Champion CHLED132 Bedienungsanleitung

CHLED132

USER MANUAL

EN - English

SE - Svenska

DK - Danske

NO - Norsk

FI - Suomi

Read this Manual carefully before use

Introduction

Thank you very much for your purchase of our product of LED TV. It serves as a

normal color TV and PC monitor. To enjoy your TV to the full from the very

beginning, read this manual carefully and keep it handy for ready reference.

INSTALLATION

1. Locate the TV in a room where direct light does not strike the screen.

 Totaldarknessorareectiononthepicturescreencancauseeyestrain.Soft

and indirect lighting is recommended for comfortable viewing.

2. Allow enough space between the receiver and the wall to permit ventilation.

3. Avoid excessively warm locations to prevent possible damage to the cabinet

or premature component failure.

4. This TV can be connected to 100-240V~ 50/60HZ.

5. Do not install the TV in a location near heat sources such as radiator, air-

ducts, direct sunlight, or in a place somewhere like close compartment and

close area. Do not cover the ventilation openings when using the TV.

6. The indicator light will last about 30 seconds to go out after cutting off the

electricity, during this period, you cannot repower it on until the indicator light

goes out, thanks a lot for your attention!

WARNING

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION: TO AVOID THE RISK OF ELECTRIC SHOCK.

DO NOT REMOVE COVER (OR BACK).

NO USER- SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

This symbol is intended to alert the user to avoid the risk

of electric shock, do not disassemble this equipment by

anyoneexceptaqualiedservicepersonnel.

This symbol is intended to alert the user to the presence

of important operating and maintenance instructions in

the literature accompanying the equipment.

Class I structures of equipment should be connected to

the grid power output with a protective earth connection

on the socket.Power plug as a broken appliance, broken

installations should be easy to operate.

CAUTION

High voltages are used in the operation of this product.

Do not open the product’s casing. Refer servicing

toqualiedservicepersonnel.

Topreventreorelectricalshockhazard,donotexpose

the main unit to rain or moisture, do not place objects

lledwithliquids,suchasvases,ontheapparatus.

Do not drop or push objects into the television cabinet

slots or openings. Never spill any kind of liquid on the

television receiver.

Avoid exposing the main unit to direct sunlight and other

sources of heat. Do not stand the television receiver

directly on other products which give off heat. E. g. video

cassetteplayers,Audioampliers.Donotblockthe

ventilation holes in the back cover. Ventilation is

essential to prevent failure of electrical component.

Do not squash power supply cord under the main unit or

other heavy objects.

Never stand on, lean on, push suddenly the product

or its stand. You should Pay special attention to

children.

Do not place the main unit on an unstable cart stand,

shelf or table. Serious injury to an individual, and

damage to the television, may result if it should fall.

When the product is not used for an extended period

of time, it is advisable to disconnect the AC power

cord from the AC outlet.

The LED panel used in this product is made of glass.

Therefore, it can break when the product is dropped

or applied with impact. Be careful not to be injured

by broken glass pieces in case the LED panel breaks.

Optional Conguration as below:

Connect the USB to the USB jack on the set.

NOTE

- It is only 500 mA MAX of DC current output when you connect with USB jack

- To ensure the Mobile HD works well, you should use other power supply for the Mobile

HD. And do not use the USB jack in the same time.

- It supports Mobile HD by connecting with USB jack (must more than 2 GB). The partitions

of the Mobile HD can’t be more than 4 partitions. The max partition is 2TB. It supports

Main unit description

Control Panel Button Function

VOL+: Volume up.

VOL-: Volume down.

CH+: TV channel up.

CH- : TV channel down.

MENU : Press to select the main menu.

SOURCE : Select the input signal.

POWER : Turn the TV on or off.

TV Terminal Connections

1. EARPHONE output terminal

2. VGA input terminal

3. SCART input terminal

4. PC AUDIO input terminal

5. LNB IN

6. RF antenna

7. COAXIAL output terminal

8. HDMI input terminal

9. USB input terminal

10. Mini-AV input terminal

11. Mini-YP P input terminal

12. Cl slot

Remote control

:Press this button to Turn the TV on or off.

:Press this button to mute or restore sound.

NICAM/A2 :In the TV condition, press this key to select

the stereo mode.

ASPECT : Press to adjust picture ratio.

PMODE : Select picture mode.

SMODE : Select sound mode.

0-9 : Select and switch to a channel using 0 - 9.

-/--- : Switch the program digit.

: Switch back and front between the current

and previous channels.

DISPLAY : Display TV information.

FREEZE : Press to hold the picture.

: Start to record.

(The U disk will be formatted when in burning,

   pleasedonotstoreimportantlesintheUdisk.

AUTO : Adjust the picture automatically in pc mode.

RED, GREEN, YELLOW, BLUE

:Correspond to the different colored subjects.

SLEEP : Set the sleep timer.

SOURCE : Press to change signal source.

ENTER : Enter the selected option or execute the

selected operation.

NOTE : Press this button to display “channel list” in

TV source.

MENU : Press this button to enter the main menu for

various optional adjustable setting.

EXIT : Exit the OSD (On-screen display).

CH /H : Change the channel up and down.

VOL /VOL : Adjust the volume.

SUBTITLE : Open or close subtitle.

(Used for models with DTV function only)

T.SHIFT : Press the button to pause current DTV

program and start record background

(Used for models with DTV functions only)

HOLD : Freezeamulti-pagepassageonscreenin

Teletext mode.

(Used for European region only)

REVEAL : Press this button to reveal the hidden information

in Teletext page. Press again to hide the information.