5 43
Use proper safety clothing and devices when operating the machine
(, safety goggles, ear protectors, safety shoes …)! Do not wear safety
gloves for oper-ating because they decrease the working accuracy
and they might be pulled into the saw blade.
Before any maintenance you have to disconnect the panel saw from
the power source. Never use the plugged cable for transporting or
manipulating the machine.
ELECTRICAL SAFETY
Tool before connecting power, using the socket must be able to fit the plug machine. The
380V model to determine the fire and. Line the correct docking, power supply socket with the
need of professionals to complete. Do not arbitrarily change the plug, adapter plugs can't pick.
The electric tool wire used together.
SAFETY INSTRUCTIONS
Warning labels and/or other labels on the machine must be replaced when they were removed.
Do not operate the machine at insufficient lighting conditions.
Do not operate the machine outdoors.
Do not operate the machine when you are tired, when your concentration
is impaired, and/ or under the influence of drugs, medication or alcohol.
Climbing onto the machine is forbidden! Heavy injuries by falling down
or by tilting of the machine are possible.
The machine shall be used only by trained persons.
Non authorized persons, especially children, shall be kept away from
the work area.
Do not wear loose clothing, long hair openly or loose jewellery like
neck-laces etc. when operating the machine
They might be catched by rotating parts and cause serious injuries.
INSTRUCTIONS
1 .Plug the power plug, the drill bit aim at processing position, make the magnetic switch is
opened, so that the magnetic is adsorbed on the surface of steel plate magnetic materials.
No impurities on the surface, and check whether the attractive force is normal or not. (ge-
neral plate thickness should be more than 10mm)
2 .Please placed the magnetic base drill required from the drilling near site and select the appro
priate adsorption material.And will handle hole safety rope penetrates into the frame, the
other one is in fastening frame after the penetration of the buckle, and then close the safety
rope buckle. Hand and pull off, should not loose and mobile.
3 .For a support screw, regulating the support screw that the bottom touches the workpiece
surface.
4. For the magnetic base is provided with the angle of the drill, the use of angle wrench movem-
ent angle disk in the annex to the belt rack makes bit central alignment processing position,
tighten the angle wrench.
5 .Open the electric drill switch, check whether the drill bit beat, sound is normal, if everything is
normal can turn the handle to feed.
6. Start feeding should be slow, gives the quantity of about 0.05mm/r in general, not too much
force, to prevent overload.
7. If the drill suddenly stopped, you must turn off the power switch immediately, (Mustclose
the magnetic control switch)
8.Please shut down for a period of time machine in continuous use for 2-3 hours, in case mag-
netic base is overheated and leakage or burned.
9.Should be filled with cooling water or cooling liquid using hollow drill, turn on the tap,and let
it flow out slowly.
