1. GENER L INFORM TION
Thank you for your purchase of CEL-MAR Company product. This product has been completely tested and is covered by two year
warranty on parts and operation from date of sale.
If any questions or problems arise during installation or use of this product, please do not hesitate to contact Technical Support at +48
41 362-12-46 or e-mail support@cel-mar.pl.
1.1. W RR NTED INFORM TION
CEL-M R Company gives the two year guarantee on the DNB-200 splitter. In case of being damaged it will be repair or the
damaged component will be replace. The warranty does not cover damage caused from improper use, materials consumption or any
unauthorized changes. If the product does not function (is damaged), or not operate in accordance with the instructions, will be
repaired.
All warranty and no warranty repairs must be returned with paid transport and insuring to the CEL-M R Company.
CEL-M R Company under no circumstances won't be responsible for ensuing damage from improper using the product or as a result
of random causes: the lightning discharge, the flood, the fire and the like.
CEL-M R Company is not be held responsible for damages and loss including: loss of profits, loss of data, pecuniary losses ensuing
from using or the impossibility of using this product.
In specific cases CEL-M R Company discontinue all warranties and in particular do not follow the user manual and do not accept
terms of warranty by the user.
1.2. GENER L CONDITIONS FOR S FE USE
The device should be installed in a safe and stable places, the powering cable should be arranged so as not to be exposed to
trampling, attaching, or pulling out of the circuit.
Do not put device on the wet surface.
Do not connect devices for nondescript powering sources,
Do not damage or crush powering wires.
Do not make connection with wet hands.
Do not adapt, open or make holes in casings of the device!
Do not immerse device in water or no other liquid.
Do not put the fire opened on device sources: candles, an oil lamps and the like.
1.3. ENVIRONMENT L PRESERV TION
This sign on the device inform about putting expended device with other waste materials. Device should send to the
recycling. (In accordance with the act about the Electronic Appliance Expended from day 29 of July 2005)
1.4. SERVICE ND M INTEN NCE
It is recommended to check the status of modular sockets and the sensors connecting cables, to eliminate the influence of mechanical
damage on the quality of measurement .
Technical support is available at number +48 41 362-12-46 in 8.00-16.00, from Monday to Friday or e-mail support@cel-mar.pl.
2. SOLUTIONS
Splitter D B-200 is used to for connection of digital sensors as: DTS-103, DTS-107 to remote multi-point measurement temperature
system in:
–rooms with structured cabling,
–automation cubicles,
–data communication cubicles,
–devices,
–and outside temperature via the serial bus 1-WIRE.
Application of 1-Wire bus enables:
–the cooperation of many sensors connected to the same data lines,
–the deployment of sensors in various locations up to 260m,
–powering the sensors from the bus,
–guarantee the correct transmission of measurement data secure checksum CRC
3. SPECIFIC TIONS
Parameters Data
Casing material Polystyrene
Operating temperature from -30°C to +70°C
Degree of protection IP20
Dimensions 50,2 x 40,2 x 20,6 mm
Weight 0,05 kg
Storage and transport
outdoor temperature -30 ÷ +70°C
Relative air humidity 5 ÷ 95% - noncondensing
3
