Clearer Audio Silver-line Bedienungsanleitung
Silver-line Power-HUB
Installation and Care Instructions
Thank you for purchasing the Silver-line Power-HUB. We hope that you enjoy the
HUB.
IMPORTANT SAFETY INFORMATION
CAUTION: To reduce the risk of electrical shock do not attempt to
open the Silver-line Power-HUB. There are no user-serviceable parts
inside and the unit can only be serviced by Clearer Audio. If a
problem occurs with your Silver-line Power-HUB then please contact
us.
Safety guidelines:
1.) Do not expose the HUB to rain or moisture.
2.) Do not attempt to modify the power cable.
3.) Unplug the HUB during electrical storms.
4.) Only use with a 250V 50/60Hz power supply.
5.) If cleaning is required, unplug the HUB and use a soft lint free cloth. Do
not use cleaning products.
Installation and Care guidelines:
The HUB does not require any maintenance but in order to get the best out of
the HUB and ultimately your system please read the following guidelines.
1.) The HUB is fully star-wired so each component is provided with power
from a central distribution block. The star-wiring also minimises
interactions between components. You may however notice a slight
improvement in performance by plugging components that draw the
most current in sequentially from left to right (i.e., the component that
draws the most current is plugged into socket 1 – nearest the inlet – and
the component that draws the least current is plugged into the last
socket).
2.) The LED indicator on the front of the HUB shows that the Gatekeeper
Surge Protection is working and protecting connected components.
Should this light go out then please contact us.
3.) If the plug fuse should blow then please contact us so we can send you a
free replacement fuse. We use carefully selected silver-plated copper
fuses. Using a different type of fuse may affect performance of the HUB.
4.) We recommend cleaning the mains plug pins every 6 months with CAIG
DeoxIT. If you opt for the Furutech FI-UK Mains Plug then CAIG Gold
should be used.
5.) The socket contacts are treated with CAIG DeoxIT. We recommend you
re-treat the contacts every 6 months. Disconnect the HUB from the
mains and carefully treat each contact with a very small amount of CAIG
DeoxIT DN5. The DN5 version should ideally be used since this is no-
flammable and the carrier solution evaporates rapidly. Leave the HUB
30-60 minutes after treatment before using again.
6.) The HUB has an earthing post on the side near the inlet. Our shielded
speaker cables should be connected to this post to drain any noise pick-
up away from the speaker cable thus ensuring that the signal lines are
not contaminated (through capacitive coupling). The post can also be
used as a reference for other earthing requirements.
If you have any questions or queries then please do not hesitate to contact us on
01702 543981.
Inhaltsverzeichnis
Andere Clearer Audio Schalten Handbücher
