Christie Christie One Mount Bedienungsanleitung

Installing a Christie One Mount Instruction Sheet 1

020-101410-05 Rev. 1 (09-2016)

Installing a Christie One

Mount/Christie One Mount

Plus

This document provides instructions for installing the Christie One Mount or Christie One Mount Plus

and optional accessories to mount Christie projectors to a ceiling or truss.

Safety precautions

Tools required

• 5mm hex key

• 3mm hex key

Parts Lists

Christie One Mount (P/N: 108-506102-XX)

Christie One Mount Plus (P/N: 140-117100-XX)

Christie One Mount Extender Rod (P/N: 121-125109-XX)

Christie One Mount Rigging Kit (P/N: 121-126100-XX)

Prerequisites

• Christie One Mount maximum projector weight limit is 25 kb (55 lbs).

• Christie One Mount Plus maximum projector weight limit is 45 kg (99 lbs).

Failure to comply with these safety precautions may result in serious injury, or even death.

• Only Christie qualified technicians are permitted to open product enclosures.

• SHOCK HAZARD! Disconnect the from AC before moving, servicing, cleaning, removing

components, or opening any enclosure.

• A minimum of two people or appropriately rated lift equipment is required to safely lift,

install, or move the product.

• FIRE HAZARD! Do not install near any devices that produce heat such as amplifiers,

radiators, heat registers, or stoves.

• Do not exceed the maximum load capacity of the product.

• Do not install on a structure susceptible to vibration, movement, or change of impact.

Installing a Christie One Mount/Christie One Mount Plus

Installing a Christie One Mount Instruction Sheet 2

020-101410-05 Rev. 1 (09-2016)

• Mount the ceiling plate to a structure capable of handling the combined maximum weight of the

projector and the mount.

• The installation of the ceiling mount and supporting structure must meet local building codes.

• Attach the ceiling plate to the supporting structure using all four holes (mounting screws and

bolts are not included with the mount).

• If mounting to ceiling studs, ensure that the mounting screws are anchored into the center of

the ceiling studs. Christie recommends using an edge-to-edge stud finder.

• Be aware of the mounting environment. If drilling and/or cutting into the mounting surface,

always make sure no electrical wires are in the wall.

• To prevent image vibration, Christie recommends not installing the fog filters on HS Series

projectors mounted with Christie One Mount Plus.

Installing the Christie One Mount/Christie One

Mount Plus

Follow these instructions to install a Christie One Mount/Christie One Mount Plus.

1. Refer to the projector’s User manual to determine the correct mount to use.

2. Position and securely fasten the ceiling plate to the ceiling.

3. Insert the calibration device into the ceiling plate and secure with the two setscrews.

4. Position the projector adaptor plate with adjustable arms on the bottom side of the projector.

Installing a Christie One Mount/Christie One Mount Plus

Installing a Christie One Mount Instruction Sheet 3

020-101410-05 Rev. 1 (09-2016)

5. Secure the adjustable arm plate to the projector by positioning the screws of the plate with the

designated holes on the bottom of the projector.

• GS Series projectors must use M6-1.0 x 40 mm long screws with two washers and rubber

bushings. Torque the screws to 16 Nm.

• H/HS Series projectors must use M8-1.25 x 50 mm long screws with two washers and

torque to 38 Nm.

6. Ensure that the washer and rubber bushings are installed on the M6 bolts when using these

with the Christie One Mount Plus (140-117100-XX).

7. Use the four brass leveling screws to attach and level the adapter plate on the projector.

Projector standoffs are adjustable spacers which can be used to level the arms of the Christie

One Mount. The projector standoffs also ensure screws are centered when the projector is

attached to the mount.

8. Ensure the quick-release ring is seated in the slotted groove.

Installing a Christie One Mount/Christie One Mount Plus

Installing a Christie One Mount Instruction Sheet 4

020-101410-05 Rev. 1 (09-2016)

Use the quick-release for rapidly attaching the projector to the mount.

9. Secure the projector to the ceiling mount with the quick-release.

Ensure the projector is locked into place by verifying that the spring lock pin is seated in the calibration

device slot. A clicking sound indicates the lock pin is seated properly in the holder. Ensure no gap exists

between the ceiling plate collar and calibration device.

10. Tighten the setscrew.

Installing a Christie One Mount/Christie One Mount Plus

Installing a Christie One Mount Instruction Sheet 5

020-101410-05 Rev. 1 (09-2016)

11. Calibrate and position the mount with the four adjustment knobs.

12. In the case of heavy loads, use a hex key to calibrate the projector position.

13. Tilt and roll knobs differ based on the orientation of the projector on the mount.

14. To eliminate vibration or movement during operation tighten the four button screws.

Installing a Christie One Mount/Christie One Mount Plus

Installing a Christie One Mount Instruction Sheet 6

020-101410-05 Rev. 1 (09-2016)

Installing the Christie One Mount Extender Rod

The extender rod is an accessory used to adjust the distance between the projector and the

mounting location.

1. Install the extender rod between the ceiling plate/rigging kit and calibration device.

2. Secure the extender rod to the calibration device/rigging kit and ceiling plate by tightening all

four setscrews.

3. To install the extended mount follow the instructions for Installing the Christie One Mount/

Christie One Mount Plus on page 2.

Installing a Christie One Mount/Christie One Mount Plus

Installing a Christie One Mount Instruction Sheet 7

020-101410-05 Rev. 1 (09-2016)

Installing the Christie One Mount Rigging Kit

The rigging kit is an accessory used to mount to a truss or similar structure.

1. Install the rigging kit to the calibration device or extender rod.

2. Secure the rigging kit by tightening the two setscrews.

Product details

The following shows the product details for Christie One Mount and Christie One Mount Plus, including

Installing a Christie One Mount/Christie One Mount Plus

Installing a Christie One Mount Instruction Sheet 8

020-101410-05 Rev. 1 (09-2016)

the extender rods.

164

Standard Mount

DIA. 187

160

DIA. 9

212

Plus Mount

Installing a Christie One Mount/Christie One Mount Plus

Installing a Christie One Mount Instruction Sheet 9

020-101410-05 Rev. 1 (09-2016)

Technical support

North and South America: +1-800-221-8025 or [email protected]

Europe, Middle East, and Africa: +44 (0) 1189 778111 or [email protected]

Asia Pacific: [email protected]

418 mm Collapsed

200

618 mm Full extended

Andere Handbücher für Christie One Mount

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Christie Projektorzubehör Handbücher

Christie

Christie DPS Series Betriebsanleitung

Christie

Christie Brio Bedienungsanleitung

Christie

Christie D4K40-RGB Gebrauchs- und Pflegehandbuch

Christie

Christie 118-131106 Series Bedienungsanleitung

Christie

Christie Vivid Blue 38-VIV301-01 Bedienungsanleitung

Christie

Christie 003-006191-01 Bedienungsanleitung

Christie

Christie Brio Bedienungsanleitung

Christie

Christie CoreIII Series Montageanleitung

Christie

Christie ChristieNet Wireless Presentation Portal Bedienungsanleitung

Christie

Christie 163-126100 Series Bedienungsanleitung

Christie

Christie One Bedienungsanleitung

Christie

Christie Dual LOS Bedienungsanleitung

Christie

Christie Brio Team+ Bedienungsanleitung

Christie

Christie 104-006101-XX Bedienungsanleitung

Christie

Christie 140-133108 Series Bedienungsanleitung

Christie

Christie RPMWU-RPMSP-LED01 Bedienungsanleitung

Christie

Christie Brio Enterprise Bedienungsanleitung

Christie

Christie LX32 Leitfaden

Christie

Christie IMB-S3 Bedienungsanleitung

Christie

Christie One Bedienungsanleitung

Christie

Christie QwikRig rigging frame Bedienungsanleitung

Christie

Christie P100 Bedienungsanleitung

Christie

Christie LX380 Bedienungsanleitung

Christie

Christie CIC Montageanleitung

Beliebte Projektorzubehör Handbücher anderer Marken

Optoma

Optoma BX-AL133B Bedienungsanleitung

PEERLESS

PEERLESS PE 1120 Leitfaden

Osram

Osram SIRIUS HRI Series Handbuch

Presentation Switchers

Presentation Switchers PS111 Bedienungsanleitung

Kramer

Kramer VIA GO Bedienungsanleitung

Yamaha

Yamaha PJL-112 Stücklistenhandbuch

Mitsubishi Electric

Mitsubishi Electric 236CB Betriebsanleitung

Epson

Epson BrightLink 475Wi Bedienungsanleitung

Acer

Acer WP100 Bedienungsanleitung

i3 i3board Bedienungsanleitung

CHIEF

CHIEF HB-43E Bedienungsanleitung

Biamp

Biamp Modena Hub Service-Handbuch

NEC

NEC MP10RX Bedienungsanleitung

Panamorph

Panamorph DCR-S3 Bedienungsanleitung

Exact solutions

Exact solutions FRAME-EVO-P10 Bedienungsanleitung

CHIEF

CHIEF VCM103S Bedienungsanleitung

InFocus

InFocus LP70+ Leitfaden

Sharp

Sharp AN-PH20EZ Bedienungsanleitung