Getting Familiar with Your Bluetooth
Smart Dongle
Cino’s smart dongle is an instant plug-and-play solution that connects
FuzzyScan Bluetooth imagers with a host device that lacks Bluetooth
capabilities. Incorporating a Bluetooth® v4.0 radio, the smart dongle delivers
a wireless communication range of over 100 meters. It is compatible with
most operating systems and no separate driver installation is required when
the imager is used in USB HID Standard mode.
This document serves as a quick reference guide for the dongle’s installation
and operation. Please visit www.cino.com.tw for details.
Installation
Pairing Bluetooth Imager with Dongle
Turn on your FuzzyScan Bluetooth imager. Make sure it is in an unpaired
state: its status indicator should emit alternating red-green flashes.
Otherwise, scan the “Uninstall” command barcode to release any prior
pairing.
Initiate the dongle-imager pairing process by scanning the dongle’s
“Quick Pair” barcode label. Your imager will then produce clicking sounds,
and its link indicator will flash blue rapidly. During this process, your
dongle will continue to emit red and green lights.
Upon successful pairing, the scanner will beep 4 times in ascending tone,
and its link indicator will flash blue every 2.5 seconds. The dongle’s
power/pairing indicator will be a steady blue.
The Quick Pair barcode on your dongle is designed for “Pair Mode”,
i.e. the dongle can only pair with one imager at a time.
The dongle's default host interface setting is USB HID. To change this
setting to USB COM, please first install the USB2COM driver on your
host device.
Status Indicator
Power/Pairing Indicator
Quick Pair Command Barcode
Cap
Remove the dongle’s cap.
Plug the dongle into your host device’s USB port.
Supply power to the dongle by turning on your host
device. The power/pairing indicator will flash blue once
and its status indicator will emit alternating red-green
flashes (“unpaired state”) when powered on.
