Casablanca W-75SL Bedienungsanleitung

W-75WALLCONTROL 

W-75SLOperatesDownlightsONLY

W-75DLOperatesUpandDownlights

BATTERY INSTALLATION

Open Battery Door

by pressing down

on the insert tab

provided.

Install a “MN21/A23”

12v alkaline batterie

in the space provided.

Please observe proper

polarity placement.

Replace Battery Door.

Battery

Door

12V

CHANGING FREQUENCY SETTING

You will only have to

change the dip switch

settings in the remote

if you are using more

than one fan in the same

area and want to control

them separately. DIPSWITCHES

SETTO‘111111’

(FactorySetting)

NOTE: DO NOT set dip switch setting in the remote to ‘000000’, this may cause

frequency interference from other Casablanca Products.All fans leave the factory set to

“111111”

(Figure2)

(Figure1)

12V

DIPSWITCHES

SETTO‘000000’

To change frequency:

1. Turn power OFF at the circuit breaker or fuse box and at the

wall switch, for the fan you want to change.

2. Open the battery door and remove the battery as shown in

Figure #1

3. Change the dip switch settings, assuring that they are

match the Direct-Touch wall control. See Figure #2.

4. Re-install the battery with the proper polarity position and

the battery door.

5. At the circuit breaker or fuse box and at the wall switch,

turn the power on for the fan whose frequency you are

changing.

6. Within 20 seconds of restoring power to the ceiling fan

press and hold both the “1” and reverse buttons as

shown in Figure #3. For 3 seconds, you will hear an audible

tone indicating the command has been accepted. The Fan

and Lights will be off. The frequency is now changed.

OPERATIONSPEEDCONTROL

There are ve individual speed settings

for the fan. Each speed is indicated by the

number on the controller and an audible tone

for each speed.

To select the desired fan speed:

Press the number on the controller

corresponding to the speed desired. 4 is high,

3 medium, 2 low, 1 ultra-low, and 0 is off.

Note: It is normal for the fan to

start in the "High" position from

"Oﬀ" before changing to the selected

speed.

OPERATIONREVERSINGAIRFLOW

The direction of airow can be changed from

downward to upward or from upward to downward.

To reverse the airow:

1. Make sure the fan is on and blades are turning.

2. Press the reverse button. You will hear a

series of clicks from the fan as it speeds up

before coming to a stop and changing direction.

OPERATIONLIGHTS

To turn the lights off and on, press and

release the button for either the up or

down lights for less than one second.

To dim either the up or down light, Press

and hold the button for either the up or

down light for more than 1 second. The light

will come on at the last brightness setting

and increase in brightness until full power is

reached, then start dimming until the lowest

setting is reached. This cycle will repeat until

you release the light button.

Up Light

Down Light

Note: e dimming feature will only

work as long as the dimming feature

remains active. See "Operation CFL

mode".

Your fan has the ability to disable the

dimming feature to allow the use of CFL

bulbs.

To activate CFL mode:

1. Turn the fan off by using your wall switch.

2. Allow the fan to remain off for at least 5 seconds.

3. Turn the fan on by using your wall switch.

4. Immediately press and hold the "1" and "3" buttons for at least 5 seconds.

The fans lights will go to 100% brightness and the dimming function will

be disabled.

To cancel CFL mode:

5. Turn the fan off by using your wall switch. Allow the fan to remain off for

at least 5 seconds.

6. Turn the fan on by using your wall switch.

7. Immediately press and hold the "2" and "4" buttons for at least 5 seconds.

The fans lights will dim to 50% brightness and the dimming function will

be enabled. Press and hold the light buttons until the desired dimmer

setting is reached.

Caution: CFL bulbs will not

function properly when

dimmed, which may result

in ickering or reduced bulb

life.

OPERATION CFL MODE

AUTOMATICDEMONSTRATIONPROGRAM

Programmed into every Direct-Touch fan is an Automatic Demonstration

Program. It can be used to fully demonstrate

and test the operation of the fan.

To enter the demonstration program:

1. Turn the fan off for at least 5 seconds by

using your wall switch. This will clear the

fan memory ready for programming.

2. Turn the fan on by using your wall switch.

3. Immediately hold the "0" button for at least 5 seconds.

A multi-tone signal will verify the start of the test program. The fan and lights

will go through a series of changing fan speeds, reversing the fan operation

mode, turning off/on, and dimming the lights.

The complete cycle lasts slightly over one minute. It will continue to repeat

until the wall switch is turned off for more than ve seconds, cancelling the

program.

Note: With CFL mode active,

the lights will not dim.

OPERATION SAFE-EXIT®

The Safe-Exit Program gives you about thirty

seconds of light when you turn the lights off,

enabling you to exit your home before the lights go

out. To enter the Safe-Exit Program:

1. Turn the fan off by using your wall switch.

Allow the fan to remain off for at least 5

seconds.

2. Turn the Power on. Immediately press and hold the "4" button for 5

seconds. When a light button is pressed, an audio tone and series of

lights blinking will indicate the program is active.

3. With CFL mode disabled, Pressing a Light Button will cause the lights to

stay on at 50% brightness for 20 seconds then decrease in intensity for 30

seconds then turn off.

4. With CFL mode active, Pressing a Light Button will turn the lights off after

30 seconds.

5. To cancel the Safe-Exit Program, turn off power off using your wall switch

and leave off for ve seconds.

Safe-Exit

The Light-Minder Program automatically turns OFF

the fan mounted lights after two hours. To enter the

Light-Minder Program:

1. To operate the lights for Light Minder Program

Turn the fan off by using your wall switch.

Allow the fan to remain off for at least 5

seconds.

2. Turn the Power on. Immediately press and

hold the "1" button for 5 seconds. A series of

tones will be heard indicating the command

has been accepted. Once the lights turn on,

they will automatically turn off after 2 hours.

3. If you leave the room and turn OFF the lights, the lights will blink to

indicate the Light Minder command has been accepted. The lights will

stay on for 2 hours and then begin to dim. After thirty seconds have

elapsed, the lights will turn completely off. In CFL Mode, the lights will

not dim, but shut off after 2 hours.

4. To cancel the Light Minder Program, turn off power off using your wall

switch and leave off for ve seconds.

LIGHT-MINDER® PROGRAM

Light-Minder

OPERATIONHOME-SAFE®PROGRAM

TROUBLESHOOTINGTIPS

ONEYEARWARRANTY

OPERATIONFAN-MINDER™PROGRAM

1. To operate the Home-Safe Program –

Turn the fan off by using your wall

switch. Allow the fan to remain off for at

least 5 seconds.

2. Turn the Power on. Immediately press

and hold the "3" button for 5 seconds. A

series of tones will be heard indicating

the command has been accepted.

3. The lights will automatically cycle on and off in a controlled sequence as

follows: ON 1 hour, OFF ½ hour, ON 2 hours, OFF 1 hour, ON ½ hour then

OFF 2 hours. This seven hour pattern will repeat continuously so that a

different pattern of lighting is seen each day of the week.

4. To cancel the Home-Safe Program, turn off power off using your wall

switch and leave off for ve seconds.

The Fan-Minder feature will add to your comfort when used

in the bedroom. The program reduces the speed of the fan

each two-hour interval to compensate for cooling night air.

1. To activate the Fan Minder Program – Turn the fan off

by using your wall switch. Allow the fan to remain

off for at least 5 seconds.

2. Turn the Power on. Immediately press and hold the "2"

button for 5 seconds.

3. The fan will respond with three descending tones. A

timer is now initiated and the fan will reduce one speed

for each two-hour interval. The fan will not, however,

descend below the rst or the lowest speed.

4. You may increase the fan speed by pressing and holding any of the fan speed

buttons until the desired speed is reached, then release it. The fan will again

reduce one speed for each 2 hour interval.

5. To cancel the Fan-Minder Program, turn off power off using your wall switch

and leave off for ve seconds.

Note: This program overrides all manual

control of lights and fan.

Please refer to this troubleshooting guide before requesting service or contacting your dealer for assistance.

PROBLEM POSSIBLE REMEDIES

Fan will not start • Check the main circuit fuses, circuit breakers, and wall switch position.

• e battery is weak. Install a fresh battery.

• Check the frequency setting: --see instructions for changing the frequency setting.

Fan does not respond to remote control • Power to the fan is oﬀ.

• Wrong remote is being used.

• Remote dip settings changed --see instructions for changing the frequency setting.

Battery life is short • Replace with alkaline batteries.

Fan O.K., No light • Check for burned out light bulb. Check fan light wires.

Light O.K., No fan • Check connectors, may not be making good contact.

Remote control of fan is erratic • Check that the batteries are installed correctly.

• Install fresh ALKALINE batteries.

Fan starts working by itself • Frequency interference; Change dip switches --see instructions for changing the frequency setting.

If you have any problem installing or

operating your fan, do not return this

product to the dealer. Call our toll-free

Consumer Aﬀairs hotline at 888-227-2178,

Monday through Friday,

8 a.m. to 4:30 p.m. Central.

Your request will be handled immediately.

is product is warranted to the original purchaser by Casablanca Fan Company against defects in material and workmanship for one (1) year from date of

purchase. During the warranty period, we will repair or, at our option, replace a defective product at no charge. For information on how to obtain service,

contact Casablanca’s Service Department by calling our toll-free number, 888-227-2178. Damage to the product caused by mishandling, improper installation or

modiﬁcation is not covered by this warranty. is warranty is given in lieu of all other warranties expressed or implied. Some states do not allow limitations of time

on an implied warranty, therefore the above limitations may not apply in every case. is warranty states speciﬁc legal rights which may vary from state to state.

is device complies with RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any

interference, including interference that may cause undesired operation of the device.

1. is device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operation.

2. is equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. ese limits are designed to provide reasonable protection

against harmful interference in a residential installation. is equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment oﬀ and on, the user is encouraged to try to correct the interference by one or more of the following

measures: Reorient or relocate the receiving antenna, Increase the separation between the equipment and receiver, Connect the equipment into an outlet on a circuit diﬀerent from that to

which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Note: Any changes or modiﬁcations to the transmitter or receiver not expressly approved by

Casablanca Fan Company may void one’s authority to operate this remote control.

7130 GOODLETT FARMS PKWY.

SUITE 400

MEMPHIS, TN 38016

1 (888) 227-2178

WWW.CASABLANCAFANCO.COM

Dieses Handbuch passt für folgende Modelle

Andere Casablanca Steuereinheit Handbücher