CellGate Watchman WXL Bedienungsanleitung
Quick Install Guide
2020
AA1XLPE Devices
INSTALLER TEST CODE:
CODE WILL STOP WORKING AFTER 10 USES.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.
Technical Support: 972-231-1999 option 2
18 gauge stranded - up to 25 ft
16 gauge stranded - up to 50 ft
12 gauge stranded - up to 60 ft
Recommended Wire Guide
WXL
**Recommended wiring: 18/6 shielded for main device, and 18/4 shielded for optional wiegand devices**
Items Included in Kit
❶WXL Unit
❷12 Volt DC Power Supply
❸Magnetic Read Switch
❹Keys (Note: Leave one key with the customer)
❺Nuts X 4
❻Bolts X 4
❼Quick Install Guide
❽Activation & Test Process
❾Customer Information Packet
WXL Unit Power Supply Wiring
Interface Circuit Board (Oriented the same as the Watchman install)
WXL
-
Router
Interface
Circuit
Board
Ethernet
Switch
WATCHMAN
Important Item
Interface Wiring Diagram (Oriented the same as the Watchman install)
❶Wire main power from the transformer to the power connector on the
circuit board.
❷Connect gate trigger wires from the Normally Open (NO) and Common (C)
to the free-exit or exit terminals on the gate operator.
❸Connect the gate status wires on the 6-pin connector on the main relay
and input plug to the magnetic switch or a Dry Contact, Normally Closed (NC)
relay on the gate operator.
❹If using an optional 26-bit reader (ex., keypad, card reader, RFID, or
clicker), wire the device to the Wiegand connection on the interface circuit
board.
❺Use Camera Guide if adding optional external camera.
❻Test/activate using the test credentials on the Activation & Test Process
document.
6-Wire Installation Instructions
Important Item
WXL
18 gauge stranded - up to 25 ft
16 gauge stranded - up to 50 ft
12 gauge stranded - up to 60 ft
Recommended Wire Guide
WATCHMAN
❶
❷
❹
❸
Installation Testing
Enter the Testing Code, then tap the Enter Button.
The Code will activate Relay 1 (the gate should open).
Enter Button
Locate a Callgroup and tap on it to call it.
An automated message will play confirming the call
was successful.
WXL
Enter a Code
Call List
Home
WATCHMAN
External Camera Installation.
Customer Information
•If you’re installing an External Camera, call
CellGate Technical Support for testing.
•Technical Support:(972) 231-1999 option 2.
Leave the following items with the Customer:
•Customer Information Packet
•WXL - Key
WXL
WATCHMAN
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Andere CellGate Touch-Screen Handbücher
Beliebte Touch-Screen Handbücher anderer Marken
Elecro Engineering
Elecro Engineering Poolsmart Plus Montageanleitung
Johnson Controls
Johnson Controls IQ4 HUB Bedienungsanleitung
Elo TouchSystems
Elo TouchSystems ET2270L Bedienungsanleitung
Elo TouchSystems
Elo TouchSystems ET1002L Bedienungsanleitung
Elo TouchSystems
Elo TouchSystems 3201L Bedienungsanleitung
Duratec
Duratec S15 Bedienungsanleitung
