Clarity XLC7HS Bedienungsanleitung
E
S
P
A
~
N
O
L
F
R
A
N
Ç
A
I
S
E
N
G
L
I
S
H
User Guide
ADDITIONAL HANDSET FOR
CLARITY XLC3.4+
CLARITY XLC7BT
50 DB OF AMPLIFICATION AND
FOUR (4) TONE SETTINGS
3
E
N
G
L
I
S
H
XLC7HS
Important Safety Instructions ............................4
Contents & Parts Checklist .........................................7
Operating Instructions................................................. 8
Troubleshooting.............................................................11
Technical Specifications.............................................. 13
Regulatory Compliance..............................................14
Warranty Information ................................................16
Française: Table des matièrese........................19
Español: Tabla de contenidos...........................35
INTRODUCTION
Thank you for purchasing the XLC7HS amplified cordless
handset from Clarity. The XLC7HS is an additional handset that
is compatible with select Clarity products. In order to use the
XLC7HS handset, you must also purchase and pair this handset
with a compatible Clarity telephone: XLC3.4+ or XLC7BT.
This User Guide will provide you with the information you need
to use your XLC7HS eectively, easily and safely. Please refer to
the main unit’s User Guide for further information on the XLC7HS
handset.
TABLE OF CONTENTS
4
XLC7HS
When using your telephone equipment, basic safety precautions should
always be followed to reduce the risk of fire, electric shock and injury to
persons, including the following:
1. Read and understand all instructions.
2. Follow all warnings and instructions marked on the telephone.
3. Avoid contact with liquids. Do not locate base unit or handset near
water, for example, near a bathtub, wash basin, sink or laundry tub, in
a wet basement or near a swimming pool.
4. Avoid using a telephone (other than a cordless type) during a storm.
There may be a remote risk of electrical shock from lightning.
5. Do not use the telephone to report a gas leak in the vicinity of the
leak.
6. Unplug this telephone from the wall outlets before cleaning. Do not
use liquid cleaners or aerosol cleaners on the telephone. Use a damp
cloth for cleaning.
7. Place this telephone on a stable surface. Serious damage and/or
injury may result if the telephone falls.
8. Do not cover the slots and openings on this telephone. This
telephone should never be placed near or over a radiator or heat
register. This telephone should not be placed in a built-in installation
unless proper ventilation is provided.
9. Operate this telephone using the electrical voltage as stated on the
base unit or in the owner’s manual. If you are not sure of the voltage
in your home, consult your dealer or local power company.
10. Do not allow anything to rest on the power cord or locate this
product in an area where the power cord is likely to be damaged by
furniture or foot trac.
11. Do not overload wall outlets or extension cords as this can increase
the risk of fire or electrical shock.
12. Never push any objects through the slots in the telephone. They can
touch dangerous voltage points or short out parts that could result
in a risk of fire or electrical shock. Never spill liquid of any kind on the
telephone.
13. To reduce the risk of electrical shock, do not take this phone apart.
Opening or removing covers may expose you to dangerous voltages
SAVE THESE INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
5
E
N
G
L
I
S
H
XLC7HS
or other risks. Incorrect reassembly can cause electric shock when
the appliance is subsequently used.
14. Unplug this product from the wall outlet and refer servicing to the
manufacturer under the followingconditions: when the power
supply cord or plug is frayed or damaged; if liquid has been spilled
into the product; if thetelephone has been exposed to rain or water;
if the telephone has been dropped or the case has been damaged;
if the telephone exhibits a distinct change in performance; if the
telephone does not operate normally by following the operating
instructions. Adjust only those controls that are covered by the
operating instructions. Improper adjustment may require extensive
work by a qualified technician to restore the telephone to normal
operation if the telephone does not operate normally by following
the operating instructions.
15. This product should be operated only from the type of power source
indicated on the marking label. If you are not sure of the type of
power supply to your home, consult your local power company.
16. Do not attempt to open the AC adapter. There are potentially
dangerous voltages inside, and there are no serviceable parts.
17. Discontinue use of product and contact Clarity if the product
overheats, has a damaged cord or plug, if the product has been
dropped or damaged or if the product has come into contact with
liquids.
18. Use only the AC adapter provided with this product or a replacement
AC adapter provided by Clarity.
19. This phone amplifies sound to loud volumes. To prevent hearing
damage, all users of the phone should be informed of the high vol-
ume capability of the phone and children should only use the phone
when supervised by an adult.
20.Exposure to high volume sound levels or excessive sound pressure
may cause temporary or permanent damage to your hearing.
Although there is no single volume setting that is appropriate for
everyone, you should always use your telephone with the volume
set at moderate levels and avoid prolonged exposure to high volume
sound levels. The louder the volume, the less time is required before
your hearing could be aected. If you experience hearing discomfort,
you should have your hearing checked by a doctor. To protect your
IMPORTANT SAFETY IN-
STRUCTIONS
SAVE THESE INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
6
XLC7HS
SAVE THESE INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
hearing, you should:
A) Set the volume control in a low position and gradually increase the
volume as needed. Before pressing the BOOST button, reduce the
volume to the lowest level. Use the phone on the lowest volume
setting as possible.
B) Limit the amount of time you use the telephone at high volume
levels.
21. If you experience a skin irritation after using this product,
discontinue use and contact Clarity.
SAFETY INSTRUCTIONS FOR BATTERIES
Dispose of used batteries according to the instructions.
Caution: Disconnect telephone line before replacing batteries.
1. Do not dispose of the battery in a fire as it may explode. Check with
local codes for possible special disposal instructions.
2. Do not open or mutilate the battery. Released electrolyte is corrosive
and may cause damage to the eyes and skin. It may be toxic if
swallowed.
3. Exercise care in handling batteries in order not to short the battery
with conducting materials such as rings, bracelets and keys. The
battery or conduction material may over heat and cause burns.
4. Remove batteries when they are discharged and when the equip-
ment will not be used for an extended period of time. Dispose of
batteries according to local environmental laws.
5. Do not disassemble, heat, crush, deform or puncture batteries.
6. Do not attempt to charge non-rechargeable batteries.
7. Keep batteries out of the reach of children.
WARNING: Risk of explosion if battery is replaced by an incorrect type.
NOTE: To replace handset batteries, use ONLY standard rechargeable
AAA NiMH batteries - 600mAh.
7
E
N
G
L
I
S
H
XLC7HS
1. Charger Base
4. User Guide
1. Charger Base
2. Handset
3. AC adapter
4. User Guide
2. Handset
XLC7HS
User Guide
MENU
TALK FLASH EXIT
MUTE
BACK
RD/P
1
BOOST MEM
3. AC Adapter
CONTENTS & PARTS CHECKLIST
8
XLC7HS
1. Remove base from package.
2. Hold one end of your phone’s
white power adapter cord
tightly. The correct end to hold
should already be plugged into
the back of your telephone base
unit. Simultaneously pull the
other end of the adapter cord
away from the phone, unraveling
it and allowing you to plug
that end of the cord into a wall
electrical outlet.
3. Plug white power adapter cord
on left rear of the charger base
into a wall electrical outlet.
4. Remove handset from package.
5. Pull the handset’s battery tab
located on the bottom of the
device in the direction of the
arrow.
6. Place the handset in the base
charger. The batteries in the
handset must be fully charged
for 16 hours before using the
telephone for the first time.
7. Follow instructions to register
the handset to your main unit,
page 9.
Additional operating instructions can be
found in the User Guide for your main unit.
OPERATING INSTRUCTIONS
9
E
N
G
L
I
S
H
XLC7HS
REGISTERING THE XLC7HS
The XLC7HS is compatible with select Clarity products (see page 13 for
compatible products). In order to use the XLC7HS you must register it to a
main unit.
Pull the handset’s battery tab located on the bottom of the device, and then
press MENU to start registering or deregistering your handset from your
system.
TO REGISTER AN UNREGISTERED HANDSET
1. Press MENU to enter registration mode. You will see displayed on the
screen, “Handset Needs Registration.”
2. Press and hold the FIND key on the main unit’s base for five seconds,
until the base visual ringer starts flashing. Release FIND key on the main
unit’s base.
3. Press MENU key on the handset.
4. The screen shows “Registering... ”, then “Registration Successful”
(accompanied by five quick beeps).
5. Your handset is now registered to your main system. Your screen will
display “Handset X,” (where “X” is the number of the actual handset
registered, such as the second or fourth handset, etc.).
You can extend the number of handsets by using additional XLC7HS
handsets (sold separately) - up to 4 handsets (total) can be registered to a
main system.
TO REGISTER YOUR HANDSET AGAIN (or to register to a dierent main
system)
1. In standby mode, press MENU.
2. Press DOWN arrow five times to advance the row reading “Phone Setup”
to the top of the screen.
3. Press MENU to enter the setup section. The screen displays “Register” on
the screen’s top row now.
4. Press MENU to enter the Registration section.
5. Press MENU again to select “Register.”
6. Follow the Registration steps listed above.
TO DEREGISTER THE HANDSET
1. See the six steps listed above, then press MENU to select Deregister.”
2. Your handset will deregister from your base as soon as you press
MENU. The screen will show “Handset X Deregistered”(again, where
“X” is the number of the handset registered), then “Handset Needs
Registration.”
OPERATING INSTRUCTIONS
10
XLC7HS
1
2
3
4
1 VOLUME Control
The dial controls the volume
level of the handset, headset or
neckloop.
2 BOOST
When pressed, an extra level of
amplification is added over the
entire range of volume control.
3 Speaker
Press to activate handset
speakerphone. Press again to
switch back to earpiece.
4 TALK
Press TALK button and dial
number to make a call. To end
call press TALK again.
5 TONE
The XLC7HS has four (4) AUDIO
TONE settings. Pressing the
TONE button changes the style
of amplification and allows
you to customize your hearing
experience.Hearing loss is
specific to each individual;
therefore, wesuggest exploring
each setting to find the one you
find most comfortable.
(See main User Guide for
a complete description of
available audio profiles.)
6 RINGER ON / OFF
Switch to turn Handset Ringer
On or O.
7 MEM Button: press this button
for one-touch dial from standby
mode.
6
5
MENU
TALK FLASH EXIT
MUTE
BACK
RD/P
1
BOOST MEM
OPERATING INSTRUCTIONS
7
Inhaltsverzeichnis
Sprachen:
Andere Clarity Mobilteil Handbücher
Clarity
Clarity D613HS Bedienungsanleitung
Clarity
Clarity XLCgo Bedienungsanleitung
Clarity
Clarity XLC 3.1 Bedienungsanleitung
Clarity
Clarity D613HS D613HS Bedienungsanleitung
Clarity
Clarity XLC 3.5HS Bedienungsanleitung
Clarity
Clarity XLC 3.1 Bedienungsanleitung
Clarity
Clarity D702 Bedienungsanleitung
Clarity
Clarity WALKER WS-2749 Bedienungsanleitung
Clarity
Clarity D703HS Bedienungsanleitung
Clarity
Clarity XLC8HS Bedienungsanleitung
