Chloride CP3000 Series Bedienungsanleitung
CHLORIDE POWER PROTECTION
THREE-PHASE Uninterruptible Power System
Owner’sManual
CP3000
Series
P/N 913-537 REV C
ii
UserandOperatingManual
©Chloride Power Protection
28430 North Ballard Drive • Lake Forest • IL • 60045
Toll Free Phone 800-239-2257 • Toll Free Fax 800-833-6829
Phone 847-990-3228 • Fax 847-549-7917
iii
DECLARATION OF CONFORMITY
The manufacturer: CHLORIDE POWER PROTECTION
Head office at:
28430 North Ballard Drive
Lake Forest, IL 60045
USA
HEREBY DECLARES THAT THE PRODUCT: CP3000
CONFORMS TO THE FOLLOWING REGULATIONS:
UL1778
FCC PART 15
iv
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
THIS MANUAL CONTAINS IMPORTANT INSTRUCTIONS FOR THE CP3000 SERIES THAT
SHOULD BE FOLLOWED DURING INSTALLATION AND MAINTANANCE OF THE UPS,
BATTERIES, OPTIONS AND ACCESSERIES
v
TableofContents
INTRODUCTION
Declaration of conformity iii
Safety vii
Grounding the unit viii
FCC compliance xi
CHAPTER 1
DELIVERY AND STORAGE
Delivery 1
Unpacking 1
Handling 2
Storage 3
CHAPTER 2
PREPERATIONS FOR INSTALLATION
Environmental Conditions 4
Accessarea 5
Floor loading 6
CHAPTER 3
INSTALLATION
Installation data 7
Specifications 8
Suggested cable sizes 9
Terminations 10
Protection devices 11
Electrical connections 12
vi
Chapter 4
BATTERY
Battery connections 16
Chapter 5
OPERATION
Displaypanel 20
Indicators and buttons 21
Menu Structure 23
Menus 24
Warnings and Faults 29
Maintenance by-pass switch and power control unit breaker 30
Operatingmodes 31
Operational procedures 32
Chapter 6
COMMUNICATIONS
Interfaceslots 33
Communication slot adaptability 34
RAU/RLY/DRV 35
AS400 36
RS232 37
ManageUPSnet 38
LIFE 2000 39
Industrialcontacts 40
Chapter 7
MAINTENANCE 41
vii
Safety (English)
WARNING:
This equipment services power from more than one source. The convenience receptacles may have voltage
even when the unit is off. UPSs present a different safety issue than most electrical equipment because
removing input power from the UPS puts it into backup mode. Removing the input power from the UPS does
not remove the electrical charge. To ensure that the UPS is off, turn the inverter OFF before removing the
input power from the UPS.
CAUTION:
Operating this equipment without proper grounding may present a risk of electrical shock.
WARNING:
Dangerous voltages are present within this unit! There are no user-serviceable parts inside. Any repairs or
modifications by the user may result in out-of-warranty repair charges, unsafe electrical conditions, or
violation of electrical code. Do not remove the cover. All repairs should be done by qualified service
personnel. Voltages inside the UPS may be lethal. Internal components are powered even when the power
switch is in the OFF position. Even with the battery disconnected and the unit unplugged, energy is stored in
high voltage capacitors and represents a severe shock hazard.
Other Safety Considerations:
The system is not intended for outdoor use. The operating environment should be maintained within the
parameters stated in the manual. Keep the cabinet doors closed and locked to ensure proper cooling airflow
and to protect personnel from dangerous voltages inside the unit. The UPS system contains its own power
source. Lethal voltages are present even when the UPS is disconnected from utility power.
If service or routine maintenance is required:
Ensure all power is disconnected before performing installation or service. Ensure the area around the UPS
system is clean and uncluttered. Battery maintenance or battery replacement should be performed only by
authorized service personnel.
Observe all DANGER, CAUTION and WARNING notices affixed to the inside and outside of the
equipment.
Battery Disposal UPS batteries contain toxic and acidic materials. Disposal method must adhere to
local/national recycling laws. Dispose of the battery in one of three ways:
ATTENTION: The batteries in this UPS are recyclable. Dispose of the batteries properly.
viii
CAUTION: DO NOT dispose of batteries in a fire. The battery may explode. Do not open or
mutilate the battery or battery cabinet. Released electrolyte is harmful to the skin and eyes and is toxic.
WARNING:
Only AUTHORIZED SERVICE PERSONNEL should perform maintenance on or service the UPS system.
Grounding the Unit
CAUTION:
Interruption of the protective grounding conductor or disconnection of the protective earth terminal presents a
potential shock hazard that could result in personal injury and damage to the equipment.
WARNING:
1) An insulated grounding conductor that is identical in size, insulation material, and thickness to the
grounded and ungrounded branch circuit conductors except that it is green with or without one or more
yellow stripes is to be installed as part of the branch circuit that supplies the unit or system.
2) The grounding conductor supplied in 1) is to be grounded to earth at the service equipment or, if
supplied by a separately derived system, at the supply transformer or motor-generator set.
3) The attachment-plug receptacles in the vicinity of the unit or system are all to be of a grounding type,
and the grounding conductors serving these receptacles are to be connected to earth ground at the service
equipment.
ix
FCC Compliance
ATTENTION:
Changes or modifications to this unit not expressly approved by the party responsible or in FCC compliance
could void the user’s authority to operate the equipment. This equipment was tested and complies with the
limits for a Class A digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the UPS is operating in a commercial environment.
The UPS generates, uses, and can radiate radio frequency energy. If installation and use is not in accordance
with the instruction manual, it may cause harmful interference to radio communications.
ATTENTION:
Operation of this equipment in a residential area may cause harmful radio communications interference. The
user is responsible for correcting the interference.
The basic environmental requirements of the UPS system are:
Ambient Temperature Range: 32 – 104°F (0-40°C)
Recommended Operating Range: 68 – 77°F (20-25°C)
Maximum Relative Humidity: 95% (non-condensing)
1
DELIVERYAND STORAGE
DELIVERY
The goods have been checked thoroughly before dispatch. Immediately inspect upon receiptof thepackaging and ensure that thecontents
are undamaged. A SHOCKWATCH label has been affixed to the packaging. Red indicator indicates rough handling. If red, Note on Bill
of Lading and report immediately to the freight forwarder.
UNPACKING
Care should be taken when removing the packaging in order to avoid damaging the equipment. Check all packaging materials to ensure
that no items are discarded. Remove the packaging following the sequence illustrated in figure 1. Shipping brackets are attached to the UPS
or battery cabinets and skid. Remove the brackets by removing the shipping bolts attached to the skid and UPS or battery cabinet/s.
Figure – 1
Shipping and Handling the UPS
Chapter
1
PACAKAGING
BRACKETS ON
BOTH SIDES
REMOVE PACKAGING
SHIPPING
BOLTS
PALLET
Inhaltsverzeichnis
Andere Chloride UPS Handbücher
Chloride
Chloride CP3150 Series Bedienungsanleitung
Chloride
Chloride Desk Power Plus 1000 Bedienungsanleitung
Chloride
Chloride VA 1000 Bedienerhandbuch
Chloride
Chloride ACTIVE A0K7XAU Bedienungsanleitung
Chloride
Chloride Desk POWER 300 Bedienungsanleitung
Chloride
Chloride Desk POWER 300 Bedienungsanleitung
Chloride
Chloride EDP70 Bedienungsanleitung
Chloride
Chloride EDP70 Bedienungsanleitung
Chloride
Chloride SYNTHESIS Bedienungsanleitung
Chloride
Chloride Cool Power 600 Bedienungsanleitung
Chloride
Chloride Power Protection Active 700 Bedienungsanleitung
Chloride
Chloride Power Protection Active 700 Bedienungsanleitung
Chloride
Chloride Power Star Bedienungsanleitung
Chloride
Chloride Power Protection Active 700 Bedienungsanleitung
Chloride
Chloride SE041XAT Bedienerhandbuch
Chloride
Chloride LP061XHR Bedienerhandbuch
Beliebte UPS Handbücher anderer Marken
Pylontech
Pylontech Victron & Pylontech US5000 Bedienungsanleitung
Tecnoware
Tecnoware EVO DSP PLUS MM 6.8 Bedienungsanleitung
Mecer
Mecer ME-1000-WTU Bedienungsanleitung
Mustek
Mustek PowerMust 530(B) Plus Installations- und Betriebshandbuch
Emerson
Emerson Liebert NXL series Bedienungsanleitung
MAKELSAN
MAKELSAN BOXER SERIES Bedienungsanleitung
