Christie D13HD2-HS Bedienungsanleitung

Installing the ultra short

throw lens

The ultra short throw (UST) lens allows you to position your projector as close as possible to the

screen.

Affected products

The following products are affected:

• D13HD2-HS

• D13WU2-HS

• D16HD-HS

• D16WU-HS

• D20HD-HS

• D20WU-HS

• Christie 4K7-HS

• Christie 4K10-HS

Required components

The following components are required.

• UST lens bracket kit (P/N: 003-006916-XX)

• 3 mm Allen key

• 5 mm Allen key

• 6 mm Allen key

• Hexagon wrench

Mounting the lens support bracket

The lens holders are replaceable parts marked with an A for the HS Series 2K models and T for the

4K7-HS and 4K10-HS models.

1. Turn on the projector and perform a lens calibration.

• If you have a non-ultra short throw lens (standard lens) installed, perform a lens

calibration by selecting Menu > Configuration > Lens Settings > Lens Calibration.

• If you do not have a non-ultra short throw lens, complete the following steps:

Installing the Ultra Short Throw Lens Instruction Sheet 1

020-103312-03 Rev. 1 (10-2020)

a. Connect to the projector using RS232 or Ethernet (default IP address 192.168.0.100).

b. Perform a lens calibration by sending the serial API command (LCB+HOME 1) to the

projector.

2. Turn off the power to the projector.

3. Remove the non-ultra-short throw lens, if installed.

4. Before mounting the bracket, align the mark lines as shown below.

5. If the two highlighted M4 x L22 screws have tightened, loosen the screws by one turn.

6. Flip the projector onto its top side.

7. Secure the support base (without lens bracket attached) to the projector.

• For HS Series 2K, fasten two M8 x 16 screws and washers. For the front screw, slide to

hook the projector front cover and then secure the screw.

Installing the ultra short throw lens

Installing the Ultra Short Throw Lens Instruction Sheet 2

020-103312-03 Rev. 1 (10-2020)

• For 4K7-HS and 4K10-HS, secure at the front position and fasten four M8 x 16 screws and

washers.

8. Flip the projector over.

9. Install the ultra short throw lens.

10. Attach the lens bracket to the support base using the location hole (A) and pin (B).

• For HS Series 2K, make sure to use the lens bracket marked with an A.

Installing the ultra short throw lens

Installing the Ultra Short Throw Lens Instruction Sheet 3

020-103312-03 Rev. 1 (10-2020)

• For 4K7-HS and 4K10-HS, make sure to use the lens bracket marked with a T.

11. Lock the M4 x L10 screws (A for HS Series 2K and T for 4K7-HS and 4K10-HS) until tight and

then loosen the screws by one turn.

Installing the ultra short throw lens

Installing the Ultra Short Throw Lens Instruction Sheet 4

020-103312-03 Rev. 1 (10-2020)

12. Shift the lens bracket to fit the L-UST lens neck.

Make sure the lens bracket plate (A) does not tilt with the lens holder (B).

13. Use two M4 x L10 screws to secure the lens fixture to the lens bracket.

Installing the ultra short throw lens

Installing the Ultra Short Throw Lens Instruction Sheet 5

020-103312-03 Rev. 1 (10-2020)

14. Tighten the two M4 x L10 screws from step 11.

15. Tighten the two M4 x L22 screws from step 2.

Adjusting the ultra short throw lens

After mounting the lens support bracket, adjust the ultra short throw lens.

1. Turn on power to the projector.

Installing the ultra short throw lens

Installing the Ultra Short Throw Lens Instruction Sheet 6

020-103312-03 Rev. 1 (10-2020)

2. Loosen by one turn the two M4 x L22 screws shown below.

3. Perform a lens calibration.

4. To adjust the image position, use the Lens Shift function.

Do not use the Lens Shift function when the two M4 x L22 screws are locked.

5. Tighten the two M4 x L22 screws from step 2.

If the tilt of the lens is too significant to fine-tune, gently lift up the lens to reduce the image

offset before locking the screws.

6. Adjust the two M6 screws to fine-tune image position.

7. To fine tune the lens roll angle, adjust the M6 screw using a hexagon wrench.

Installing the ultra short throw lens

Installing the Ultra Short Throw Lens Instruction Sheet 7

020-103312-03 Rev. 1 (10-2020)

8. Loosen by one turn the two M4 screws on the lens supporter, shown below.

9. Adjust the boresight.

For information on how to adjust boresight, refer to the product Installation and Setup guide.

10. Tighten the two screws from step 8.

11. To ensure the Lens Shift function cannot be executed after the boresight has been adjusted,

from the on-screen display, navigate to Configuration > Lens setting > Lock all Lens

Motors and select Locked.

Technical support

Technical support for Christie products is available at:

• North and South America: +1-800-221-8025 or [email protected]

• Europe, Middle East, and Africa: +44 (0) 1189 778111 or [email protected]

• Asia Pacific

• Australia: +61 (0)7 3624 4888

• China: +86 10 6561 0240

• India: +91 (80) 6708 9999

• Japan: 81-3-3599-7481

• Singapore: +65 6877-8737

Installing the ultra short throw lens

Installing the Ultra Short Throw Lens Instruction Sheet 8

020-103312-03 Rev. 1 (10-2020)

• South Korea: +82 2 702 1601

•Christie Professional Services: +1-800-550-3061 or [email protected]

Installing the ultra short throw lens

Installing the Ultra Short Throw Lens Instruction Sheet 9

020-103312-03 Rev. 1 (10-2020)

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Christie Projektor Handbücher

Christie

Christie LW40U Bedienungsanleitung

Christie

Christie HS 2K Series Bedienungsanleitung

Christie

Christie DWU951 Bedienungsanleitung

Christie

Christie M Series Bedienungsanleitung

Christie

Christie Christie DS+655 Bedienungsanleitung

Christie

Christie LW401 Bedienungsanleitung

Christie

Christie LX45 Bedienungsanleitung

Christie

Christie LWU701i Bedienungsanleitung

Christie

Christie M Series Bedienungsanleitung

Christie

Christie LX1200 Bedienungsanleitung

Christie

Christie Cinema 4K-RGB CP4315-RGB Bedienungsanleitung

Christie

Christie CP2000-XB Bedienungsanleitung

Christie

Christie Vivid Blue 38-VIV301-01 Bedienungsanleitung

Christie

Christie DS+650 Bedienungsanleitung

Christie

Christie 38-VIV210-01 Bedienungsanleitung

Christie

Christie Projector Bedienungsanleitung

Christie

Christie Cinema 4K-RGB CP4315-RGB Montageanleitung

Christie

Christie M Series Bedienungsanleitung

Christie

Christie LWU620i Bedienungsanleitung

Christie

Christie LX400 Bedienungsanleitung

Christie

Christie Boxer 30 Benutzerhandbuch

Christie

Christie Solaria CP2210 Bedienungsanleitung

Christie

Christie DWX555-GS Bedienungsanleitung

Christie

Christie Roadie HD+35K Bedienungsanleitung

Beliebte Projektor Handbücher anderer Marken

iEmmet

iEmmet MP-312 Bedienungsanleitung

Epson

Epson VS400 Bedienungsanleitung

Sony

Sony VPL-HS10 Marketing Specifications & Features Bedienungsanleitung

Sony

Sony VPL-HW65ES Service-Handbuch

Toshiba

Toshiba TLP-791U Bedienungsanleitung

Philips

Philips LC1341 Referenzhandbuch

Panasonic

Panasonic PTL735NTU - LCD PROJECTOR-NETWORK IB Bedienungsanleitung

NEC

NEC NP600S EDU Bedienungsanleitung

BenQ

BenQ SH753P Bedienungsanleitung

Eiki

Eiki EK-623U series Bedienungsanleitung

Epson

Epson PowerLite Pro Cinema 6020UB Bedienungsanleitung

Epson

Epson PowerLite Home Cinema 705HD Bedienungsanleitung

Navitar

Navitar FX Bedienungsanleitung

InFocus

InFocus LitePro 560 Bedienungsanleitung

Sony

Sony SRX-R815P Bedienungsanleitung

Vivitar

Vivitar DP1500 X Bedienungsanleitung

Acer

Acer C20 Series Bedienungsanleitung

Asus

Asus ZenBeam Latte Bedienungsanleitung