CHAINTECH CT-6SLV Bedienungsanleitung
1
Introduction
Chapter 1
Introduction
This system is an excellent choice for an Ultra compact personal computer or
performance home/office application . Because it is fully IBM's PC compatible,
supports hundreds of industrial standard software application and operating
system i.e. Window 95/98/2000/NT, OS/2 and etc. (Linux is under testing)
In addition, Gentle PC was designed for optimum size and performance. The
cutting edge special features of the system board make this system more
advancedandmorepowerfulthanotherPCsinthemarkettoday.Youcanupgrade
yoursystembyaddingmorememoryand/orAddingMR(ModemRiser)toyour
requirements as well as to communicate with other world wide network or LAN.
Even ifyouareanexperiencedcomputeruser,makesuretoatleast familiarize
yourselfwith this guide. If you are notan experienced user, spend some time to
go through the manual and to be sure that you understand the details of the
system.
gentle-pc1.p65 2000/5/22, PM 01:501
2
Chapter 1
1-1Specifications
System Dimension
-285(W)x 280(D) x 85(H) mm
Power DC Adapter
- 88W, integrated PFC(Power Factor Connector), universal voltage
selection
System Device Bay
- 3.5" FDD x 1, (or 3.5" FDD+PCMCIA combo x 1 - Optional)
Slim 5.25 CD-ROM / DVD-ROM / CD-RW x 1 for Slim type (GP1)
Standard 5.25 CD-ROM / DVD-ROM / CD-RW x 1 for Standard type
(GP2)
Mainboard 6SLV
- Supports Socket-370 processors up to 750MHz PIII(FC-PGA) and
Celeron (PPGA) up to 650MHz.
- SiS
630 AGPset with integrated
2D/3D
graphics controller
-Supports TV-OUT, DFP LCD monitor
- Two 168-pin DIMM sockets support up to 512MB SDRAM Supports
PC-133 SDRAM
- Embedded Fast Ethernet Controller Supports IEEE 802.3/802.3u 10/
100Based-T LAN
- One AMR slot (v 1.0 compliant) for soft modem riser application
-
Onboard SiS 950 I/O controller
-
Embedded System Monitor Hardware
-
2Mb Boot Block ISA Flash ROM
-
Supports HPSIR, ASKIR, and CIR function
- 4 x USB Connectors (2 front and 2 rear)
-
Optional IEEE1394 with 2 ports (1 front and 1 rear)
- Optional PCMCIA and FDD combo (Hot SWAP available) true IDE,
type II/III ATA Flash card,ATA HDD, Compact Flash and Smart
Media card (adapter required)
gentle-pc1.p65 2000/5/22, PM 01:502
3
Introduction
Chassis
- Compact size provides for Vertical and Horizontal usage
- One standard 3.5" FDD Device bay, One Standard 3.5" HDD Device
bay,andOneStandard/SlimCD-ROM/DVDROM/CD-RW
- USB, and 1394 (optional), IRDA and Audio - front access
- Internal 5cm FAN
- Customized front bezel design
Power Supply
- 88W power DC adaptor; +12V and +5Vsb output; 90-260V; 47-63Hz/
1.8A input
-Universalpowervoltageselection
-PFC (Power Factor Corrector) Class D compliant
- Fully Safety and EMI compliant
1-2 Feature
- Supports processors up to 750 MHz PIII(FC-PGA), Celeron (PPGA) up
to 650 MHz
- SiS630 Mainboard, embedded 128 bit VGA, 10/100 Base-T LAN
- Supports TV-OUT, DFP LCD monitor.
- IEEE-1394 (optional) with two ports (1 front and 1 rear)
- PCMCIA and FDD combo (Hot SWAP available!) true IDE, type II/III
ATA Flash Card, ATA HDD, Compact Flash and Smart Media card (an
adapterrequired)
1-3 Unpacking
Yoursystemcomessecurelypackedinasturdycardboardshippingcarton. Upon
receiving your computer, open the carton and carefully remove the contents.
After unpacking,carefullyinspecteachcomponenttomakesurethatnothing is
damaged.Ifanyofthesematerialisdamaged,contactthedealerfromwhomyou
purchasedyourcomputer.
Savethecartonincaseyouwanttostorethecomputerinthefuture.Youshould
alsokeepyoursalesreceiptforwarrantyverificationincaseyouneedtohaveyour
computerserviced.
gentle-pc1.p65 2000/5/22, PM 01:503
4
Chapter 1
1-4 Operating Environment
You can use your computer under a wide range of environmental conditions.
However, to ensure longevity and continued high performance, consider the
following factors when setting up your computer:
- Set the computer on a flat and stable surface. To prevent damage to the
computer's hard disk drive, avoid using the computer where it will be
exposed to strong vibration.
- Locate the computer away from electromagnetic or radio frequency
interference( for example, television/stereo sets, copier machines, and
air conditioners).
- Avoid using or storing the computer where it will be exposed to extreme
temperatures. In particular, do not leave the computer in direct sunlight,
over a radiator, or near a heat register for a long period of time. High
temperature tends to damage the electronic circuitry.
- Avoid using or storing the computer where it will be exposed to high or low
humidity. Extreme humidity can contribute to disk drive failure.
- If you are using the computer with the AC adapter, do not allow anything
to rest on the power cord. Do not place the computer where people can
step on or trip over the cord.
-Theventilationholesonthecomputerareprovidedtoprotectthecomputerfrom
overheating. To ensure reliable operation, leave about 10 cm (4 inches)
around the computer for air circulation.
- Avoid placing the computer where there will be dust or smoke in the air.
gentle-pc1.p65 2000/5/22, PM 01:504
5
Getting Started
2-1 Introducing the Gentle PC
If you are new to this kind of computer, you will find it very helpful to understand
the details for your main system unit. If you are an experienced user who is
thinking of adding features in the near future, the system unit deserves your
attention especially the all-in-one system board.
This chapter describes the components of your computer and takes a look
atwhatisinside.Whileyoumayneverhavetoopenupyoursystemor worryabout
theelectronics inside,itis toyouradvantagetounderstandingeneraltermswhat
makesyoursystemwork.Ifyouareconsideringaddingoptions,thisinformation
will be especially useful.
This chapter contains information about the following:
*
Front Panel
*
Rear Panel
*
System Board
*
Adding Memory/MR card
Chapter 2
gentle-pc2.p65 2000/5/22, PM 01:505
6
Chapter 2
2-2 Front View Panel
Thissectiondescribesindetailsofthefrontpanel'sdifferentfeatures.Thefigure
below show the location of each of these features.
Infrared (IR)
Power Button
Standard CD_ROM
IEEE1394
Speaker
MIC
USB0/1
Slim
FloppyDisk
(Optional)
PCMCIA
(Optional)
PowerLED
HDD LED
gentle-pc2.p65 2000/5/22, PM 01:506
7
Getting Started
Features
Over-writepowerbutton
Thepowerbutton onthe chassiscanbeusedasanormal powerswitch as
wellasabuttontoactivateAdvancedPowerManagementSuspend mode.
LED'Sindicator
Wheneverpowertothesystemison,thepowerLEDwillbelit.Ifyoursystem
includes a hard disk drive, the hard disk drive LED will be lit only when the
hard disk is being accessed.
CD-ROMdrive
The Front panel of the standard system has one drive bay into which the
CD-ROMdriveisinserted. (OptionalDVD,CD-RWdrive)
Floppy disk drive
The Front panel of the standard system has one drive bay into which
the floppy drive is inserted.
PCMCIAdevice(Optional)
The PCMCIA device let you extend the capability of your computer by
inserting PC cards (Hot SWAP) true IDE, type II/III ATA Flash Card, ATA
HDD, Compact Flash and Smart Media card.
IEEE1394port(Optional)
Supports 100/200/400Mbps devices of IEEE1394 such as CamCoder,
Digital Camera, printer, etc.
USBconnectors
PlugUSBdevicessuchasscanner,speaker,keyboard,mouse,HDD,etc.
Mic-in jack
Connect this jack to a micro-phone cable.
gentle-pc2.p65 2000/5/22, PM 01:507
8
Chapter 2
2-3 Rear View Panel
On the rear panel of the main system unit, you will notice a number of
plugsandI/O(inputandoutput) connectors.ThePlugs(Knownasports)arefor
connecting the power cord, monitor cable, printer cable, LAN cable, mouse or
modem cables and etc. The figure below shows the location of each of these
features.
LAN
USB0/1
Keyboard
Port
RCA
Jack
S-Video
IEEE
1394
DFP LCD
Connector
VGA Port
Power
GamePort
COM1
Telephone
Line(Optional)
Modem
Mouse
Port
(Optional)
PrinterPort
gentle-pc2.p65 2000/5/22, PM 01:508
Line_OUT
Line_IN
9
Getting Started
Features
Power
connectorforDC-inadapter
Plug this connector to a DC-in power adapter.
PS/2 Mini-DIN keyboard and mouse ports
These ports are to be connected to a keyboard and mouse.
RJ-45Eternetconnector
The connector is for connecting to a network such as LAN.
USBports
PlugUSBdevicessuchasscanner,speaker,keyboard,mouse,HDD,etc.
IEEE1394port
This port supports faster data transfer connection of devices such as
digitalcamera.
Parallel port
The parallel port is for connecting peripherals such as a printer.
Video(VGA) port
This port for connecting to video cable for an analog monitor.
DFPLCD port
Connect this port to video cable for DFP LCD monitor.
Serial RS-232 Port
This port is for connecting to serial devices such as a modem.
Game/MIDIport
Connect this port to a joy stick, game pad, etc.
AudioLine-out/Line-in
Connect line-out/in to a device such as speakers, audio amplifier etc.
gentle-pc2.p65 2000/5/22, PM 01:509
10
Chapter 2
2-4 The System Board
Thissectiondescribes thosemajor featuresoftheall-in-onesystemboard
thathavenotbeencoveredintheprevioussection.Evenifyouarenotnew
tothisinnerworkingsofcomputers,youmaywanttoreviewthisinformation.
Although you probably will not have any need to open up your main unit.
Knowingwhat is inside will helpyouto understand the technical termsthat
aresometimeusedtoexplaincomputer.Bylearningwhatisinside,youwill
seewhyyoursystemhasspecialadvantagesovermostofothercomputers
in its class.
Thesystemboard(alsoknownasthe mainormotherboard)istheheartof
thecomputer.Itcontains almost all of the electronic components that your
computer uses to operate.
While most computers need extra electronic boards ( known as add-on
option or interface cards), this computer has everything that is needed to
operate the system in one-well designed, compact, and very efficient
system board.That is why we call it an all-in-one board.
On the following pages, the major features of the system board are
illustrated.Thecomponentsnotedinthischapterarethosecomponentsthat
youmayneedtobefamiliarwithifyoueverupgradeoraddenhancements
to your system.
External Freq. JP2 JP3
Auto (default) 1 ~ 2 1 ~ 2
100MHz 1 ~ 2 2 ~ 3
133MHz
2 ~ 3 2 ~ 3
JP/CN Function JumperSetting / Connector
JP1 SDRAM Freq. 1-2:100MHz; 2-3:133MHz
JP2/JP3 CPU Bus Freq.
JP6 Clear CMOS 1-2:Normal(default); 2-3:Enable(Clear)
JP7 CIR Password Function 1-2:Disable(default); 2-3:Enable
JP8 Power on by Keyboard 1-2: Disable(default); 2-3: Enable
CN1 Front Panel
CN2/CN5 External USB
CN3 Infrared / Consumer Infrared
CN6 MIC & Speaker-out
CN8/ CN20 HDD/ FDD/ CDROM power
CN10 RCA Jack
CN11/CN14 IEEE 1394 connector (optional)
CN12 S-VIDEO
CN13 Game port
CN16 CD-in
CN17 Line-in/out
CN21 DC_IN Power connector
FAN1/2
CPU/SYSTEM cooling FAN
gentle-pc2.p65 2000/5/22, PM 01:5010
Inhaltsverzeichnis
Andere CHAINTECH Computerhardware Handbücher
Beliebte Computerhardware Handbücher anderer Marken
EMC2
EMC2 VNX Series Betriebsanleitung
Panasonic
Panasonic DV0PM20105 Bedienungsanleitung
Mitsubishi Electric
Mitsubishi Electric Q81BD-J61BT11 Bedienungsanleitung
Gigabyte
Gigabyte B660M DS3H AX DDR4 Bedienungsanleitung
Raidon
Raidon iT2300 Bedienungsanleitung
National Instruments
National Instruments PXI-8186 Bedienungsanleitung
