Challenge HTJ-2027 Bedienungsanleitung

MODEL NO. HTJ-2027

3.2L ULTRASONIC HUMIDIFIER

INSTRUCTION MANUAL

Important - Please read these instructions carefully before first

using this product and retain for future reference.

SAFETY INSTRUCTIONS

1. Install the appliance on a flat and firm surface to avoid vibration and

noise.

2. Never immerse the appliance in water or other liquids.

3. Never operate this appliance if the cable or connector is damaged or

if there is any abnormal operation.

4. Disconnect the appliance from the mains when it is not in use, or

before relocating or cleaning it.

5. Operate the appliance only at a mains supply of 220-240V~50/60Hz

6. This appliance is for indoor use only.

7. Do not put heavy objects on the appliance.

8. Do not disassemble, so as to avoid electric shock. No user

serviceable parts inside

9. Do not damage the mains cord by excessive bending or knotting, and

do not put pressure on the cable grips, as this can cause short circuit

and fire.

10. Do not put the unit close to heat-generating devices or near

flammable and dangerous materials. Do not tilt the appliance, as split

water could damage the appliance.

11. Do not use around flammable or corrosive, gases and conductive

dust.

12. This appliance can be used by children aged 8 years

and above and persons with reduced physical, sensory

or mental capabilities or lack of experience and

knowledge if they have been given supervision or

instruction concerning use of the appliance in safe way,

and understand the hazards involved. Children shall not

play with the appliance. Cleaning and user maintenance

shall not be made by children without supervision.

Do not try to repair, dismantle or modify the appliance

as this may damage the unit. If the supply cord is

damaged, it must be replaced by the manufacturer, or

its service agent or a similarly qualified person in order

to avoid a hazard.

KNOW YOUR APPLIANCE

1. Fog nozzle

2. Water tank

3. Base

4. Control Knob

5. Main Power switch

First time use

Filling the water tank:

We recommend using distilled water to avoid limescale build-up but if

using tapwater in a hardwater area we recommend regular cleaning to

avoid limescale build-up. Make sure water temperature does not exceed

40°C.

(Put the appliance down on a suitable flat horizontal surface, and where it is to

be used.)

Note: Do not use on any surface that may be damaged by water, (during refill

some water drops may be spilt)

1. Remove the white fog nozzle (1) from the top of the blue water tank. Never

remove or fill the water tank with the fog nozzle attached.

2. Remove the blue water tank from its base, and turn the tank upside-down.

3. Unscrew the filler cap with filter in the direction shown, and remove.

Take off the nozzle Lift off water tank Turn over, unscrew the cap

4. Fill from the tap or distilled water container to the top of upturned tank or as

much as required

5. Replace filler cap/filter assembly.

Fill (tap or Jug) Fasten the cap Fit tank to base as align marks

Align marks

6. Turn the tank over and wipe away any spilt water, carefully fit the tank onto the

base, taking care to align correctly noting the alignment marks on the base unit

and tank.

7. Refit fog nozzle (1)

8. Plug in to a 220-240V~50/60Hz, wall socket, and switch on with units main

power switch (5)

Note: If the indicator light is Red, water is still filling the flume (in the base

unit), wait until it turns Blue, the unit will start working.

In use:

Turn control knob (4) to set the vapor release rate depending on requirement,

including dryness or size of room.

When the tank is short of water, the indicator will turn Red once again, and vapor

release will stop. Turn off and un-plug the unit from the wall socket.

How to re-fill with water:

1. Remove the white fog nozzle from the top of the blue water tank. Never

remove or fill the water tank with the fog nozzle attached.

2. Carefully remove the blue water tank from its base, and turn the tank

upside-down.

Note: During this process the flume (in the base unit) will be full of water, lift off

the tank into a towel to catch drips if necessary.

3. Continue as step 3 (See “First time use”)

CLEANING

Always unplug the unit from the mains before commencing any cleaning in order

to avoid the risk of electric shock.

Tank cleaning

Remove the water tank (2) from the unit and unscrew the water cap. Wipe away

any limescale present with a clean soft cloth then wash it with clean water. We

recommend cleaning the water tank every 2 to 3 weeks.

Flume cleaning

If there is any limescale in the flume, wipe it with a soft cloth and wash it with

clean water.

Atomiser chip cleaning

Apply detergent to the surface of the atomiser chip and then pour in warm water

and wait for 5 minutes. Gently brush around the opening and rinse again with

clean water. Take special care not to submerge the main unit in water or splash

the controls.

Note: Only use a small amount of water to clean the atomiser chip and base unit,

do not rinse under a tap as this will damage the unit.

Maintenance of Water Filter

Remove the water filter from the unit by unscrewing. Wash the filter in warm

soapy water and rinse thoroughly. Refit the water filter.

STORAGE

If not using the unit for an extended period of time, please:

oTurn the unit off and unplug it from the mains.

oCompletely empty the water tank and wipe it clean.

oCompletely drain the base unit and wipe dry

oCover the unit and store away from direct sunlight.

TROUBLE SHOOTING

Never try to repair or dismantle the humidifier yourself. Incompetent repairs

result in loss of warranty and can endanger the user and property.

PROBLEM CAUSE

No operation and no lights Check mains plug is fully inserted and

socket switched on

Make sure the power switch (5) is turned on

Blue light, no vapour Check whether there is water in tank

Turn up adjustment knob

Lift off and refit the tank

Vapour has bad odour Unit needs cleaning and drying for 12 hours.

Small amount of vapour Atomiser chip dirty or lime scale buildup

Water being stored for too long causing lime

scale build-up.

PURCHASING REPLACEMENT FILTER

Replacement filter is available for purchase. If you would like to purchase a filter,

please phone 0843 289 9160 between the hours of 8:30am – 4:30pm, Mon-Fri.

Waste electrical products should not be disposed of with

general household waste, please recycle in accordance with local regulations.

CAUTIONS

When using this humidifier, please comply with the following safety measures:

Carefully read all the instructions, even if you are very familiar with this

product.

This humidifier is designed for use in the UK; if used in any other country

please check your supply voltage is compliant with product specifications.

Please do not use the humidifier in drafty areas and radiation areas.

Keep as far away from machinery, furniture, and electrical products.

When not in use turn off, unplug, empty the water, and dry completely.

Water must not be allowed to enter the lower section of the base unit.

Do not touch the water in the flume or parts in water when the unit is on.

Do not wash, adjust or move the humidifier without first unplugging it from

mains.

Prevent water from getting into the inside of the unit when washing.

Do not put chemicals, detergents into the atomiser as dangerous vapors can

be emitted.

While the unit is operating, do not move it otherwise water spillage and

contamination of the lower base unit may cause serious damage.

If the temperature is likely to fall below 0°C the unit must be fully emptied.

Never turn whole unit upside down while on or off, water contamination or

atomizer chip damage could occur.

Do not pull at the power cord or damage may occur, power cord can only be

replaced by the manufacturer, or its service agent or a similarly qualified

person

This product is intended for use as an indoor air humidifier, and should not

be used for any other purpose.

After use, the humidifier should be switched off by pressing the “On/Off”

button to the “Off” position.

Never operate unit without water in the tank.

Always keep the unit upright to avoid water leakage.

SPECIFICATIONS

Product Name Ultrasonic Humidifier

Model HTJ-2027

Rated voltage 220-240V~50/60Hz

Rated power 18-25W

Water tank capacity 3.2L

Rating Humidity 250ml/hr

CONNECTION TO POWER

•Before connecting, check that the voltage indicated on the appliance

corresponds with the mains voltage in your home. If this is not the case,

consult your dealer and do not use.

•This appliance may be fitted with a non-rewirable plug. If you need to change

the fuse in a non–rewirable plug, the fuse cover must be refitted. If the fuse

cover is lost or damaged, the plug must not be used until a replacement is

obtained.

•If the plug has to be changed because it is not suitable for your socket, or

becomes damaged, the appliance should be disconnected from the mains

power supply. The plug should be cut off and an appropriate plug fitted

following the wiring instructions. The removed plug must be disposed of

safely as insertion into a mains socket is likely to cause an electrical hazard.

•This equipment must be disconnected from the mains when not in use. Do

not allow this unit to be exposed to rain or moisture.

For your own safety read the following instructions carefully before

attempting to connect this unit to the mains.

You should only plug the appliance into a 220-240V AC, 50/60Hz supply.

Connecting it to other power sources may damage the appliance.

The wires in the mains lead are coloured in

accordance with the following code:

BLUE = NEUTRAL

BROWN = LIVE

IMPORTANT

The colours of the wires in the mains lead of this appliance may not correspond

with the coloured markings identifying the terminals in your plug, proceed as

follows:

Caution

To prevent electric shock disconnect from the

mains before removing the cover

•The blue wire must be connected to the terminal marked with the letter N or

coloured black

•The brown wire must be connected to the terminal marked with the letter L or

coloured red.

If a 13 Amp (BS 1363) fused plug is used it must be fitted with a 3A fuse

conforming to BS 1362 and be ASTA approved.

If in doubt contact a qualified electrician.

Inhaltsverzeichnis

Andere Challenge Luftbefeuchter Handbücher

Challenge

Challenge S35U-B Bedienungsanleitung

Beliebte Luftbefeuchter Handbücher anderer Marken

Bionaire

Bionaire CM1 Handbuch

Air-O-Swiss

Air-O-Swiss AOS 7131 Handbuch

KING

KING K 5002 Rainbow Bedienungsanleitung

Crane

Crane EE-6902 Bedienungsanleitung

Glaziar

Glaziar Ness Bedienungsanleitung

Philips

Philips DreamStation Go Abmessungen

Honeywell

Honeywell MISTMATE HUL520BC Bedienungsanleitung

Stadler Form

Stadler Form Hera Bedienungsanleitung

Hunter

Hunter 31206 Bedienungsanleitung

TaoTronics

TaoTronics TT-AH004 Bedienungsanleitung

adorini

adorini Cigar Heaven Bedienungsanleitung

Lanaform

Lanaform Aroma Bedienungsanleitung

Aprilaire

Aprilaire 800 Series Bedienungsanleitung

Pyle

Pyle SereneLife PHUMDIF8 Bedienungsanleitung

Trotec

Trotec B 200 Bedienungsanleitung

Pure Humidifier

Pure Humidifier EC Series Bedienungsanleitung

Crane

Crane EE-864 Bedienungsanleitung

air&me

air&me Solnan Bedienungsanleitung