Christie Solaria CP2210 Service-Handbuch

Replacing the ICP Battery Technical Bulletin 1

020-200313-01 Rev. 1 (02-2015)

Replacing the ICP Battery

This document provides instructions for replacing the Integrated Cinema Processor (ICP) battery. If

the ICP battery fails, projector time settings can become inaccurate and automated events might

not run as expected.

The ICP battery replacement takes approximately 30 minutes. Christie recommends replacing the

battery every five years.

Affected products

• Christie CP2210

• Christie CP2215

• Christie CP2220

• Christie CP2230

• Christie CP4220

• Christie CP4230

• Christie Solaria One

• Christie Solaria One+

Safety precautions

Prerequisites

• Replacement ICP battery (type BR2330)

• A USB flash drive with a minimum capacity of 8GB

• Texas Instruments ICP and Enigma Control Program

To request a copy of the software, contact Christie Technical Support.

Technical Bulletin

ELECTRICAL SHOCK HAZARD! Always turn off, disconnect, and disengage all power sources to the

projector before servicing. Failure to comply results in death or serious injury.

Only Christie accredited service technicians are permitted to open any enclosure on the projector and

only if the AC power has been fully disconnected. Failure to comply could result in minor or moderate

injury.

To prevent damage by static electricity, wear an anti-static wrist strap and follow anti-static protocols

when replacing the ICP battery.

Replacing the ICP Battery Technical Bulletin 2

020-200313-01 Rev. 1 (02-2015)

Replace the ICP battery

The ICP is installed in the card cage located on the operator (left) side of the projector facing the

lens. This procedure describes the replacement of an ICP battery in a Christie CP2215 projector. For

removal instructions that are specific to your projector model, see the projector Service Manual.

To prevent damage to the projector or personal injury, complete the procedures in the order they

are written.

Backup projector settings and information

This procedure is optional, but is recommended to make sure you can recover your data if an error

occurs.

1. Insert a USB flash drive into the USB port on the side of the projector touch panel controller

(TPC).

2. Log on to the projector with service permissions.

3. On the TPC, tap Menu > Service Setup > File Management.

4. Tap Backup.

5. When the backup is complete, remove the USB flash drive and store it in a secure location.

Prepare the projector for service

1. If the lamp is on, tap the lamp off ( ) icon on the projector TPC to turn it off.

2. Allow the lamp to cool for a minimum of 15 minutes.

3. Tap and hold the power off ( ) icon to turn the projector off.

4. Disconnect the projector from AC power.

Remove the ICP

1. Loosen the seven screws that secure the top lid to the projector.

2. Lift the lid up from the rear of the projector and set it aside.

Replacing the ICP Battery Technical Bulletin 3

020-200313-01 Rev. 1 (02-2015)

3. Unlock the high security lid with the high security key.

4. Lift the lid up and out and set it aside.

5. Reach into the projector and pull the lever to release the security ring.

6. Lower the security ring so it is out of the way.

7. Pull the ejectors on the ICP outward.

8. Pull the ICP outward out of the card cage and set it on a flat, stable surface.

Replacing the ICP Battery Technical Bulletin 4

020-200313-01 Rev. 1 (02-2015)

Remove and replace the ICP battery

1. Insert a flat screwdriver under the battery (A) and carefully lift it upward until it separates from

the retaining clip.

2. Remove the battery and set it aside.

Follow your local regulations for battery disposal.

3. Insert the new battery beneath the retaining clip.

Reinstall the ICP and reassemble the projector

1. Insert the ICP with even pressure into the card cage until it is firmly seated on the backplane.

2. Push the ejectors on the ICP faceplate inward to lock the ICP in position.

3. Replace the high security ring.

4. Replace the high security lid and lock it with the high security key.

5. Place the top lid on the projector and tighten the seven screws to secure it in position.

6. Reconnect the projector to AC power.

7. On the projector TPC, tap and hold the green power ( ) icon.

Activate marriage

You must complete marriage to display encrypted content and to comply with the Digital Cinema

Initiatives (DCI) specification.

1. Log on to the projector with marriage permissions.

2. Tap Menu > Service Setup > LD Marriage.

3. Complete the Marriage wizard.

4. Click Finish.

Replacing the ICP Battery Technical Bulletin 5

020-200313-01 Rev. 1 (02-2015)

Reset the ICP real-time clock

1. Download and install the ICP and Enigma Control Program on a computer that you can connect

to the projector.

2. Connect one end of an Ethernet cable to the Ethernet port on the computer with the ICP and

Enigma Control Program.

3. Connect the other end of the Ethernet cable to the Ethernet port on the projector.

4. Click Start > All Programs > ICP and Enigma Control Program.

5. On the Connection tab, select External Ethernet Port.

6. In the Ethernet Configuration area, enter the projector IP address in the IP Addr field and

press Select.

7. In the Login area, click Login.

8. Complete the User ID and Password fields and click OK.

9. Click OK.

10. Click the Sys-Config tab.

11. Click RTC Time.

12. In the Set Time area, select PC Time (UTC) and click Set RTC Time.

13. Close the ICP and Enigma Control Program.

Restore projector settings and information

This procedure is optional. Complete this procedure if an error has occurred and you need to

recover projector settings and other data.

1. Log on to the projector with service permissions.

2. Insert the USB flash drive with the backup into the USB port on the side of the projector.

3. Tap Menu > Service Setup > File Management.

4. Tap Browse to the right of the File to restore field.

5. Select the location of the upgrade file in the Drive Letter list.

6. Browse to the location of the upgrade file in the Folder list.

7. Tap the upgrade file and then tap Open.

8. Select the type of file to restore in the Select type list.

9. Tap Restore.

10. Tap Yes.

Replacing the ICP Battery Technical Bulletin 6

020-200313-01 Rev. 1 (02-2015)

Technical support

North and South America: +1-800-221-8025 or [email protected]

Europe, Middle East, and Africa: +44 (0) 1189 778111 or [email protected]

Asia Pacific: [email protected]

Christie Managed Services: +1-800-550-3061 or [email protected]

Andere Handbücher für Solaria CP2210

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Christie Projektor Handbücher

Christie

Christie Solaria CP2210 Bedienungsanleitung

Christie

Christie Cinema 4K-RGB CP4315-RGB Montageanleitung

Christie

Christie RPMSP-500Xe 38-GFX208-xx Bedienungsanleitung

Christie

Christie DWU1052 Bedienungsanleitung

Christie

Christie Mirage S+ Bedienungsanleitung

Christie

Christie Captiva Touch Bedienungsanleitung

Christie

Christie RPMSP-D120U Montage- und Bedienungsanleitung

Christie

Christie G Series Benutzerhandbuch

Christie

Christie M RGB Series Montageanleitung

Christie

Christie Mirage 4K40-RGB Bedienungsanleitung

Christie

Christie CP2420-Xe Bedienungsanleitung

Christie

Christie H Series Bedienungsanleitung

Christie

Christie Roadie 25K Bedienungsanleitung

Christie

Christie Christie LX66A Bedienungsanleitung

Christie

Christie D4K2560 Bedienungsanleitung

Christie

Christie CP4230 Bedienungsanleitung

Christie

Christie Mirage WQ-L Bedienungsanleitung

Christie

Christie CP2320-RGB Montageanleitung

Christie

Christie LW751i Technisches Dokument

Christie

Christie LX501 Kurzanleitung

Christie

Christie LX1000 Bedienungsanleitung

Christie

Christie LHD700 Bedienungsanleitung

Christie

Christie DS Series Bedienungsanleitung

Christie

Christie D4K25 Bedienungsanleitung

Beliebte Projektor Handbücher anderer Marken

iEmmet

iEmmet MP-312 Bedienungsanleitung

Epson

Epson VS400 Bedienungsanleitung

Sony

Sony VPL-HS10 Marketing Specifications & Features Bedienungsanleitung

Sony

Sony VPL-HW65ES Service-Handbuch

Toshiba

Toshiba TLP-791U Bedienungsanleitung

Philips

Philips LC1341 Referenzhandbuch

NEC

NEC NP600S EDU Bedienungsanleitung

BenQ

BenQ SH753P Bedienungsanleitung

Eiki

Eiki EK-623U series Bedienungsanleitung

Epson

Epson PowerLite Pro Cinema 6020UB Bedienungsanleitung

Epson

Epson PowerLite Home Cinema 705HD Bedienungsanleitung

Navitar

Navitar FX Bedienungsanleitung

InFocus

InFocus LitePro 560 Bedienungsanleitung

Sony

Sony SRX-R815P Bedienungsanleitung

Vivitar

Vivitar DP1500 X Bedienungsanleitung

Asus

Asus ZenBeam Latte Bedienungsanleitung

Epson

Epson PowerLite 810p Bedienungsanleitung

BOXLIGHT

BOXLIGHT CP-322i/CP-634i Bedienungsanleitung