Cellocator CelloTrack T Bedienungsanleitung
Copyright © 2014 by Pointer Telocation, Ltd.
CelloTrack T
Installation Guide
Proprietary and Confidential
Version 1.2
Revised and Updated: July 8, 2014
CelloTrack T Installation Guide
CelloTrack T Installation Guide Page 2 of 20
Copyright © 2014 by Pointer Telocation, Ltd.
Legal Notices
IMPORTANT
1. All legal terms and safety and operating instructions should be read thoroughly before
the product accompanying this document is installed and operated.
2. This document should be retained for future reference.
3. Attachments, accessories or peripheral devices not supplied or recommended in
writing by Pointer Telocation Ltd. May be hazardous and/or may cause damage to the
product and should not, in any circumstances, be used or combined with the product.
General
The product accompanying this document is not designated for and should not be used in
life support appliances, devices, machines or other systems of any sort where any
malfunction of the product can reasonably be expected to result in injury or death.
Customers of Pointer Telocation Ltd. using, integrating, and/or selling the product for use
in such applications do so at their own risk and agree to fully indemnify Pointer Telocation
Ltd. for any resulting loss or damages.
Warranty Exceptions and Disclaimers
Pointer Telocation Ltd. Shall bear no responsibility and shall have no obligation under the
foregoing limited warranty for any damages resulting from normal wear and tear, the cost
of obtaining substitute products, or any defect that is (i) discovered by purchaser during
the warranty period but purchaser does not notify Pointer Telocation Ltd. Until after the
end of the warranty period, (ii) caused by any accident, force majeure, misuse, abuse,
handling or testing, improper installation or unauthorized repair or modification of the
product, (iii) caused by use of any software not supplied by Pointer Telocation Ltd., or by
use of the product other than in accordance with its documentation, or (iv) the result of
electrostatic discharge, electrical surge, fire, flood or similar causes. Unless otherwise
provided in a written agreement between the purchaser and Pointer Telocation Ltd., the
purchaser shall be solely responsible for the proper configuration, testing and verification
of the product prior to deployment in the field.
POINTER TELOCATION LTD.’S SOLE RESPONSIBILITY AND PURCHASER’S SOLE REMEDY
UNDER THIS LIMITED WARRANTY SHALL BE TO REPAIR OR REPLACE THE PRODUCT
HARDWARE, SOFTWARE OR SOFTWARE MEDIA (OR IF REPAIR OR REPLACEMENT IS NOT
POSSIBLE, OBTAIN A REFUND OF THE PURCHASE PRICE) AS PROVIDED ABOVE.
POINTER TELOCATION LTD. EXPRESSLY DISCLAIMS ALL OTHER WARRANTIES OF ANY
KIND, EXPRESS OR IMPLIED, INCLUDING WITHOUT LIMITATION ANY IMPLIED
WARRANTIES OF NON-INFRINGEMENT, MERCHANTABILITY, SATISFACTORY
PERFORMANCE AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL
POINTER TELOCATION LTD. BE LIABLE FOR ANY INDIRECT, SPECIAL, EXEMPLARY,
INCIDENTAL OR CONSEQUENTIAL DAMAGES (INCLUDING WITHOUT LIMITATION LOSS
OR INTERRUPTION OF USE, DATA, REVENUES OR PROFITS) RESULTING FROM A BREACH
OF THIS WARRANTY OR BASED ON ANY OTHER LEGAL THEORY, EVEN IF POINTER
TELOCATION LTD. HAS BEEN ADVISED OF THE POSSIBILITY OR LIKELIHOOD OF SUCH
DAMAGES.
CelloTrack T Installation Guide
CelloTrack T Installation Guide Page 3 of 20
Copyright © 2014 by Pointer Telocation, Ltd.
Intellectual Property
Copyright in and to this document is owned solely by Pointer Telocation Ltd. Nothing in
this document shall be construed as granting you any license to any intellectual property
rights subsisting in or related to the subject matter of this document including, without
limitation, patents, patent applications, trademarks, copyrights or other intellectual
property rights, all of which remain the sole property of Pointer Telocation Ltd. Subject to
applicable copyright law, no part of this document may be reproduced, stored in or
introduced into a retrieval system, or transmitted in any form or by any means
(electronic, mechanical, photocopying, recording or otherwise), or for any purpose,
without the express written permission of Pointer Telocation Ltd.
© Copyright 2014. All rights reserved.
CelloTrack T Installation Guide
CelloTrack T Installation Guide Page 4 of 20
Copyright © 2014 by Pointer Telocation, Ltd.
Table of Contents
1Introduction .............................................................................................................. 5
1.1 Overview..................................................................................................................... 5
1.2 Abbreviations .............................................................................................................. 5
1.3 References .................................................................................................................. 5
1.4 Revision History ........................................................................................................... 5
2CelloTrack Interfaces ................................................................................................ 6
2.1 The CelloTrack Interface ............................................................................................... 7
2.2 The CelloTrack Power Interface ...................................................................................... 8
2.3 CelloTrack Connector .................................................................................................... 9
2.4 CelloTrack Power Harness ............................................................................................10
3Installation Instructions ......................................................................................... 11
3.1 Installation Overview ...................................................................................................11
3.2 Tools and Equipment Required......................................................................................11
3.3 Initial Setup for the CelloTrack......................................................................................12
3.4 Initial Setup for the CelloTrack Power ............................................................................13
3.5 Enable Cradle Tamper Switch .......................................................................................13
3.6 Mounting the CelloTrack Device ....................................................................................14
3.7 Mounting with the Magnetic Cradle ................................................................................15
3.8 Wiring Guidelines for the CelloTrack Power .....................................................................16
3.9 CelloTrack Power Wiring Connection: Digital Input not in Use ...........................................17
3.10 CelloTrack Power Wiring Connection: Digital Input Connected to Ignition ...........................17
3.11 CelloTrack Power Wiring Connection: Wiring to PTO.........................................................18
3.12 CelloTrack Activation and Deactivation...........................................................................19
CelloTrack T Installation Guide
CelloTrack T Installation Guide Page 5 of 20
Copyright © 2014 by Pointer Telocation, Ltd.
1Introduction
1.1 Overview
This guide provides the necessary information for technicians to install the CelloTrack T
unit, and the CelloTrack Power unit. It describes how to install and verify the proper
functioning of the kit elements.
1.2 Abbreviations
Abbreviation
Description
FB
Front Button
GSM
Global System for Mobile communications
GPS
Global Positioning System
OTA
Over the Air
PTO
Power Take-Off
SMS
Short Message Service (GSM)
IP
Ingress Protection Rating
Ah
Amper Hour
3D
3 Dimensions
LED
Light Emitted Diode
1.3 References
All the reference documents listed in the following table can be downloaded from the
knowledge base section of the Cellocator website (www.Cellocator.com).
#
Reference
1.
Cello Family Hardware Installation Guide
2.
CelloTrack T Family Overview
3.
CelloTrack T Introduction
4.
Battery Handling Procedure for Cellocator Units
1.4 Revision History
Version
Date
Description
1.0
29/12/2013
Initial version
1.1
30/12/2013
Removing battery handling section and add
CelloTrack T Installation Guide
CelloTrack T Installation Guide Page 6 of 20
Copyright © 2014 by Pointer Telocation, Ltd.
Version
Date
Description
reference
1.2
08/07/2014
Correct LEDs names in The CelloTrack Interface
section.
Modify the Charging the Unit Battery section
CelloTrack T Installation Guide
CelloTrack T Installation Guide Page 7 of 20
Copyright © 2014 by Pointer Telocation, Ltd.
2CelloTrack Interfaces
2.1 The CelloTrack Interface
1 –FB (Front Button)
2 –GSM LED
3 –SYS LED
4 –Cradle Tamper Switch
5 –Cradle
6 –Unit Tamper Switch
7 –Connector
8 –Connector Cover
9 –Opening for cable tie
CelloTrack T Installation Guide
CelloTrack T Installation Guide Page 8 of 20
Copyright © 2014 by Pointer Telocation, Ltd.
2.2 The CelloTrack Power Interface
1. CelloTrack Power harness (pigtail)
2. FB (Front Button)
3. GSM LED
4. SYS LED
CelloTrack T Installation Guide
CelloTrack T Installation Guide Page 9 of 20
Copyright © 2014 by Pointer Telocation, Ltd.
2.3 CelloTrack Connector
The CelloTrack 6-pin connector is protected by a plastic cover, providing IP67 compliance.
The following illustration shows the CelloTrack unit with the rubber cover removed.
The connector pin out is as follows:
Pin 1 –VCC
Pin 2 –Ground (GND)
Pin 3 –General Purpose I/O 1 (GP1)
Pin 4 –General Purpose I/O 2 (GP2)
Pin 5 –TXD
Pin 6 –RXD
------------------------------------------------------------------------------------------------
NOTE: Removing the connector cover revokes the unit’s IP67 compliance. It is the
customer’s responsibility to provide proper sealing if the connector cover is removed.
------------------------------------------------------------------------------------------------
Pin 1
Pin 6
CelloTrack T Installation Guide
CelloTrack T Installation Guide Page 10 of 20
Copyright © 2014 by Pointer Telocation, Ltd.
2.4 CelloTrack Power Harness
The CelloTrack Power utilizes a 60-cm pigtail harness which ends with several free wires
and a connector for the programming cable, as described in the following table.
Pin
No.
Color
Function
Free Wire
Programming
Connector Pin No.
1.
red
VCC (9-32v)
+
2.
black
Ground (GND)
+
1
3.
orange
General Purpose I/O (GP)
+
4.
brown
General Purpose I/O (GP)
+
5.
green
TXD
2
6.
yellow
RXD
3
Inhaltsverzeichnis
