Caroma QUIET FLOW Bedienungsanleitung
Installation Instructions
Using a ruler, measure the distance from the
base of the cistern to the WL mark on the back
of the cistern.
Insert Quietow valve into cistern & secure in
place using nut provided.
IMPORTANT:- It is critical the 31mm minimum
air-separation from the top of the overow to the
critical level mark on the inlet valve is maintained.
Flush the water supply line before connecting to
stop cock & turn mains water on. Check water
level height is correct and that there are no
leaks.
For further water level adjustment, ensure mains water is turned off.
Repeat steps 2-4 until the desired water level is achieved.
Remove clip on
Quietow valve and
twist body to release
from it’s current set
height.
Slide valve body
up/down until the WL
mark on valve body
corresponds to the
height measured in
step 1.
Twist & lock valve
body back into place
before replacing clip.
* This Inlet Valve must be installed in accordance with AS/NZS 3500.1
Service/Repair Instructions
Ensure mains water is
turned off & disconnect from stop cock.
Flush water supply line before
connecting to stop cock & turn mains
water back on.
Using pliers carefully remove tail strainer from the base of the
valve.
Wash tail strainer to
remove any dirt.
Carefully replace
strainer back into
valve tail.
Push & rotate
anti-clockwise to
re-attach cap
assembly.
Replace seal onto
cap assembly.
Wash seal to
remove any dirt and
inspect for damage.
Remove seal from
cap assembly.
Rotate clockwise &
pull to remove cap
assembly.
Cap Assembly
Seal
®
Helplines
Australia 1300 CAROMA (1300 227 662)
New Zealand +64 9 9279 2700
Caroma International +61 3 9926 5477
Caroma Industries Limited
ABN 35 000 189 499
Locked bag 20, Epping, NSW 2121, Australia
Made in China.
www.caroma.com.au
www.smartush.com.au
www.caroma.co.nz
Leaet No. 687 540~D
● Compatible with all Bottom Inlet Cisterns
where required air-separation is achievable.
Service Requirements
Troubleshooting Guide
Spare Parts Information
● Quietow Inlet Valve compatible Spare Part Kit is 687 040
Containing - 1 x Cap Assembly
- 1 x Seal
Refer to - Steps 1, 2, 5 & 6 above.
● Valve slow to ll OR fails to open ► Ensure tap is open and/or clean Tail Strainer.
● Valve fails to close ► Clean & inspect seal as described above, replace Cap Assembly & Seal if damaged.
● If any other issues arise ► Consult a plumber or Caroma After Sales Service.
● Valve Seal and Inlet Strainer may require periodic cleaning (dependant on water quality).
- procedure as described above.
Dieses Handbuch passt für folgende Modelle
2
Andere Caroma Steuereinheit Handbücher
Beliebte Steuereinheit Handbücher anderer Marken
Festo
Festo Compact Performance CP-FB6-E Stücklistenhandbuch
Elo TouchSystems
Elo TouchSystems DMS-SA19P-EXTME Bedienungsanleitung
JS Automation
JS Automation MPC3034A Bedienungsanleitung
JAUDT
JAUDT SW GII 6406 Series Kurzanleitung
Spektrum
Spektrum Air Module System Bedienungsanleitung
BOC Edwards
BOC Edwards Q Series Bedienungsanleitung
