Clearwater Clearspa Instructions 09/06
13. Operating the touch pad. – The touch pad has three operating buttons.
Button A – Starts and stops the motor. As seen in the picture above, an LED indicates
when the blower is on or off, this light also indicates whether the hygiene system is
on.
Button B – This is the variable speed button, press and hold to decrease and increase
the speed of the blower, release the button at your required pressure.
Button C – This is the massage button, once pressed the speed varies from the high
speed to slow speed continuously over a period of time. If the button is pressed again
the speed of the motor will carry on at that speed.
Check all sealed areas for any leaks
Section 4
System operation
The blower will last approximately 30 minutes; after the 30 minutes have elapsed the
blower will turn itself off. This is a safety feature ensuring the blower does not over
heat. If the blower does not have sufficient room to breath the running time of the
blower will be less.
Hygiene system
Once the bath has been emptied and the Clearspa system has been turned off, the LED
on the stop start button (A) will flash to indicate the hygiene system is active. The
hygiene system is programmed into the blower. The blower will start up again in
approximately 15 minutes after it has been turned off at the touch pad. The objective
of the hygiene system is to purge the remaining water out of the system and into the
base of the bath where it can drain away. The hygiene system should last for
approximately five minutes. After the five minutes have elapsed the motor will turn
itself off. We suggest that you run the system even if the Clearspa has not been used,
this can be done by turning the system on and off again engaging the Hygiene system.
Button B
Button A
Button C
