Clarion OHM102/OHM153 Service-Handbuch

Warning!

The Clarion OHM102/OHM153 overhead monitor systems are designed for strictly for rear seat

entertainment. Viewing the monitor while operating a motor vehicle can result in serious injury

and/or property damage. Clarion is not responsible for any injury and/or property damage as a

result of the improper use or viewing of the monitor.

Welcome!

Thank you for purchasing the Clarion OHM102/OHM153 overhead monitor system. These

monitors are engineered with advanced technological designs and components for the best

picture quality and convenience. These overhead monitor systems incorporate a built-in

audio/video switcher, PIP (picture in picture), and split screen operation. The split screen

operation will allow 2 different A/V sources to be enjoyed simultaneously through dual band IR

wireless headphones.

Features:

. • TFT active matrix display

. • Left and Right swivel mechanism (OHM102 only)

. • Built-in dual band IR transmitter for wireless headphones

. • Built-in PIP/Split Screen functions

. • External A/V Game Port (Included)

. • Built-in 4 source A/V input switcher

. • Built-in dome lights

. • Front panel menu, picture, and source controls

. • OSD (On Screen Display) FM modulator control (FM200 not included)

. • Selectable screen modes: Normal, Zoom, Full, and Wide

. • Universal mounting bracket

. • 1/2” rubber gasket

. • Two dual band IR wireless headphone (WH204H included)

. • IR remote control

. • Supports both NTSC and PAL video signals

Introduction

The Clarion OHM102/OHM153 are exclusively designed for the ultimate in rear seat mobile video

entertainment. With the built-in A/V switcher, any Clarion video source or game station can be

enjoyed on these monitors. The built-in A/V switcher also incorporates PIP (picture in picture) and

split screen operation. For added convenience, the front panel controls allows for menu, picture,

source, and FM modulator selections. FCC Approval The OHM102/OHM153 has been tested and

found to comply within the limits of Part 15B of the FCC rules. These limitations are designed to

provide reasonable protection against harmful interference in a residential installation. This

equipment generates and uses radio frequency energy and if not installed and used in

accordance with the instructions, it may cause harmful interference to radio communications.

There is no guarantee that interference will not occur in a particular installation. If this equipment

does cause harmful interference to a radio or television reception, turn off the equipment and

contact a local Clarion dealer for assistance. Changes or modifications to this product not

approved by the manufacturer will void the warranty and violate FCC Approval.

Table of contents

Opening the Overhead Monitor . . . . . . . . . 4

Precautions . . . . . . . . . . . . . . . . . . . . . . . . 5

Care And Maintenance . . . . . . . . . . . . . . . 5

Operating OHM102/153 Monitor . . . . . . . . 6-9

Operating the Remote Control . . . . . . . . . .10-11

Operating the Headphones . . . . . . . . . . . . 12

Installation Instructions . . . . . . . . . . . . . . . 13-15

Complete System Diagram . . . . . . . . . . . . 16-17

Package Contents . . . . . . . . . . . . . . . . . . . 18

Troubleshooting . . . . . . . . . . . . . . . . . . . . . 18

Specifications . . . . . . . . . . . . . . . . . . . . . . 19

Warranty Information . . . . . . . . . . . . . . . . . 20-21

Opening the Overhead MonitorOpening the Overhead Monitor

Press the “OPEN” button to release the overhead monitor. Gently push down on the bottom of the

monitor until it reaches the desired position. The monitor will turn on automatically when it is fully

open.

Press the “OPEN” button to release the overhead monitor. Gently push down on the bottom of the

monitor until it reaches the desired position. The monitor will turn on automatically when it is fully

open.

Note: The vehicle’s ignition key must be “ON” or Accessory (ACC) position for the monitor to

have power.

Note: The vehicle’s ignition key must be “ON” or Accessory (ACC) position for the monitor to

have power.

Precautions

• These overhead monitor systems are designed for use in 12V DC negative ground vehicles.

• Do not operate the overhead monitor system in ways other than described in this manual. Doing

so may result in damage to the monitor system and/or vehicle, along with voiding the warranty.

• SAFETYFIRST! These overhead monitor systems are designed for rear seat

entertainment only. Do not install in/on dashboard or anywhere else that would allow

the operator of the vehicle to view the monitor.

• Do not disable or modify the overhead monitor system. Doing so may damage the

monitorsystem, along with voiding the warranty.

• Keep all liquids away from the overhead monitor system.

• Do not leave the overhead monitor system open when not in use. Direct sunlight can cause the

monitor not to function properly.

• In extreme hot and cold temperatures, the movement of the picture may appear to move slow

and dark. The overhead monitor system will function properly once the temperature rises.

• Do not hang or hang items from the overhead monitor system. If you have any questions or

problems concerning the monitor that are not covered in

this manual, please consult a local Clarion dealer for assistance.

Before installing this overhead monitor system, please check you local traffic rules and

regulations.

Care And Maintenance

Keep all liquids away from the OHM102/OHM153 overhead monitor systems. Liquids inside the

monitor will damage the electronics, and result in electrical shock. In the event that the unit

should become wet, turn off the power and contact a local Clarion dealer for assistance. To clean

the monitor, use a clean soft cloth and gently wipe the screen. If possible, use specially designed

“monitor wipes” to clean the screen.

OPERATING OHM102/OHM153 MONITOR

In the event a problem arises with the OHM102/OHM153 overhead monitor system, do not

attempt to disassemble or repair the monitor yourself. Opening or attempting to service the

monitor will void the warranty; instead contact a local Clarion dealer for assistance.

Monitor Control Panel

1. PIP (Picture In Picture) button

Press the PIP button to enable Picture In Picture or split screen operation.

2. MENU button

Press the MENU button to access the monitor adjustments.

FM MOD ON/OFF>Brightness>Contrast>Saturation>Hue>Sub Size>

Sub Position> Default Reset.

3. DOWN button

MENU, then DOWN selects item

to be adjusted.

DOWN: Also selects Main AV source.

4. UP button

MENU, then UP selects item to be adjusted. UP: Also

selects Sub Screen AV source.

5. DIMMER button

Press to adjust the brightness of the screen.

6. MODE button

Press to change the screen format: Normal, Full, Zoom, and

Wide.

7. OPEN button

Press to open the overhead monitor.

8. IR Transmitter for wireless headphones and IR Receiver for remote control

Note: Also functions as the dome light ON/OFF switch for the OHM102 only.

9. Dome light switch

Dome light switch for the OHM153

10. Dome lights

Closing the Overhead Monitor

Gently push the backside of the monitor until it clicks into the overhead monitor housing.

The monitor will turn off automatically when it is returned to the closed position.

Note: Do not place any objects between the monitor and the monitor housing, this can result

in serious damage to the monitor.

Adjusting the Tilt and Swivel (OHM102 only)

The monitor can be opened to a maximum of 110 degrees.

Exceeding this point can cause serious damage to the

monitor and monitor housing. Note: The OHM102 has the

capability of swiveling the monitor left and right. Prior to

closing the monitor, it is important that the monitor be

returned to the center position.

Setting the Screen Mode

The OHM102/OHM153 has 4 different screen modes: NORMAL, WIDE, ZOOM, and FULL.

Pressing the MODE button on the front control panel or the remote control can access the

different screen modes. The current mode is displayed on the screen first. Each time the MODE

button is pressed, the screen mode switches in the following sequence:

Note: The screen mode will set after 5 seconds, pending that the MODE button is not

pressed.

The display image may appear coarse or grainy when viewed in Zoom mode.

Changing the Display Settings (Picture In Picture/Split Screen)

The display setting can be adjusted by pressing the PIP (Picture In Picture) button on the control

panel or remote control. This button selects between PIP and split screen viewing mode. In PIP

mode, the second image can be displayed in any of the four corners and in four different viewing

aspects. In split screen mode, the display is evenly divided between two AV sources.

To access PIP or split screen display setting, press the PIP button until the desired mode is

displayed. The screen will change in the following sequence:

Selecting the AV Sources for Main and Sub Screen

MAIN SCREEN

Press the (DOWN Button) to select the desired AV source. The sources will be

changed in following sequence:

SUB SCREEN

Press the (UP button) to select the desired AV source. The sources will be

changed in following sequence:

NOTE: Same video input cannot be viewed simultaneously.

Dimmer Button:

Press the DIMMER button to adjust the brightness of the screen. The brightness will

change in the following sequence:

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Clarion Auto-Videosystem Handbücher

Clarion

Clarion OHM156 Bedienungsanleitung

Clarion

Clarion VS755 Bedienungsanleitung

Clarion

Clarion VRX878RVD Bedienungsanleitung

Clarion

Clarion NX403EV Bedienungsanleitung

Clarion

Clarion NX505E Bedienungsanleitung

Clarion

Clarion VX316AU Bedienungsanleitung

Clarion

Clarion BKX1328-06 Bedienungsanleitung

Clarion

Clarion OHM653 Bedienungsanleitung

Clarion

Clarion NX409 Reparaturanleitung

Clarion

Clarion BKX-1276-07 Bedienungsanleitung

Clarion

Clarion CJ-981E Reparaturanleitung

Clarion

Clarion NX706E Bedienungsanleitung

Clarion

Clarion VRX610 Reparaturanleitung

Clarion

Clarion VRX775VD Reparaturanleitung

Clarion

Clarion VMA6491 Fehlerbehebungshandbuch

Clarion

Clarion VRX575USB Bedienungsanleitung

Clarion

Clarion OHM107VD Bedienungsanleitung

Clarion

Clarion NX509E Originalbetriebsanleitung

Clarion

Clarion VRX6671Z Reparaturanleitung

Clarion

Clarion VRX868RVD Reparaturanleitung

Clarion

Clarion VX401 Reparaturanleitung

Clarion

Clarion VX409 Reparaturanleitung

Clarion

Clarion VRX848RVD Bedienungsanleitung

Clarion

Clarion NX602 Bedienungsanleitung

Beliebte Auto-Videosystem Handbücher anderer Marken

Stinger

Stinger HEIGH10 RB10RAM13B Bedienungsanleitung

Eonon

Eonon E1057 Bedienungsanleitung

Milion

Milion D2223 Bedienungsanleitung

Metra Electronics

Metra Electronics 99-8153 Bedienungsanleitung

Voxx Electronics

Voxx Electronics HR8MA1 Bedienungsanleitung

Axxera

Axxera AV604Bi Bedienungsanleitung

Pyle view

Pyle view PLDN74BTi Bedienungsanleitung

RCA

RCA DRC6296 - Twin 9" Mobile DVD System Benutzerhandbuch

Kia

Kia MTXM100YPPE Bedienungsanleitung

Lanzar

Lanzar SVDVD5 Bedienungsanleitung

Eonon

Eonon E1060 Bedienungsanleitung

Macrom

Macrom M-AN900 Bedienungsanleitung

Hyundai

Hyundai BAPE-L3000N Bedienungsanleitung

r.LiNK

r.LiNK RL2-UCON8-SM Bedienungsanleitung

Blaupunkt

Blaupunkt DVP 01C Bedienungsanleitung

DP Audio Video

DP Audio Video dbd807nav Bedienungsanleitung

auna

auna MVD-400 CP Bedienungsanleitung

Alpine

Alpine IVX-W200E Bedienungsanleitung