cellar, and the method of check-up and solve these

default, and find the information of the correspondent page.

Statement: (Fig.4 ) shows the reference figure Fig4

( →6.1.6 ) shows the reference item 6.1.6.

Warning: before attempting any cleaning or maintenance this unit MUST be disconnected from the

electrical supply, to prevent electrical shock

▲Preparation before maintenance

○Tools

1．Pliers 2．Phillips head screwdrivers

3．Process pipe 4．Electrical Multi meter

5．Amp meter (5A) (caliper cable type) 6．Electrical soldering iron

7．Wire strippers 8．Seal pliers

○Equipment

1．Vacuum pump 2．Soldering iron for copper pipes 3.Refrigerant meter

1. Safety rules on operation of repairing. (Rules must be

obeyed).——————————————————————— 2

2. Electrical circuit diagram. ———————————— 4

3. Cooling system diagram. —————————————— 5

4. Name and function on control panel. ———————— 5

5. How to diagnose the fault. （E1、E2、E3、E4） ——— 6

6. Gist on disassembly. ———————————————— 9

7. How to maintain the default. ———————————— 19

1. Safety rules on operation of repairing (Rules must be obeyed).

To avoid the accident during maintain the wine cooler, and make sure the product is safety, rules

must be obeyed list below.

○ Below we list the symbols and explain the danger if ignore it.

Danger This symbol means that the instance may have the chance to suffer

death or a serious wound.

Warning This symbol means that the instance may have the chance to suffer

death or a serious wound.’

Notice This symbol means that the instance may have the chance to suffer

a wound.’

○Below symbols’ distinguish and rules should be obeyed.

This symbol means the

instance hope to be noticed

This symbol means the

instance must be done forcibly

This symbol means the

instance forbidden

Danger

·Please make sure to discharge the rest refrigerant in the parts.

·When discharging refrigerant, make sure that it never go to the fire place and drain

to outdoors.

Tell the customers that they never close to the discharge place and the fire is

forbidden.

·Take apart the pipe by cutter.

Never take apart the part by soldering, otherwise it will fire the rest refrigerant in the

systems and cause blast.

·Exhaust the rest refrigerant in the systems before welding.

·After filling the refrigerant the sealing should be done by using smithing welding

nozzle.

Using the welding machine will fire the refrigerant and blast.

·Since the R600a is heavier than the air, please let the R600a on the ground go

especially for the hypogeum.

·The operation on the servicing refrigerant bottle should be done in place without fire

and outdoors.

·Use the refrigerant warner please， as the rest refrigerant will cause the fire.

·Don’t use fire in the place with rest refrigerant.

·Don’t place the default compressor in indoor.

Danger

·During repairing, the power plug should be disconnected.

Before remove, install, replace parts disconnect the power plug.

·Attention don’t get electric shock.

When checking current, voltage or charging never touch the connectors.

When changing the parts, don’t touch the charged parts within three minutes after

disconnect the plug.

The capacitor will discharge for some time.

·Don’t damage the cooling pipe, sine the refrigerant is flammable, the damage will

cause the fire or blast.

·Don’t smoking in the service car.

·Discharge the refrigerant entirely in the place without fire before disusing the

refrigerant bottle.

·Don’t touch the wine cooler when the cooling pipe damaged, don’t fie inside the wine

cooler, keep the windows open to exchange the air.

·Disusing the default compressor should be done outdoor without fire.

·The maximum weight of the refrigerant bottle loaded in the vehicle should be comply

to stated, the bottle should be place upright, the maximum leaning angle is 40°.

·Do use the appointed part, otherwise it have chance to smoke fire or default.

·Please put the default compressor into plastic bag and seal the peristome, then pack

it with strip, as the rest compressor oil may leak in the vehicle and cause fire or blast.

·Check if all the snails, parts, wiring are install in it’s place, if the area around the

service part worsen.

When measuring the grounding resistance make sure that the test range is more than

1MΩ.

Make sure the power cord and plug never be pinched on rear of the wine cooler.

Exchange the power cord when it damaged.

Clean the flake of the plug when it dirty.

Andere Handbücher für WC6216

Inhaltsverzeichnis

Andere Caple Weinkühler Handbücher

Beliebte Weinkühler Handbücher anderer Marken

U-Line

U-Line Echelon Wine Captain 2075WC Betriebsanleitung

Haier

Haier WS50GA Bedienungsanleitung

Cavist

Cavist 62 Bedienungsanleitung

Kenmore

Kenmore 461.99130 Bedienungsanleitung

Miele

Miele KWT 6422 iG Bedienungsanleitung

Danby

Danby DWC113BLSDB Bedienungsanleitung

Avanti

Avanti WC1001 Bedienungsanleitung

Frigidaire

Frigidaire FFWC38F6LS Bedienungsanleitung

Titan

Titan TT-W2454SZ Installationshandbuch

Klarstein

Klarstein Botella 166 Uno Bedienungsanleitung

Costway

Costway FP10130WL Bedienungsanleitung

Lemair

Lemair LWC59 Bedienungsanleitung

Haier

Haier JC-125GEA Bedienungsanleitung

Climadiff

Climadiff CLI24 Kurzanleitung

Viking

Viking VCWB301LSS Bedienungsanleitung

Vinvautz

Vinvautz VZ08BHK Bedienungsanleitung

AVG

AVG PRYMO PMB76SS Bedienungsanleitung

Viking

Viking PURHK30BR Bedienungsanleitung