Celestron NexStar 80GTL Bedienungsanleitung

Extend tripod legs 6 to 8 inches by loosening

the tripod leg locking bolts and pulling the leg

to desired length and re-tightening knob.

Assemble tripod by spreading the legs out until

the center leg brace is fully extended.

Item #31132

Quick Set-up Guide

123

All three legs should be the same length to

provide a level platform for the telescope.

Properly assembled, the accessory tray should

appear as pictured above.

Place accessory tray on top of center leg

brace as shown above.

To secure the accessory tray to leg brace,

tighten the attached screw located underneath

the leg brace.

Next Loosen the screw located on the

telescope tube ring clamp.

To balance the telescope, slide the tube ring

clamp to the line on the warning sticker located

on the telescope tube. Then tighten the tube ring

clamp screw.

NexStar 80GTL

Your NexStar 80GTL includes: optical tube w/ fork

arm attached; tripod; computerized hand control;

solar filter; erect image diagonal; two eyepieces;

finderscope; battery pack; accessory tray w/

compass; documentation including an owner’s

manual, The Sky™ CD and Telescope Control

Software.

Warning sticker line

Quick Set-up Guide [cont]

Hold the telescope tube assembly by the fork

arm and place the bottom of the base inside

the tripod mounting platform as shown.

Then thread the coupling screw into

the hole at the bottom of the fork arm base.

Tighten screw to secure the entire assembly.

When properly assembled your telescope

should look like this.

Place the computerized hand control in the

bracket on the accessory tray and connect the

hand control to the fork arm base as shown.

Attach the battery pack to the tripod by

hanging the strap from one of the wingnuts on

the tripod.

To attach the finderscope, loosen the silver

screw and slide finderscope into mounting

platform. The glass window should be facing

towards the front of the telescope.

Tighten silver screw to secure finderscope in

place.

17 18

Insert the chrome barrel of the 90º erect image

diagonal into the focuser and tighten the two

silver screws to secure in place.

Next loosen the silver screw at the top

of the 90º erect image diagonal and remove

the plastic cover.

Select the low power (25mm) eyepiece and

insert it as shown above. Tighten silver screw

to secure.

Remove tube lens cap to begin viewing.

While observing, tube should be positioned as

shown above.

A solar filter may be installed for viewing the

sun. Before use check to make sure there are

no pin holes in it. See inset. See owner’s

manual for complete instructions.

For detailed usage

information please

consult your manual.

Now you are ready to put in the 90º erect

image diagonal. First you must loosen the two

silver screws and then remove the plastic cap

from the focuser.

Coupling screw

Andere Handbücher für NexStar 80GTL

Andere Celestron Teleskop Handbücher

Celestron

Celestron NexStar SE Bedienungsanleitung

Celestron

Celestron CPC DELUXE 800 HD Bedienungsanleitung

Celestron

Celestron 60EQ Bedienungsanleitung

Celestron

Celestron AstroMaster 130EQ Bedienungsanleitung

Celestron

Celestron 80AZS Bedienungsanleitung

Celestron

Celestron AstroMaster LT Bedienungsanleitung

Celestron

Celestron Advanced Series C6-RGT Bedienungsanleitung

Celestron

Celestron PowerSeeker 40AZ Bedienungsanleitung

Celestron

Celestron 15-60x60mm Bedienungsanleitung

Celestron

Celestron Travel Scope 60 Bedienungsanleitung

Celestron

Celestron PowerSeeker 127EQ Technisches Datenblatt

Celestron

Celestron 52201 Bedienungsanleitung

Celestron

Celestron PowerSeeker 114EQ Bedienungsanleitung

Celestron

Celestron CPC 925 Bedienungsanleitung

Celestron

Celestron Tabletop 76 Bedienungsanleitung

Celestron

Celestron StarSense Explorer DX 130AZ Bedienungsanleitung

Celestron

Celestron PowerSeeker 60AZ Bedienungsanleitung

Celestron

Celestron NexStar EVOLUTION 8 EDGE HD Bedienungsanleitung

Celestron

Celestron StarSense Explorer DX Bedienungsanleitung

Celestron

Celestron NexStar 5 Bedienungsanleitung

Celestron

Celestron FirstScope 90AZ Technisches Datenblatt

Celestron

Celestron 21011 Bedienungsanleitung

Celestron

Celestron Regal M2 Bedienungsanleitung

Celestron

Celestron StarSense Explorer DOBSONIAN Bedienungsanleitung

Beliebte Teleskop Handbücher anderer Marken

Meade

Meade 81005 Condor Bedienungsanleitung

Meade

Meade 114 EQ-DS Bedienungsanleitung

Meade

Meade LX200 CLASSIC Bedienungsanleitung

Leica

Leica 82 HD Bedienungsanleitung

EASTCOLIGHT

EASTCOLIGHT 9920 Bedienungsanleitung

zoomion

zoomion Genesis 200 EQ Bedienungsanleitung

TEC

TEC APO 140 Bedienungsanleitung

Orion

Orion 7832 Bedienungsanleitung

Carson

Carson Skelescope SK-100 Bedienungsanleitung

SKY-WATCHER

SKY-WATCHER VIRTUOSO Bedienungsanleitung

Orion

Orion EZ Finder 7228 Bedienungsanleitung

cassini

cassini C-JRS Bedienungsanleitung

nedis

nedis SCTE5060WT Bedienungsanleitung

Meade

Meade Polaris 60EQ-D Bedienungsanleitung

PlaneWave

PlaneWave CDK700 Bedienungsanleitung

William Optics

William Optics Synta Crayford Bedienungsanleitung

Orion

Orion FUNSCOPE Bedienungsanleitung

Levenhuk

Levenhuk Skyline Travel Bedienungsanleitung