Carel Easy PJEZS Series Bedienungsanleitung

CAREL SERIES REFRIGERATION CONTROL –FIELD SUPPORT GUIDE

1. Overview of the Easy control’s display and buttons:

2. Wiring the control’s connections correctly: Carel controls come in a wide variety of different configurations, often

customized for the OEM appliance manufacturer. A label found on top of the control will show a wiring guide and electrical

specifications for the specific model. When replacing the control, DO NOT ASSUME that the numbered terminals will always serve

the same function as the previous control installed. Carefully check all connections according to the labels / symbols shown

underneath each numbered contact.

Common Configurations: PJEZS* Models –Medium Temp PJEZC* Models –Low Temp

Carefully note the following connections available on your model, and connect the wires accordingly.

Temperature probe input(s)

Control probe (AMB) and optional defrost probe (DEF), with a common

Digital input

Configurable input for alarm, defrost, curtain etc. (Parameter A4)

Compressor output

Contact points may vary across different control models

Fan output

Contact points may vary across different control models

Defrost output

Contact points may vary across different control models

Auxiliary output

Contact points may vary across different control models

Line voltage to outputs

Typically isolated from supply voltage, requiring its own connection

Supply voltage

L/N

Line and neutral supply wires, most commonly points 6 and 7

3. Viewing and changing the set point: Press and hold the red SET button for 1 second to view current set point,

and release immediately after it is displayed. (Display may flash, indicating the value can be changed.)

Press UP and DOWN arrows to change value and press SET again to store new value.

4. Programming the control / customizing the functions:

6. Troubleshooting common alarms: (Alarm indicator will light, and the code will alternate with the temperature on the display

until the condition is corrected and /or alarm is reset.)

Probe 1 Error –replace control probe

Probe 2 Error –replace defrost probe

Hi Temp Alarm –no refrigeration

Low Temp Alarm –cooling below set point

Defrost Timeout –check defrost probe

Dirty Condenser –from probe 3 (A4=10)

7. “Display alternates ‘OFF’ / Temp”: Controller is in OFF status. Press and hold power button for 3s to toggle ON / OFF.

8. If icons are blinking: the controller is calling for this activation, but a delay is keeping this activation off for a period of a set

time (i.e. minimum compressor off time of “x” minutes as a compressor protector).

9. Controller is cooling below the set point: first check if the compressor icon is blinking (Continuous Cycle mode). If blinking,

hold both UP and DOWN arrow together for 3 seconds to deactivate continuous cycle. If compressor icon is not lit but compressor

still runs, troubleshoot the appliance’s compressor, wiring, external contactor, or the control’s output for an electrical short.

10. Not Starting / Skipping Defrost: check if defrost has been disabled by parameter (operating mode) [0 = direct+defrost;

1 = direct (cooling only, no defrost); 2 = reverse (heating)] Also, check the defrost parameters decsibed above.

Is set to terminate defrost by TEMPERATURE? If so, check that the defrost probe is accurate and paramter is correct.

Is set to terminate defrost by TIME? If so, confirm paramters and are correct. (A value of 0 in either will disable defrost.)

Inhaltsverzeichnis

Andere Carel Controller Handbücher

Carel

Carel ir33+ VCC Series Bedienungsanleitung

Carel

Carel pCO3 series Handbuch

Carel

Carel pCO1 series Bedienungsanleitung

Carel

Carel FSC Series Bedienungsanleitung

Carel

Carel easy Bedienungsanleitung

Carel

Carel e-drofan Bedienungsanleitung

Carel

Carel MasterAria Bedienungsanleitung

Carel

Carel PBB2 Series Bedienungsanleitung

Carel

Carel HYPA3 Series Bedienungsanleitung

Carel

Carel PJEZ Series Bedienungsanleitung

Carel

Carel mPCII Bedienungsanleitung

Carel

Carel mchiller compact Bedienungsanleitung

Carel

Carel supernode Bedienungsanleitung

Carel

Carel ADP 30 pAD Series Bedienungsanleitung

Carel

Carel ir33+ Bedienungsanleitung

Carel

Carel ir33+ Bedienungsanleitung

Carel

Carel UltraCella WB000S F0 Series Bedienungsanleitung

Carel

Carel MRK0000 Series Bedienungsanleitung

Carel

Carel EASY FREEZE Bedienungsanleitung

Carel

Carel FCS Series Bedienungsanleitung

Carel

Carel kVent Bedienungsanleitung

Carel

Carel pRack pR300T Bedienungsanleitung

Carel

Carel FCPM0420A0 Bedienungsanleitung

Carel

Carel MuC2SE Bedienungsanleitung

Beliebte Controller Handbücher anderer Marken

Digiplex

Digiplex DGP-848 Betriebsanleitung

YASKAWA

YASKAWA SGM series Bedienungsanleitung

Sinope

Sinope Calypso RM3500ZB Bedienungsanleitung

Isimet

Isimet DLA Series Style 2 Installationshandbuch

LSIS

LSIS sv-ip5a Bedienungsanleitung

Rockwell Automation

Rockwell Automation 1769-L31 Bedienungsanleitung

Airflow

Airflow Uno hab Bedienungsanleitung

ABB

ABB ACS580-01 drives Bedienungsanleitung

Panasonic

Panasonic GM1 Series Bedienungsanleitung

Emerson

Emerson SW93 Bedienungsanleitung

AutoAqua

AutoAqua Smart ATO micro SATO-120P Bedienungsanleitung

Panasonic

Panasonic FP? Positioning Unit RTEX Bedienungsanleitung

Samson

Samson Type 5824 Service-Handbuch

Alpha IP

Alpha IP MIOB 21001 Bedienungsanleitung

Siemens

Siemens OpenAir GMA 1 Series Bedienungsanleitung

Surecom

Surecom SR-629 Bedienungsanleitung

Fishman

Fishman TriplePlay Bedienungsanleitung

Regulus

Regulus SRS1 T Bedienungsanleitung