SKU 02954 Page 3
REV 04k
Use eye and ear protection7. . Always wear ANSI approved impact safety goggles.
Wear a full face shield if you are producing metal lings or wood chips. Wear an ANSI
approved dust mask or respirator when working around metal, wood, and chemical
dusts and mists.
Do not overreach8. . Keep proper footing and balance at all times. Do not reach over or
across running machines.
Maintain tools with care9. . Keep tools clean and moving parts lubricated for better
and safer performance. Follow instructions for lubricating and changing accessories.
Inspect tool cords periodically and, if damaged, have them repaired by an authorized
technician. The handles must be kept clean, dry, and free from oil and grease at all
times.
Disconnect power10. . Unplug tool when not in use.
Remove adjusting keys and wrenches11. . Check that keys and adjusting wrenches are
removed from the tool or machine work surface before plugging it in.
Avoid unintentional operation12. . Be sure hands are off power switch when not in use
and before plugging in.
Stay alert13. . Watch what you are doing, use common sense. Do not operate any tool
when you are tired.
Check for damaged parts14. . Before using any tool, any part that appears damaged
should be carefully checked to determine that it will operate properly and perform its
intended function. Check for alignment and binding of moving parts; any broken parts
or mounting xtures; and any other condition that may affect proper operation. Any
part that is damaged should be properly repaired or replaced by a qualied technician.
Do not use the tool if the power switch does not work properly.
Guard against electric shock15. . Prevent body contact with grounded surfaces such as
pipes, radiators, ranges, and refrigerator enclosures.
Replacement parts and accessories16. . When servicing, use only identical replace-
ment parts. Use of any other parts will void the warranty.
Do not operate product if under the inuence of alcohol or drugs17. . Read warn-
ing labels if taking prescription medicine to determine if your judgment or reexes are
impaired while taking drugs. If there is any doubt, do not operate the product.
Use proper size and type extension cord18. . If an extension cord is required, it must
be of the proper size and type to supply the correct current to the tool without heat-
ing up. Otherwise, the extension cord could melt and catch re, or cause electrical
damage to the tool. If you are using the tool outdoors, use an extension cord rated for
outdoor use (signied by “WA” on the jacket).
Maintenance19. . For your safety, service and maintenance should be performed regu-
larly by a qualied technician.
Do not use for aircraft purposes.20.
Note: Performance of this tool (if powered by line voltage) may vary depending on varia-
tions in local line voltage. Extension cord usage may also affect tool performance.
