16 17
TRUE ON LINE UPS TRUE ON LINE UPS
CAUTION!
DO NOT CONNECT EQUIPMENT WHICH WOULD OVERLOAD THE UPS
SYSTEM (E. G. LASER PRINTERS).
3) Battery Charge: Fully charge the batteries of the UPS system by leaving the UPS
system connected to the mains for 8-10 hours. You may use the UPS system directly
without charging it but the stored energy time may be shorter than the nominal value
specified.
4) Turn On the UPS:
4-1) With utility power connecting:
For 1K / 2K UPS, press I button continuously for more than 1 second to
turn on the UPS. Then the UPS will get into self-test status first. After having finishing
the self-test, the UPS will get into the inverter mode, at this time, the Utility Power
LED, Inverter LED, and Load and Battery Capacity LEDs will light up.
4-2) Without utility power connecting:
Even though utility power is connected to the UPS, the UPS still can be turned on by
just simply pressing I button continuously for more than 1 second. Then the UPS
will get into self-test status first. After having finishing the self-test, the UPS will get
into the inverter mode, at this time, Battery LED, Inverter LED, and Load and Battery
Capacity LEDs will light up.
Note: The default setting for bypass mode is no output after UPS is connecting
utility power and breaker is turned on. This can be configured by monitoring
software.
5) Test Function:
Test the function of the UPS system by either pressing the On-Switch I or
disconnecting the input of the UPS system from the power supply.
6) Turn Off the UPS:
2) Connection:
2-1) UPS Input Connection
If the UPS is connected via the power cord, please use a proper socket with protection
against electric current, and pay attention to the capacity of the socket: over 10A for
1KS(H) & 2K, over 16A for 2KH & 3KS(H).
2-2) UPS Output Connection
The output of 1KS(H),2KS(H) and 3KS(H) are socket-types only. Simply plug the
load power cord to the output sockets to complete connection.
2-3) Computer Connection:
Connect your computer to the outlet sockets of the UPS system.
6-1) In Inverter Mode: Press button continuously for more than 1 second to
turn off the UPS. Then the UPS will get into self-test status first. After having finished
the self-test, the UPS will get into bypass mode and the Utility Power LED and
Bypass LED will light up. At this time, the UPS might has output. Disconnect the
utility power to turn off the output.
6-2) In Battery Mode: Press button continuously for more than 1 second to
turn off the UPS. Then the UPS will get into self-test status first. After having
finished the self-test, the UPS will be turned off completely.
7) Audible Alarm Mute Function: If the alarm is too annoying in battery mode,
you may press I button continuously for more than 1 second to clear it.
8) Operation Procedure of External Battery for Long Backup time Model
( H Model)
(1) Use the battery pack with voltage: 36Vdc for 1 KH (3 pcs of 12V batteries), 96Vdc
for 2KH / 3KH (8 pcs of 12V batteries). Connection of batteries more than or less
than required will cause abnormality.
