CDA SK700 Montage- und Bedienungsanleitung
www.cda.eu
SK700
Single Oven
Installation, use and maintenance
2
Contents:
3 Important information
5 Safety instructions
6 First use of the oven
7 Oven controls and use
8 Function table
9 Cleaning function
10 Electronic programmer/timer
10 Setting the current time
10 Minute minder function
11 Semi-automatic cooking
12 Automatic cooking
14 Safety key lock
14 Eco mode
16 Cleaning and maintenance
17 Removing the appliance door
18 Replacing the appliance door
19 Removing the inner door glass
21 - 22 Removing shelf supports, runners and liners
23 Changing the oven light bulb
24 Installation
26 Mains electrical connection
28 Troubleshooting
29 Energy Eciency Information
IMPORTANT: Please read the user instructions carefully before
using the appliance for the first time and before installing it.
Failure to install the oven as per the user manual could invalidate
the warranty.
3
Important
This appliance must only be used for the purpose for which it is
intended, i.e. domestic cooking. Any other use could be dangerous
and may lead to premature failure of the appliance.
The CDA Group Ltd cannot be held responsible for injuries or losses
caused by incorrect use or installation of this product. Please note that
CDA reserve the right to invalidate the guarantee supplied with this
product following incorrect installation or misuse of the appliance.
Under no circumstances should any external covers be removed for
servicing or maintenance except by suitably qualified personnel.
User information:
• Ovens become hot during and immediately after use.
•The oven door can become very hot during operation.
•After use, please ensure that the oven switches are in the ‘O’
position.
•Keep children away from the appliance when in use, and
immediately after use.
•Do not allow children to play with or on the appliance.
•Keep the oven door closed whilst grilling.
Appliance information:
Please enter the details from the appliance rating plate on to the
following page for reference, to assist CDA Customer Care in the
event of a fault with your appliance and to register your appliance for
guarantee purposes.
4
Appliance Model
Serial Number
EU Declarations of Conformity:
This oven has been designed, constructed and marketed in
compliance with safety requirements of EU Directive 2014/35/EU (Low
voltage) and requirements of EU Directive 2014/30/EU.
This appliance has been manufactured to the strictest standards and
complies with all applicable legislation, including Electrical safety (LVD)
and Electromagnetic interference compatibility (EMC). Parts intended
to come into contact with food conform to 1935/2004/EC.
IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE
PRODUCT IN ACCORDANCE WITH EC DIRECTIVE 2012/19/EU.
At the end of its working life, the product must not be disposed
of as urban waste. It must be taken to a special local authority
dierentiated waste collection centre or to a dealer providing this
service.
Disposing of a household appliance separately avoids possible
negative consequences for the environment and health deriving from
inappropriate disposal and enables the constituent materials to be
recovered to obtain significant savings in energy and resources. As a
reminder of the need to dispose of household appliances separately,
the product is marked with a crossed-out wheeled dustbin.
5
Important
•Read the user instructions carefully before using the oven
for the first time.
•Follow the instructions for first use of the oven.
•Clean the oven regularly.
•Remove spills as soon as they occur.
•Always use oven gloves when removing shelves and trays
from the ovens.
•Do not allow children near the oven when in use.
•Do not allow fat or oils to build up on the oven shelves, grill
pan or oven base.
•Do not place any cooking utensils or plates directly on the
oven base.
•Always grill with the oven door closed.
•Do not grill food containing fat without using the grill pan
grid.
•Do not cover the trays or the oven walls with aluminium
foil.
•Do not perform maintenance or cleaning of the oven
without first switching o the electricity supply. If the oven
has recently been used, allow to cool.
•Do not place hot enamel parts in water. Leave them to
cool first.
•Do not allow vinegar, coee, milk, saltwater, lemon or
tomato juice to remain in contact with enamel parts.
•Do not use abrasive cleaners or powders that will scratch
the surface of the enamel.
•Do not attempt to repair the internal workings of your
oven.
6
First use of the oven
•The metal casing of this appliance has been coated with a
preservative to protect it during transport and storage. This should
be removed during installation by using a non-abrasive stainless
steel cleaner. Always follow the instructions given with the cleaner
being used. Remove all protective film from the oven accessories.
•Before using the oven for the first time we recommend that you
clean the oven with soapy water and rinse carefully. Set the current
time on the programmer as per page 10. Heat on each of the
below programmes at maximum temperature for the specified time.
A slightly unpleasant smell may be produced, caused by grease
remaining on the oven elements from the production process.
15 minutes full grill 30 minutes fan oven
Please note:
•This oven has been fitted with a cooling fan to achieve maximum
eciency and to maintain low surface temperatures. The cooling fan
will switch on automatically when the oven switches on. It is normal
for the cooling fan to run for an hour or more after use, depending
on the duration, temperature and type of cooking programme used.
7
Oven controls and use
A - Cooking function knob E - Safety key lock sensor
B - Clock sensor F - Oven light sensor
C - Timer sensor G - Adjustment knob
D- Temperature sensor H - Timer display
IMPORTANT: You must set the current time on the oven
programmer, as per page 10, for the oven to operate properly.
Cooking function knob (A)
To set a function, turn the cooking function knob (A in Fig. 1) to the
required function. Most functions have a preset temperature (see
page 8). The adjustment knob (G) can be used to change this (see
below). Turn the knob left to lower the temperature and right to raise
it.
If the temperature display next to the symbol is flashing, then
this indicates that temperature adjustment is available. Press the
temperature sensor to activate temperature adjustment. Once
active, use the adjustment knob (G) to set the desired temperature
and then either press the temperature sensor again or wait
approximately 5 seconds.
Fig. 1
A E
BCD
H
FG
8
Knob setting Display indication Oven functions Default setting
1 FAN
170°C
Level 3
2
FAN ECO*
170°C
Level 3
3
FAN +
BOTTOM ELEMENT
220°C
Level 2
4
BOTTOM ELEMENT
(CRISPING)
200°C
5
BOTTOM ELEMENT
+ TOP ELEMENT
180°C
Level 3
6
BOTTOM ELEMENT
+ TOP ELEMENT
+ FAN
170°C
Level 3
7
GRILL
TOP ELEMENT
FAN
190°C
Level 2
8
GRILL
TOP ELEMENT
280°C
Level 5
9
GRILL
280°C
Level 5
10 CLEANING
Bottom element
90°C
30 min.
*ECO Fan Heater is an optimised heating function designed to save energy when preparing
food.
Each of the oven functions uses dierent elements within the oven
to oer you the best choice of cooking every time. These are
explained on the quick reference table below. The levels referenced
in the ‘Default setting’ column are the recommended shelf positions
(numbers are on the oven cavity sides, behind the door, to aid you).
9
When fan grilling, please note:
• Always grill with the oven door closed.
• The grill pan does not need to be as close to the grill as possible.
• Do not grill for more than 30 minutes at a time.
• Preheat the grill for up to five minutes with the oven door closed.
When grilling, please note:
• Always grill with the oven door closed.
• Put the grill pan as close to the grill as possible.
• Do not grill for more than 30 minutes at a time.
• Preheat the grill for up to five minutes with the oven door closed.
Cleaning function
This function heats a tray of water to approximately 90°C (for a preset
time of 30 minutes) which will help to loosen any stubborn stains or
dirt inside the oven and make it easier to clean the interior manually.
Use the baking tray (the shallower of the two supplied). Pour
approximately 250ml (one glass) of water into the tray, insert it into the
lowest shelf position and activate the function (function 10 on the table
opposite). Once complete, an acoustic signal will sound. Wearing oven
gloves, remove the baking tray, switch the power o at the mains supply
and clean the interior as per the cleaning and maintenance section
(page 16).
Remember that the oven interior will be hot to the touch, exercise
extreme care and always wear adequate Personal Protective
Equipment (PPE).
10
Electronic programmer/timer
This oven’s electronic timer is equipped with touch control sensors.
Each registered touch of a sensor field is confirmed by a single beep.
It is advisable to keep the sensor fields clean at all times to avoid
errors in operation.
Setting the current time
After connection to the mains supply, or re-connection after a power
outage, the display will show ‘24hr’. Use the adjustment knob (G in Fig.
1) to change between 24 hour time display and 12 hour time display.
•Press the clock sensor . Use the adjustment knob (G) to set the
number of hours.
•Press the clock sensor again. Use the temperature control
knob (G) to set the time in minutes. Press the clock sensor
again to confirm entry.
Please note: The time must be set for the oven to work.
Setting the minute minder function
The minute minder function can be set at any time whilst a function is
active. The minute minder can be set anywhere from 1 minute to 23
hours and 59 minutes.
•Press the timer symbol . The symbol on the display should
flash and the time display should show ‘00:00’.
•Set the desired duration of the minute minder using the adjustment
knob (G). Touch the timer symbol and the minute minder will
be set. The symbol will be solidly lit. The current time will be
shown on the timer display.
Inhaltsverzeichnis
Andere CDA Ofen Handbücher
CDA
CDA SK510 Single Kurzanleitung
CDA
CDA SK110 Kurzanleitung
CDA
CDA DV 770 Bedienungsanleitung
CDA
CDA SC211 Referenzhandbuch
CDA
CDA SV410 for Referenzhandbuch
CDA
CDA RV 700 Series Bedienungsanleitung
CDA
CDA SC210 Series Referenzhandbuch
CDA
CDA SK451 Bedienungsanleitung
CDA
CDA SL400BL Benutzerhandbuch
CDA
CDA SC 310 Series Referenzhandbuch
CDA
CDA SV 150L Series Gebrauchsanweisung
CDA
CDA DC740 Referenzhandbuch
CDA
CDA SL550SS Benutzerhandbuch
CDA
CDA 9Q6 Series Referenzhandbuch
CDA
CDA DC741 Kurzanleitung
CDA
CDA vk700 Referenzhandbuch
CDA
CDA 9Q6 Series Referenzhandbuch
CDA
CDA DC930 Series Referenzhandbuch
CDA
CDA SK410SS Technisches Datenblatt
CDA
CDA 11Z6 for Referenzhandbuch
