CarVision UCONNECT Bedienungsanleitung
1. Remove Screen from vehicle and find clean place
to open screen to insert PCB.
2. Remove 5 screws from behind the screen as
shown above.
3. Carefully separate the back from the screen.
Take care not to break the wire in between.
4. Carefully remove the wire connected to the main
PCB board to separate the back completely.
5. Remove the metal bracket behind the screen as
shown above.
6. Remove the 68Pin cable from the main screen as
shown above carefully.
UCONNECT 8.4" Installation Instructions:
Art. 300 313
7. Plug our small 68Pin cable back into the original
cable outlet.
8. Insert the 68Pin cable of the original car plate
into the cable port provided PCB.
9. Insert the video cable into our small board and
fix it on the small board (the video cable needs to
pull a gap as shown above).
10. Cover the housing. When installing, pay
attention to the position of the internal small board
and the position of the gap in video cable. Do not
damage the cable.
11. Attach the original cable back to the main PCB
board as shown above.
11. Insert the screws back to fix the screen back
together and complete installation.
Dieses Handbuch passt für folgende Modelle
1
Andere CarVision Auto-Videosystem Handbücher
